Objective: Rotational forceps and manual rotation followed by direct forceps are techniques used in the management of malposition of the fetal head in the second stage of labor. However, there is widespread debate regarding their relative safety and utility. We aimed to compare the effectiveness and safety of rotational forceps with manual rotation followed by direct forceps, for management of fetal malposition at full dilation.
Study Design: A retrospective cohort study in a single tertiary obstetric unit with >6000 births per year. We recorded and analysed outcomes of 104 sequential rotational forceps births over 21 months (Jan 2010-Sept 2012) and 208 matched chronologically sequential attempted manual rotations and direct forceps births (1:2 by number). Univariable and multivariable approaches used for statistical analysis. The main outcome measure was vaginal birth.
Results: The rate of vaginal birth was significantly higher with rotational forceps than with manual rotation followed by direct forceps (88.5% vs 82.2%, RR 1.17, 95% CI 1.04-1.31, p=0.017). Births by rotational forceps were associated with a significantly higher rate of shoulder dystocia (19.2% vs 10.6%, RR 2.35, 95% CI 1.23-4.47, p=0.012), but not of neonatal injury. There were no significant differences in all other maternal and neonatal outcomes between the two modes of birth.
Conclusions: The use of rotational forceps was associated with a statistically significantly higher rate of vaginal birth, but also of shoulder dystocia, compared to manual rotation followed by direct forceps. This is the first study to demonstrate a statistically significant increase in the rate of shoulder dystocia following rotational forceps birth.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.ejogrb.2017.03.031 | DOI Listing |
Aust Vet J
December 2024
Advanced Vetcare, Kensington, Victoria, Australia.
Aim: To determine the optimal first proximal screw position which permits proximal tibial fragment rotation adjustment while minimising osteotomy gap formation when a manual reduction technique is used for TPLO in dogs.
Methods: TPLOs were performed on bone models using Synthes 3.5-mm TPLO implants with a jig but without the use of an anti-rotational pin.
Kyobu Geka
September 2024
General Thoracic Surgery, Kagoshima University, Kagoshima, Japan.
We introduce a novel approach for reduced-port robotic-assisted thoracoscopic surgery for thoracic neoplasms. Surgery is performed via single- or two-incision. Main incision( 4 cm) is placed on 8th intercostal space on mid-axillary line and second incision, if needed, is placed on 5th intercostal space on anterior axillary line.
View Article and Find Full Text PDFOper Orthop Traumatol
November 2024
Fachzentrum Unfall- und Handchirurgie, Orthopädische Klinik Hess. Lichtenau, Hessisch Lichtenau, Deutschland.
Objective: Osteosynthesis in dislocated diametaphyseal forearm fractures is intended to restore anatomy and function. Antegrade intramedullary nailing in the radius is used to restore length, rotation, and axis within the age-specific correction limits. Sufficient stability ensures early functional postoperative treatment without load.
View Article and Find Full Text PDFJBJS Essent Surg Tech
November 2024
Department of Spine Surgery, Ganga Medical Center and Hospital, Coimbatore, Tamil Nadu, India.
Background: Patient-specific instruments (PSIs) were reported to improve implant position and rotation accuracy in total knee arthroplasty (TKA), among other benefits. Most PSIs used in TKA were commercial products from implant manufacturers, which could be time-consuming and could potentially affect accuracy as they relied on engineer's decision. This study aimed to present the radiological outcomes of PSI produced by the 3D printing facility at our hospital, with direct involvement of the surgeon in its design.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!