The management of an increasing amount of municipal waste via incineration has been gaining traction. Fly ash as a by-product of incineration of municipal solid waste is considered a hazardous waste due to the elevated content of various elements. The enrichment and distribution of 24 elements in fly ash from three wastes incinerators were evaluated. Two coarse (>100 μm and <100 μm) and five sub-sieve (12-16, 16-23, 23-34, 34-49, and 49-100 μm) particle size fractions separated on a cyclosizer system were analyzed. An enhancement in the enrichment factor was observed in all samples for the majority of elements in >100 μm range compared with <100 μm range. The enrichment factor of individual elements varied considerably within the samples as well as the sub-sieve particle size ranges. These variations were attributed primarily to: (i) the vaporization and condensation mechanisms, (ii) the different design of incineration plants, (iii) incineration properties, (iv) the type of material being incinerated, and (v) the affinity of elements.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jenvman.2017.03.073 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Determination of alkali metal elements in solid biomass fuel by laser-induced breakdown spectroscopy: Analysis and reduction of chemical matrix effects.
Anal Chim Acta
February 2025
School of Electric Power Engineering, South China University of Technology, Guangzhou, Guangdong, 510641, China; Guangdong Province Key Laboratory of Efficient and Clean Energy Utilization, Guangzhou, Guangdong, 510641, China. Electronic address:
Background: Rapid and accurate detection of the biomass potassium (K) content in biomass is crucial for mitigating ash deposition and fouling issues in biomass fuel combustion processes. Laser-induced breakdown spectroscopy (LIBS) offers a promising approach for rapid analysis of biomass elemental. However, the accuracy of LIBS detection is susceptible to chemical matrix effects.
View Article and Find Full Text PDFPrediction of Compressive Strength of Fly Ash-Recycled Mortar Based on Grey Wolf Optimizer-Backpropagation Neural Network.
Materials (Basel)
January 2025
School of Engineering, Computing and Mathematics, University of Plymouth, Plymouth PL4 8AA, UK.
The evaluation of the mechanical performance of fly ash-recycled mortar (FARM) is a necessary condition to ensure the efficient utilization of recycled fine aggregates. This article describes the design of nine mix proportions of FARMs with a low water/cement ratio and screens six mix proportions with reasonable flowability. The compressive strengths of FARMs were tested, and the influence of the water/cement ratio (/) and age on the compressive strength was analyzed.
View Article and Find Full Text PDFEffect of Strengthening Mechanism of Alkali Curing on Mechanical Properties of Fly Ash Lightweight Aggregates and Its Concrete.
Materials (Basel)
December 2024
Jiangsu Key Laboratory Environmental Impact and Structural Safety in Engineering, China University of Mining and Technology, Xuzhou 221116, China.
The low hydration degree of fly ash in Fly Ash Unburned Lightweight Aggregate (FULA) is not conducive to the development of the mechanical properties of lightweight aggregates and their concrete. In this paper, FULA was immersed in an alkaline solution with the purpose of improving the mechanical properties of FULA and its concrete. Firstly, FULA was prepared using fly ash as the main raw material.
View Article and Find Full Text PDFCoal Gasification Slag as a Green Additive in Supplementary Cementitious Materials: Mechanical Properties and Microstructure.
Materials (Basel)
December 2024
College of Water Conservancy and Civil Engineering, Inner Mongolia Agricultural University, Hohhot 010018, China.
Gasification slag is the solid waste produced in the process of coal gasification. China produces approximately 30 million tons of gasification slag every year, which urgently needs to be recycled in an efficient and sustainable way. This paper discusses the feasibility of using gasification slag as a supplementary cementitious material (SCM).
View Article and Find Full Text PDFMechanical Properties and Microstructure of Geopolymer-Based PFSS Synthesized from Excavated Loess.
Materials (Basel)
December 2024
CSCEC Strait Construction and Development Co., Ltd., Fuzhou 350015, China.
Pre-mixed fluidized solidified soil (PFSS) has the advantages of pumpability, convenient construction, and a short setting time. This paper took the excavated loess in Fuzhou as the research object and used cement-fly-ash-ground granulated blast furnace slag-carbide slag as a composite geopolymer system (CFGC) to synthesize PFSS. This study investigated the fluidity and mechanical strength of PFSS under different water-solid ratios and curing agent dosages; finally, the microstructure of the composite geopolymer system-pre-mixed fluidized solidified soil (CFGC-PFSS) was characterized.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!