NMR measurements show that diethyl carbonate (DEC, a solvent with a low dielectric constant) solutions of LiClO contain (LiClO) oligomers. The reduction of these species by solvated and presolvated electrons is followed by picosecond pulse radiolysis measurements. The data analysis shows that several anions absorbing in the near-infrared (NIR) and visible range are formed after the 7 ps electron pulse. In contrast with tetrahydrofuran (THF) solutions of LiClO, the anionic monomer (LiClO) is not observed in DEC solutions. This is due to the fact that DEC is a nonpolar solvent favoring the clustering of monomers in the nonirradiated solution, as shown by NMR results, and also due to the instability of the anionic monomer. The absorption spectra of the anionic dimer (LiClO), trimer (LiClO), and tetramer (LiClO) are clearly observed in NIR and visible ranges. Compared to the results obtained for the same system in THF and in agreement with simulated absorption spectra, the experimental results show that the absorption bands are shifted to the blue end of the spectrum when n increases. The kinetics recorded for the molar LiClO solution indicates that the solute is only in the form of oligomers (LiClO) with a large n value and that the reduced species absorb weakly in the visible region. Lastly, and contrary to what is known for well-separated ions in polar solvents, it is shown that the (LiClO) anions are not stable with respect to self-reduction, leading to the decomposition of perchlorate anions. In this reaction, the perchlorate anion ClO is reduced by the Li atom into a chlorate anion ClO. This is proved by the presence of ClO and chlorinated species detected by mass spectrometry measurements in irradiated DEC solutions containing LiClO.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acs.jpcb.7b04982DOI Listing

Publication Analysis

Top Keywords

liclo
13
solutions liclo
12
oligomers liclo
8
diethyl carbonate
8
nir visible
8
anionic monomer
8
dec solutions
8
absorption spectra
8
anion clo
8
solutions
5

Similar Publications

Solid-state polymer electrolytes (SPEs) are increasingly favored over liquid electrolytes for emerging energy storage devices due to their safety features, enhanced stability, and multifunctionality. Minor solvents (such as water) are often introduced unintentionally or intentionally into SPEs. Although it can significantly affect SPEs' electrochemical and mechanical properties, the fundamental role of such solvent content has rarely been studied.

View Article and Find Full Text PDF

Solution Casting Effect of PMMA-Based Polymer Electrolyte on the Performances of Solid-State Electrochromic Devices.

Polymers (Basel)

January 2025

Centre for Advanced Devices and Systems, Faculty of Engineering, Multimedia University, Persiaran Multimedia, Cyberjaya 63100, Selangor, Malaysia.

Electrochromic devices (ECDs) are devices that change their optical properties in response to a low applied voltage. These devices typically consist of an electrochromic layer, a transparent conducting substrate, and an electrolyte. The advancement in solid-state ECDs has been driven by the need for improved durability, optical performance, and energy efficiency.

View Article and Find Full Text PDF

Pyrene (Pr) was used to improve the electrochemical and electrochromic properties of polythiophene copolymerized with 3,4-ethylenedioxythiophene (EDOT). The corresponding product, poly(3,4-ethylenedioxythiophene-co-Pyrene) (P(EDOT-co-Pr)), was successfully synthesized by electrochemical polymerization with different monomer concentrations in propylene carbonate solution containing 0.1 M lithium perchlorate (LiClO/PC (0.

View Article and Find Full Text PDF

Cyclic Voltarefractometry of Single TiO Nanoparticles in Large Ensembles in Nonaqueous Electrolyte.

Anal Chem

January 2025

Nanobiotechnology Department of the Institute of Biotechnology, Brandenburg University of Technology Cottbus-Senftenberg, Universitaetsplatz 1, Senftenberg 01968, Brandenburg, Germany.

Single nanoparticle (NP) cyclic voltarefractometry (CVR), realized as wide-field surface plasmon resonance microscopy (SPRM) in combination with potential cycling, has been proposed and applied to the in situ study of TiO NPs. Electrochemical activity of TiO is mainly observed outside the electrochemical stability window of water. Therefore, the response of individual anatase (a-TiO) and rutile (r-TiO) NPs adsorbed on a gold layer was studied in 0.

View Article and Find Full Text PDF

Lithium-ion batteries have garnered significant attention owing to their exceptional energy density, extended lifespan, rapid charging capabilities, eco-friendly characteristics, and extensive application potential. These remarkable features establish them as a critical focus for advancing next-generation battery technologies. However, the commonly used organic liquid electrolytes in batteries are explosive, volatile, and possess specific toxic properties, resulting in persistent safety concerns that remain to be addressed.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!