In the egg ofPimpla turionellae L., three density gradients are produced by different methods of centrifugation. In spinning, the egg is rotated about its own long axis, so that the lightest egg material is collected in a central column (radial stratification). Flinging parallel to the long axis has been carried out at a short distance from the rotational axis (rotation axis situated immediately adjacent to a long edge of the egg) as well as further from the rotational axis (at a distance of 4.5 cm). A transversal stratification is thereby produced, in which the lightest and the heaviest material are collected at opposite long edges of the egg. The same stratification results from all three methods. From centripetal outward toward centrifugal, a lipid zone, a light yolk zone, a cytoplasm zone poor in yolk granules (basophilic cytoplasmic network), a dense yolk zone and a glycogen zone are formed. The sharpness of separation between the zones in eggs centrifuged during maturation divisions is better than that in eggs spun or flung during cleavage or pre-blastoderm formation. Either development ceases soon after the experiment has taken place or the centrifuged eggs develop into larvae. Half of the eggs flung at short distance or spun about the rotational axis with 10000-12000g are able to develop into embryos. Eggs handled by both of these methods show identical development at increasing accelerations. Eggs flung at greater distance already cease their development after a treatment at 10000g. Malformations or incomplete embryos do not occur in any group of experiments. These findings allow postulation of a system of factors sensitive to accelerations higher than 10000g, which is arranged cylindrically within the egg and which is not connected in any way to the shiftable, light microscopic fractions. This postulated system of factors could have a dynamic function and thereby be an essential component of the primary organization pattern in the egg ofPimpla.Only eggs forming polar caps at opposite ends of the egg within 1.5-2 hours after the experiment will develop into embryos. The polar caps are formed independently of each other. Following too great a stress on the end of the egg oblique to the rotational axis, ooplasm contraction fails to take place. Ooplasmic redistribution has been pursued in life and in section pictures in eggs continuing to and failing to develop. Redistribution combined with a regulated removal of zones is evidently connected with the energid migration. The content of the lipid plasm zone disappears to some extent during redistribution. The posterior part possesses the highest capacity for development in nonviable eggs. It is sometimes able to form a blastoderm independently of the anterior region. A blastoderm is formed only if the posterior part includes the region between 25 and 35% of the egg.

Download full-text PDF

Source
http://dx.doi.org/10.1007/BF00574895DOI Listing

Publication Analysis

Top Keywords

rotational axis
16
egg
11
eggs
9
long axis
8
material collected
8
short distance
8
yolk zone
8
eggs flung
8
develop embryos
8
system factors
8

Similar Publications

Orientation angles are commonly used to describe complex angular motions of the body. Selecting the most appropriate rotation sequence for a given segment's motion is crucial. The purpose of this study was to develop a set of generalisable, primary axis-centric sequence selection strategies and to compare the lean direction-lean-rotation (LDLR) sequence, selected for thoracic motion during golf driving based on the strategies, with the conventional rotation-bend-side bend (RBSB) sequence in assessing the level of inter-angle cross-talk.

View Article and Find Full Text PDF

Is a vertical fracture fragment after indirect reduction acceptable in minimally invasive plate osteosynthesis for acute mid-shaft clavicular fractures?

Injury

January 2025

Department of Orthopedic Surgery, Korea University Anam Hospital, Korea University College of Medicine, 73, Goryeodae-ro, Seongbuk-gu, Seoul 02841, Republic of Korea. Electronic address:

Purpose: Reduction and intraoperative maintenance of fracture fragments during minimally invasive plate osteosynthesis (MIPO) pose technical difficulties, particularly when the interposed fragment is angulated, prompting surgeons to attempt reduction due to concerns about nonunion or malunion. We aimed to compare the clinical and radiological outcomes of MIPO for mid-shaft clavicular fractures based on the reduced status of the interposed fragments.

Method: Fifty-seven patients who underwent MIPO for acute mid-shaft Robinson type 2B clavicular fractures were divided into two groups based on the alignment of the interposed fracture fragment.

View Article and Find Full Text PDF

The misalignment between the geometric and optical axes, combined with rotational asymmetry, poses significant challenges for achieving high-accuracy measurement of the off-axis aspheric mirror during the fabrication and polishing processes. To address this issue, this paper presents a method based on stereo deflectometry for measuring the figure of the off-axis aspheric mirror. In this method, point cloud of the off-axis aspheric mirror is first obtained using stereo deflectometry.

View Article and Find Full Text PDF

This work investigates how misalignments of collimation lenses affect two performance criteria: minimum throughput within an angular window and maximum beam height. Based on these criteria, we establish an alignment concept for the first section of a LiDAR emitter. The performance criteria are derived from the overall LiDAR system requirements and applied to an optical system consisting of a laser diode array source, a microlens array for slow-axis collimation, and an acylinder for fast-axis collimation.

View Article and Find Full Text PDF

We study properties of a light field at the tight focus of the superposition of two different-order cylindrical vector beams (CVBs). In the source plane, this superposition has a polarization singularity index amounting to the half-sum of the numbers of two constituent CVBs, while having neither spin angular momentum (SAM) nor transverse energy flow. We show that if the constituent CVBs have different-parity numbers, in the focal plane there occur areas that have opposite-sign longitudinal SAM projections, alongside areas of opposite-handed energy flows rotating on closed paths (clockwise and anticlockwise).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!