Introduction: The purpose of this study was to determine the prevalence of the second mesiobuccal canal (MB2) in 100 maxillary first molars using 3 independent methods and a combination method.
Methods: One hundred extracted human maxillary first molars were collected. The teeth were mounted in the maxillary first molar extraction sockets of a human cadaver head. A cone-beam computed tomographic (CBCT) scan was taken of each tooth. Two radiology faculty independently evaluated the CBCT volume for the presence of an MB2 canal. Additionally, teeth were accessed. If a canal was not found, a preoperative CBCT scan was viewed followed by a second attempt to locate an MB2 canal. Lastly, the mesiobuccal root was dissected by grinding in a coronal plane.
Results: A review of CBCT volumes found the presence of an MB2 canal 69% of the time. Accessing the tooth led to an MB2 detection of 78%. When a CBCT scan was viewed, this brought the access detection rate up to 87%. Coronal plane root grinding had an MB2 canal detection rate of 92%. Differences between each method were statistically significant.
Conclusions: The results of this study show that an MB2 canal is present up to 92% of the time. Direct access of teeth found statistically significant more MB2 canals than viewing CBCT volumes alone (P = .032). Therefore, exposing every patient to a preoperative CBCT scan may not be appropriate. However, taking a CBCT scan when an MB2 canal is not found clinically can significantly increase the chances of finding an MB2 canal (P < .001).
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.joen.2017.05.011 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Unlabelled: The first maxillary molar is one of the most difficult teeth for endodontical treatment; it presents the highest failure rates due to the impossibility of locating and treating the second mesiobuccal canal (MB2). The aim of our work was study of second mesiobuccal canal in maxillary first molar and compare obtained data with literature sources for increasing the efficiency of treatment.
Materials And Methods: The study involved 59 patients with exacerbation of chronic pulpitis or chronic periodontitis who were distributed according to age: 14-20 years, 21-30 years and 31-40 years.
Micro-computed tomographic evaluation of dentinal microcracks in response to progressive taper enlargement in root canals of maxillary molars.
Int Endod J
February 2025
Department of Endodontics, School of Dentistry, State University of Rio de Janeiro (UERJ), Rio de Janeiro, Rio de Janeiro, Brazil.
Aim: To investigate the development of dentinal microcracks resulting from the progressive enlargement of the buccal canals of maxillary molars with and without the MB2 canal employing instruments with the same tip and four different tapers.
Methodology: Twenty maxillary molars with (n = 10) and without (n = 10) the MB2 canal underwent micro-CT scanning. Their mesiobuccal and distobuccal canals were sequentially enlarged using nickel-titanium instruments with sizes 25/.
The prevalence, configuration, and prediction of second mesiobuccal canals in maxillary second molars in West Bengal population - A cone-beam computed tomography study.
J Conserv Dent Endod
October 2024
Department of Conservative Dentistry and Endodontics, Dr. R. Ahmed Dental College and Hospital, Kolkata, West Bengal, India.
Objective: This study's objective is to analyze the prevalence as well as the configuration of second mesiobuccal (MB2) in maxillary 2 molars and predict its existence based on mesiobuccal-palatal (MB-P) distance, MB-P/distobuccal-palatal (DB-P) distance ratio and mesiobuccal, distobuccal, and palatal orifice (MDP) angle with the help of cone-beam computed tomography.
Materials And Methods: The presence and absence of MB2 are noted down in 300 maxillary 2 molars. Canal configuration was observed from the orifice to the apex in the mesiobuccal root.
The impact of cone beam CT on outcomes associated with endodontic access cavity preparation: a controlled human analogue study using 3D-printed first maxillary molars.
Dentomaxillofac Radiol
January 2025
Division of Oral and Maxillofacial Surgery, Medicine, Pathology and Radiology, Dublin Dental University Hospital, Trinity College Dublin, Dublin, Lincoln Place, Dublin, D02 F859, Ireland.
Objectives: To identify if supplemental preoperative cone beam CT (CBCT) imaging could improve outcomes related to endodontic access cavity preparation, using 3D-printed maxillary first molars (M1Ms) in a rigorously simulated, controlled human analogue study.
Methods: Eighteen operators with 3 experience-levels took part in 2 simulated clinical sessions, 1 with and 1 without the availability of CBCT imaging, in a randomized order and with an intervening 8-week washout period. Operators attempted the location of all 4 root canals in each of 3 custom-made M1Ms (2 non-complex and 1 complex mesiobuccal [MB] canal anatomy).
Cone beam computed tomography analysis of the root and canal morphology of the maxillary second molars in a Syrian subpopulation.
BMC Oral Health
September 2024
Department of Pediatric Dentistry, Faculty of Dentistry, Damascus University, Damascus, Syria.
Aim: To investigate the root number and morphology of the maxillary second molars in the Syrian population besides bilateral symmetry, and the effect of gender.
Methods: 250 Cone Beam Computed Tomography (CBCT) images (140 females, 110 males) were examined by two endodontists. The detailed analysis included the number of roots, the number of canals and their configurations, bilateral symmetry, and relation to gender.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!