Structural superlubricity describes the state of virtually frictionless sliding if two atomically flat interfaces are incommensurate, that is, they share no common periodicity. Despite the exciting prospects of this low friction phenomenon, there are physical limitations to the existence of this state. Theory predicts that the contact size is one fundamental limit, where the critical size threshold mainly depends on the interplay between lateral contact compliance and interface interaction energies. Here we provide experimental evidence for this size threshold by measuring the sliding friction force of differently sized antimony particles on MoS. We find that superlubric sliding with the characteristic linear decrease of shear stress with contact size prevails for small particles with contact areas below 15 000 nm. Larger particles, however, show a transition toward constant shear stress behavior. In contrast, Sb particles on graphite show superlubricity over the whole size range. Ab initio simulations reveal that the chemical interaction energies for Sb/MoS are much stronger than for Sb/HOPG and can therefore explain the different friction properties as well as the critical size thresholds. These limitations must be considered when designing low friction contacts based on structural superlubricity concepts.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1021/acsnano.7b02240 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Electrostatic in-plane structural superlubric actuator.
Nat Commun
January 2025
Tsinghua Shenzhen International Graduate School, Tsinghua University, Shenzhen, China.
Micro actuators are widely used in NEMS/MEMS for control and sensing. However, most are designed with suspended beams anchored at fixed points, causing two main issues: restricted actuated stroke and movement modes, and reduced lifespan due to fatigue from repeated beam deformation, contact wear and stiction. Here, we develop an electrostatic in-plane actuator leveraging structural superlubric sliding interfaces, characterized by zero wear, ultralow friction, and no fixed anchor.
View Article and Find Full Text PDFThe effects of disordered edge and vanishing friction in microscale structural superlubric graphite contact.
Nat Commun
December 2024
Department of Mechanical Engineering, Tsinghua University, Beijing, China.
Article Synopsis
- Structural superlubricity (SSL) is a state of extremely low friction and wear between solid surfaces, providing a potential solution for reducing these factors in practical applications.
- Recent research identifies that edge pinning significantly influences SSL friction, although understanding of its atomic-level nature was previously unclear.
- The study reveals the atomic structure of disordered edges in microscale graphite and demonstrates that by using SiN caps to disconnect edges from the substrate, an ultra-low friction stress of 0.1 kPa or lower can be achieved.
Mechanical and electromechanical properties of 2D materials studied microscopy techniques.
Nanoscale
December 2024
Key Laboratory for the Physics and Chemistry of Nanodevices, School of Electronics, Peking University, Beijing 100871, China.
Two-dimensional (2D) materials with van der Waals stacking have been reported to have extraordinary mechanical and electromechanical properties, which give them revolutionary potential in various fields. However, due to the atomic-scale thickness of these 2D materials, their fascinating properties cannot be effectively characterized in many cases using conventional measurement techniques. Based on typical microscopy techniques such as scanning electron microscopy (SEM), transmission electron microscopy (TEM), and atomic force microscopy (AFM), a range of microscopy techniques have been developed to systematically quantify the mechanical and electromechanical properties of 2D materials.
View Article and Find Full Text PDFMolecular Mechanisms of Solvation Force for Aqueous Systems.
Nano Lett
December 2024
Department of Mechanical Engineering, State Key Laboratory of Tribology in Advanced Equipment (SKLT), Tsinghua University, Beijing 100084, China.
Article Synopsis
- Solvation force, crucial for interactions in fields like batteries and lubrication, is difficult to quantify in aqueous systems, with traditional theories falling short due to oversimplifications.
- The researchers developed a new formula for solvation force that considers the liquid flow as surfaces come close together, linking it to the energy needed to push liquid molecules out of narrow spaces.
- Experiments using 3D atomic force microscopy confirmed this model across different surface types, showing that factors like temperature and surface wetting significantly influence solvation force more than liquid density does.
Evolution of Interfacial Hydration Structure Induced by Ion Condensation and Correlation Effects.
Angew Chem Int Ed Engl
December 2024
Department of Mechanical Engineering, State Key Laboratory of Tribology in Advanced Equipment (SKLT), Tsinghua University, Beijing, 100084, China.
Article Synopsis
- Interfacial hydration structures are key in various fields like batteries, colloids, and lubrication, with multivalent ions such as Mg2+ and La3+ playing a significant role, although experimental support for this was lacking.
- Using atomic force microscopy, the study successfully observed the hydration structures at the interface of La(NO3)3 solution and mica, noting changes in layer number and thickness depending on ion concentration.
- The findings indicate that both multivalent and monovalent ions experience concentration-dependent behaviors that influence their hydration structures, offering valuable insights for improving battery performance, colloid stability, and lubrication efficiency.
Want AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!