Background: In total knee arthroplasty (TKA), femoral component rotation is an important factor in the flexion stability and biomechanics of the patellofemoral joint. However, it remains unclear how much tension is appropriate when performing TKA using the gap technique.
Methods: One hundred fifty TKAs that used the gap technique were randomized into one of the three groups. Gravity group (n=50) included patients who underwent TKA using only the weight of the patient's lower leg. In 20-lbf group (n=50) and 30-lbf group (n=50), a gap-tensioning device was set at 20lbf and 30lbf respectively. The femoral component rotation was measured based on the clinical transepicondylar axis (cTEA) on postoperative CT and any outliers (a femoral component rotation diverging from the cTEA over 3°) were evaluated.
Results: The mean femoral component rotation was -0.82°±2.44° (95% confidence interval [CI], -1.52° to -0.13°) in gravity group, -0.40°±2.22° (95% CI, -1.03° to 0.23°) in 20-lbf group, and 1.37°±2.70° (95% CI, 0.61° to 2.14°) in 30-lbf group. The mean femoral component rotation in 30-lbf group was significantly different from that in gravity group (p<0.001) and 20-lbf group (p<0.001). There were more outliers in 30-lbf group (18% in gravity group, 18% in 20-lbf group, and 36% in 30-lbf group; p=0.043).
Conclusions: The use of a tensioning device set at 30lbf resulted in an externally rotated femoral component and frequent outliers.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.knee.2017.01.003 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Mid-term Clinical and Radiographic Outcomes of the Actis Total Hip System: A Retrospective Study.
Cureus
January 2025
Department of Orthopaedic Surgery, Faculty of Medicine, Dentistry and Pharmaceutical Sciences, Okayama University, Okayama, JPN.
Introduction Implant technology for total hip arthroplasty (THA) was developed to improve hip function and patient satisfaction. Actis (DePuy Synthes, Warsaw, IN, USA) is a short fit-and-fill titanium stem, with a medial-collared and triple-taper (MCTT) geometry, that is fully coated with hydroxyapatite (HA). We evaluated the radiographic and clinical outcomes of the Actis Total Hip System during a mean follow-up of five years.
View Article and Find Full Text PDFVarus/valgus angle of the femoral component relative to the tibial component increases risk of bearing dislocation in medial mobile bearing unicompartmental knee arthroplasty.
BMC Musculoskelet Disord
January 2025
Senior Department of Orthopedics, The Fourth Medical Center of PLA General Hospital, No. 51 Fucheng Road, Beijing, 100048, People's Republic of China.
Background: In medial mobile-bearing unicompartmental knee arthroplasty (MB-UKA), the position of the bearing does not correspond to the planned position which will increasing the risk of bearing dislocation. This study aimed to explore the relationship between the malposition of the femoral and tibial components and the phenomenon of bearing deviation using postoperative radiological measurements.
Methods: One hundred twenty patients who underwent mobile-bearing uni-compartmental knee arthroplasty (MB-UKA) at our hospital between January and August 2023 were enrolled in this retrospective study.
Comparison of long-term clinical and radiologic outcomes of AperFix and fixed loop device fixation in anterior cruciate ligament reconstruction: A retrospective study.
Medicine (Baltimore)
January 2025
Department of Orthopaedics and Traumatology, Faculty of Medicine, Van Yuzuncu Yil University, Van, Turkey.
Anterior cruciate ligament reconstruction aims to improve knee stability and range of motion. The AperFix system consists of polymer components, and fixed-loop fixation is an established endoscopic technique. Our aim in this study was to compare the long-term clinical and radiological results of AperFix and fixed-loop fixation and to prove that the long-term results of the AperFix fixation method are at least as good as those of the fixed loop device.
View Article and Find Full Text PDFLow rates of dislocation and reoperation following robotic-assisted total hip arthroplasty for femoral neck fracture.
Hip Int
January 2025
Department of Orthopaedic Surgery, Hospital for Special Surgery, New York, NY, USA.
Introduction: Total hip arthroplasty (THA) is widely used for active, elderly patients with femoral neck fractures (FNF). Compared to THA for osteoarthritis, THA for FNF is associated with a higher incidence of dislocation and reoperation. Robotic assistance may improve component positioning and leg-length restoration in THA, but its use in FNF has not been described.
View Article and Find Full Text PDFHigh Detection Rate of Posterolateral Tibial Plateau Fractures and Poor Functional Outcomes in Type IIIB Impaction Fractures After Anterior Cruciate Ligament Rupture and Reconstruction.
Orthop Surg
January 2025
Department of Orthopedics, The Second Affiliated Hospital of Soochow University, Suzhou, Jiangsu, People's Republic of China.
Objective: The incidence of anterior cruciate ligament (ACL) ruptures has been increasing annually. However, clinical surgeons have overlooked the impaction fractures of the posterolateral tibial plateau and lateral femoral condyle in patients with ACL ruptures. The purpose of the present study was to report the detection rate of the posterolateral tibial plateau impaction fractures in patients with ACL ruptures, and to evaluate the functional outcomes of patients following ACL reconstruction (ACLR) without treatment of the tibial fractures at a 2-year postoperative follow-up.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!