Statement Of Problem: Candida-associated denture stomatitis is the most common oral mucosal lesion among denture wearers. Trimethylsilane (TMS) plasma coating may inhibit the growth of Candida albicans on denture surfaces.
Purpose: The purpose of this in vitro study was to investigate whether TMS plasma coatings can effectively reduce C albicans adhesion on denture base acrylic resin surfaces.
Material And Methods: Sixty denture base acrylic resin disks with smooth and rough surfaces were prepared and were either left untreated (control group) or coated with TMS monomer (experimental group) by using plasma. Contact angles were measured immediately after TMS plasma coating. The morphology of C albicans adhesion was observed with scanning electron microscopy (SEM). Energy-dispersive spectroscopy (EDS) was used to characterize the elemental composition of the specimen surface. An adhesion test was performed by incubating the resin disk specimens in C albicans suspensions (1×10 cells/mL) at 37°C for 24 hours and further measuring the optical density of the C albicans by using a 3-(4,5-dimethylthiazol-2-yl)-2,5-diphenyltetrazolium bromide (MTT) assay test. One-way ANOVA and 2-way ANOVA were followed by a post hoc test analysis (α=.05).
Results: The group with TMS coating exhibited a more hydrophobic surface than the control group. EDS analysis revealed successful TMS plasma coating. The difference in the mean contact angles between the uncoated group and the TMS-coated group was statistically significant (P<.05), 79.0 ±2.9 degrees versus 105.7 ±1.5 degrees for the smooth surface and 90.2 ±7.6 degrees versus 131.5 ±2.1 degrees for the rough surface. In SEM analysis, the C albicans biofilm was found to grow more on the surface of the denture base resin without the TMS coating than on the surfaces of the experimental group. In the adhesion test, the amount of C albicans adhering to the surface of denture base resin with the TMS coating was significantly less than that on the surfaces without TMS coating (P<.05).
Conclusions: TMS coating significantly reduced the adhesion of C albicans to the denture base resin and may reduce denture stomatitis.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5650576 | PMC |
| http://dx.doi.org/10.1016/j.prosdent.2017.01.003 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Degradation Behavior of Coated Metallic Stents: Influence of In Vitro Fluid-Dynamic Biostability Testing Conditions.
Materials (Basel)
December 2024
Fraunhofer Institute for Ceramic Technologies and Systems IKTS, Maria-Reiche-Strasse 2, 01109 Dresden, Germany.
Coated metallic stents are the next generation of metallic stents with improved surface properties. To evaluate the degradation behavior of stents in vitro, different in vitro degradation models can be applied: (i) static immersion test: degradation under static fluid condition, (ii) fluid dynamic test: degradation under flowing fluid, and (iii) electrochemical corrosion test: degradation under the influence of electric potential. During these experimental procedures, stents interact with the simulated blood plasma, and degradation products are formed in the form of depositions on the stent surface, likewise in vivo experiments.
View Article and Find Full Text PDFSelf-Powered Triboelectricity-Driven Multiple-Input-Single-Output Occupancy Detection System Using a Triboelectric Nanogenerator for Energy Management.
Polymers (Basel)
December 2024
Department of Electronic Engineering, Institute for Wearable Convergence Electronics, Kyung Hee University, 1732 Deogyeong-daero, Giheung-gu, Yongin 17104, Republic of Korea.
An energy crisis, resulting from rapid population growth and advancements in the Internet of Things, has increased the importance of energy management strategies. Conventionally, energy management is conducted using sensors; however, additional energy is required to maintain sensor operation within these systems. Herein, an all-fiber-based triboelectric nanogenerator with O plasma treatment, graphene oxide/tannic acid solution coating, and hexane/1-octadecanethiol solution coating (AFT-OGH) is fabricated to implement a self-powered sensor, generating a high electrical power density, of 0.
View Article and Find Full Text PDFMagnetic molecularly imprinted polymers coupled with UPLC-MS/MS for simultaneous detection of 19 steroid hormones in human plasma.
J Chromatogr A
January 2025
State Key Laboratory of Chemical Resource Engineering, Beijing University of Chemical Technology, 15 3rd Ring North East Road, Chaoyang District, Beijing 100029, China. Electronic address:
Steroid hormones constitute a group of hormones with molecular weights ranging from 200 to 400 daltons, characterized by their highly similar chemical structures. Each hormone within this group holds significant value for the diagnosis of various diseases. Accurate clinical measurement of the levels of each hormone is crucial for the diagnosis in clinical settings.
View Article and Find Full Text PDFUltrasensitive detection of intact SARS-CoV-2 particles in complex biofluids using microfluidic affinity capture.
Sci Adv
January 2025
Krantz Family Center for Cancer Research, Massachusetts General Hospital, Boston, MA, USA.
Measuring virus in biofluids is complicated by confounding biomolecules coisolated with viral nucleic acids. To address this, we developed an affinity-based microfluidic device for specific capture of intact severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2). Our approach used an engineered angiotensin-converting enzyme 2 to capture intact virus from plasma and other complex biofluids.
View Article and Find Full Text PDFFormation of Wrinkled Nanostructures via Surface-Bulk Curing Disparity in Ethyl Cyanoacrylate: Toward Superhydrophobic Surface Applications.
Nanomaterials (Basel)
December 2024
School of Mechanical and Ocean Engineering, Mokpo National University, Muan-gun 58554, Jeollanam-do, Republic of Korea.
Superhydrophobic surfaces, known for their exceptional water-repellent properties with contact angles exceeding 150°, are highly regarded for their effectiveness in applications including self-cleaning, antifouling, and ice prevention. However, the structural fragility and weak durability of conventional coating limit their long-term use. In this research, a new approach is proposed for the fabrication of long-lasting superhydrophobic surfaces using ethyl cyanoacrylate (ECA) and a primer.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!