Structural and emission properties of Tb-doped nitrogen-rich silicon oxynitride films.

Nanotechnology

CIMAP, Normandie Univ, ENSICAEN, UNICAEN, CEA, CNRS, 6 Boulevard Maréchal Juin 14050 Caen Cedex 4, France.

Published: March 2017

Terbium doped silicon oxynitride host matrix is suitable for various applications such as light emitters compatible with CMOS technology or frequency converter systems for photovoltaic cells. In this study, amorphous Tb ion doped nitrogen-rich silicon oxynitride (NRSON) thin films were fabricated using a reactive magnetron co-sputtering method, with various N flows and annealing conditions, in order to study their structural and emission properties. Rutherford backscattering (RBS) measurements and refractive index values confirmed the silicon oxynitride nature of the films. An electron microscopy analysis conducted for different annealing temperatures (T ) was also performed up to 1200 °C. Transmission electron microscopy (TEM) images revealed two different sublayers. The top layer showed porosities coming from a degassing of oxygen during deposition and annealing, while in the region close to the substrate, a multilayer-like structure of SiO and SiN phases appeared, involving a spinodal decomposition. Upon a 1200 °C annealing treatment, a significant density of Tb clusters was detected, indicating a higher thermal threshold of rare earth (RE) clusterization in comparison to the silicon oxide matrix. With an opposite variation of the N flow during the deposition, the nitrogen excess parameter (N) estimated by RBS measurements was introduced to investigate the Fourier transform infrared (FTIR) spectrum behavior and emission properties. Different vibration modes of the Si-N and Si-O bonds have been carefully identified from the FTIR spectra characterizing such host matrices, especially the 'out-of-phase' stretching vibration mode of the Si-O bond. The highest Tb photoluminescence (PL) intensity was obtained by optimizing the N incorporation and the annealing conditions. In addition, according to these conditions, the integrated PL intensity variation confirmed that the silicon nitride-based host matrix had a higher thermal threshold of rare earth clusterization than its silicon oxide counterpart. Analysis of time-resolved PL intensity versus T showed the impact of Tb clustering on decay times, in agreement with the TEM observations. Finally, PL and PL excitation (PLE) experiments and comparison of the related spectra between undoped and Tb-doped samples were carried out to investigate the impact of the band tails on the excitation mechanism of Tb ions.

Download full-text PDF

Source
http://dx.doi.org/10.1088/1361-6528/aa5ca0DOI Listing

Publication Analysis

Top Keywords

silicon oxynitride
16
emission properties
12
structural emission
8
nitrogen-rich silicon
8
host matrix
8
annealing conditions
8
rbs measurements
8
confirmed silicon
8
electron microscopy
8
1200 °c
8

Similar Publications

Singlet exciton fission has the potential to increase the efficiency of crystalline silicon solar cells beyond the conventional single junction limit. Perhaps the largest obstacle to achieving this enhancement is uncertainty about energy coupling mechanisms at the interfaces between silicon and exciton fission materials such as tetracene. Here, the previously reported silicon-hafnium oxynitride-tetracene structure is studied and a combination of magnetic-field-dependent silicon photoluminescence measurements and density functional theory calculations is used to probe the influence of the interlayer composition on the triplet transfer process across the hafnium oxynitride interlayer.

View Article and Find Full Text PDF

Structural, Mechanical, and Optical Properties of Laminate-Type Thin Film SWCNT/SiON Composites.

Nanomaterials (Basel)

November 2024

Department of Materials and Environmental Technology, School of Engineering, Tallinn University of Technology, Ehitajate tee 5, 19086 Tallinn, Estonia.

The development of new encapsulating coatings for flexible solar cells (SCs) can help address the complex problem of the short lifespan of these devices, as well as optimize the technological process of their production. In this study, new laminate-type protective composite coatings were prepared using a silicon oxynitride thin-film matrix obtained by curing the pre-ceramic polymer perhydropolysilazane (PHPS) through two low-temperature methods: (i) thermal annealing at 180 °C and (ii) exposure to UV radiation at wavelengths of 185 and 254 nm. Single-walled carbon nanotubes (SWCNTs) were used as fillers via dry transfer, facilitating their horizontal orientation within the matrix.

View Article and Find Full Text PDF

Passivation Effect of Rock-Salt Nitride Materials on a Planar -Si Photocathode for Solar Water Reduction.

ACS Appl Mater Interfaces

November 2024

Department of Chemistry Education and Optoelectronic Convergence Research Center, Chonnam National University, Gwangju 61186, Republic of Korea.

Article Synopsis
  • Photoelectrochemical water splitting is becoming important for producing clean hydrogen fuel using sunlight, driven by concerns over fossil fuels and pollution.
  • Silicon photocathodes are effective due to their light absorption abilities, but issues like low voltage and rapid corrosion limit their performance.
  • This study explores a titanium nitride passivation layer and a molybdenum oxynitride cocatalyst to improve the stability and efficiency of silicon photocathodes, achieving a high onset potential and over 140 hours of stable operation under harsh conditions.
View Article and Find Full Text PDF

In the current research, the silicon carbon oxynitride (SiCON) thin film was deposited on the silicon (Si) substrate by radio frequency (RF) reactive magnetron sputtering method. To comprehensively assess the impact of nitrogen flux rate on thin film characteristics, a suite of advanced analytical methods was utilized. The GIXRD analysis confirmed that the SiCON thin film is amorphous in structure.

View Article and Find Full Text PDF
Article Synopsis
  • - We propose an efficient design for a spin-photon interface using a diamond microdisk topped with a silicon oxynitride triangular lattice, allowing for effective light emission without needing precise alignment between layers.
  • - The setup achieves a high quantum efficiency of up to 46% for a specific type of color center in the diamond, making it promising for larger-scale production of quantum light sources.
  • - Our new optimization method leverages a dipole model to significantly enhance free space performance, yielding results similar to complex simulations but with a much shorter computation time (a 7·10 reduction).
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!