Silicon, although widely used in modern electronic devices, has not yet been implemented in thermoelectric applications mainly due to its high thermal conductivity, κ, which leads to an extremely low thermoelectric energy conversion efficiency (figure of merit). Here, we present an approach to manage κ of Si thin-film-based nanoarchitectures through the formation of radial and planar Si/SiO hybrid nanomembrane superlattices (HNMSLs). For the radial Si/SiO HNMSLs with various numbers of windings (1, 2, and 5 windings), we observe a continuous reduction in κ with increasing number of windings. Meanwhile, the planar Si/SiO HNMSL, which is fabricated by mechanically compressing a five-windings rolled-up microtube, shows the smallest in-plane thermal conductivity among all the reported values for Si-based superlattices. A theoretical model proposed within the framework of the Born-von Karman lattice dynamics to quantitatively interpret the experimental data indicates that the thermal conductivity of Si/SiO HNMSLs is to a great extent determined by the phonon processes in the SiO layers.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsnano.7b03219DOI Listing

Publication Analysis

Top Keywords

thermal conductivity
16
planar si/sio
12
in-plane thermal
8
radial planar
8
si/sio hybrid
8
hybrid nanomembrane
8
nanomembrane superlattices
8
si/sio hnmsls
8
si/sio
5
conductivity
4

Similar Publications

High photothermal conversion efficiency of RF sputtered TiO Magneli phase thin films and its linear correlation with light absorption capacity.

Sci Rep

December 2024

Centre Énergie, Matériaux Télécommunications, Institut National de la Recherche Scientifique, 1650, Blvd, Lionel-Boulet, Varennes, QC, J3X-1P7, Canada.

RF-sputtering is used to deposit TiO-Magneli-phase films onto various substrates at deposition temperatures (T) ranging from 25 to 650 °C. Not only the structural, but also electrical conductivity, optical absorbance and photothermal properties of the TiO films are shown to change significantly with T. A T of 500 °C is pointed out as the optimal temperature that yields highly-crystalized pure-TiO-Magneli phase with a densely-packed morphology and a conductivity as high as 740 S/cm.

View Article and Find Full Text PDF

This study explores the thermal conductivity and viscosity of water-based nanofluids containing silicon dioxide, graphene oxide, titanium dioxide, and their hybrids across various concentrations (0 to 1 vol%) and temperatures (30 to 60 °C). The nanofluids, characterized using multiple methods, exhibited increased viscosity and thermal conductivity compared to water, with hybrid nanofluids showing superior performance. Graphene oxide nanofluids displayed the highest thermal conductivity and viscosity ratios, with increases of 52% and 177% at 60 °C and 30 °C, respectively, for a concentration of 1 vol% compared to base fluid.

View Article and Find Full Text PDF

Due to their outstanding electrical and thermal properties, graphene and related materials have been proposed as ideal candidates for the development of lightweight systems for thermoelectric applications. Recently, the nanolaminate architecture that entails alternation of continuous graphene monolayers and ultrathin polymer films has been proposed as an efficient route for the development of composites with impressive physicochemical properties. In this work, we present a novel layer-by-layer approach for the fabrication of highly ordered, flexible, heat-resistant, and electrically conductive freestanding graphene/polymer nanolaminates through alternating Marangoni-driven self-assembly of reduced graphene oxide (rGO) and poly(ether imide) (PEI) films.

View Article and Find Full Text PDF

Anion Exchange Membranes (AEMs) are promising materials for electrochemical devices, such as fuel cells and electrolyzers. However, the main drawback of AEMs is their low durability in alkaline operating conditions. A possible solution is the use of composite ionomers containing inorganic fillers stable in a basic environment.

View Article and Find Full Text PDF

The urgent need for sustainable, low-emission energy solutions has positioned proton exchange membrane fuel cells (PEMFCs) as a promising technology in clean energy conversion. Polysulfone (PSF) membranes with incorporated ionic liquid (IL) and hydrophobic polydimethylsiloxane-functionalized silica (SiO-PDMS) were developed and characterized for their potential application in PEMFCs. Using a phase inversion method, membranes with various combinations of PSFs, SiO-PDMS, and 1-butyl-3-methylimidazolium triflate (BMI.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!