BTEX (benzene, toluene, ethylbenzene, ortho-, meta-, and para-xylenes), methyl tert-butyl ether (MTBE), cis-1,2-dichloroethylene (cis-DCE), and trichloroethylene (TCE) are among the major soil and groundwater contaminants frequently co-existing, as a result of their widespread uses. Pseudomonas plecoglossicida was immobilized on waste scrap tyre to remove these contaminants mixture from synthetic contaminated water. The microbial activity was enhanced in the immobilized system, shown by the higher colony forming units (CFUs) (40%), while BTEX were used as growth substrates. The adsorption capacity of tyres toward contaminants reached a maximum within one day, with BTEX (76.3%) and TCE (64.3%) showing the highest sorption removal capacities, followed by cis-DCE (30.0%) and MTBE (11.0%). The adsorption data fitted the Freundlich isotherm with a good linear correlation (0.989-0.999) for the initial contaminants concentration range applied (25-125mg/L). The monoaromatic hydrocarbons were almost completely removed in the immobilized system and the favourable removal efficiencies of 78% and 90% were obtained for cis-DCE and TCE, respectively. The hybrid (biological, immobilization/physical, sorption) system was further evaluated with the contaminants spiked intermittently for the stable performance. The addition of mineral salt medium further enhanced the bioremoval of contaminants by stimulating the microbial growth to some extent.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.scitotenv.2017.01.025 | DOI Listing |
J Hazard Mater
December 2024
College of Materials Science and Chemical Engineering, Harbin Engineering University, Harbin 150001, China; Nanhai Institute of Harbin Engineering University, Sanya 572024, China. Electronic address:
The rational use of solar energy to achieve photothermal conversion is an attractive strategy to promote the efficient removal of radioactive Cs and Sr from nuclear wastewater. Herein, a photothermal adsorbent of composite aerogel with three-dimensional porous structure is fabricated by integrating prussian blue analogues (PBAs) and straw biochar into the chitosan (CS) and waste leather scrap hydrolysate (WLSH) aerogel matrix (CS/WLSH/C/PBAs). The local heating effect generated by CS/WLSH/C/PBAs aerogel induce to generate steam, accelerating the enrichment of Cs and Sr in the solution, which increase their interaction with the CS/WLSH/C/PBAs and improves their adsorption rates and capacities.
View Article and Find Full Text PDFMaterials (Basel)
November 2024
Chemical Engineering Department, ESEIAAT-UPC, Colom 11, 08222 Terrassa, Spain.
A new method is proposed to generate hydrogen in situ at low pressure from powder-pressed recycled aluminum turnings activated with small amounts of NaOH and drops of water. The contribution of this system is that the user can obtain small flows of high-purity hydrogen (>99%) to charge their portable electronic devices in remote places, in a simple, controlled, and safe way, since only water is used. Test tubes that contain tiny amounts of NaOH on their surface can be transported and used without contact.
View Article and Find Full Text PDFMaterials (Basel)
November 2024
School of Metallurgical Engineering, Jiangxi University of Science and Technology, Ganzhou 341000, China.
We conducted a mechanistic and experimental study on zinc fluoride roasting for the recovery of NdFeB waste to address the difficulties faced during this pyrometallurgical recovery process, such as the high dependence on the quality of raw materials, the high energy consumption involved in roasting transformations, and the low added value of mixed rare earth products. Thermodynamic calculations showed the feasibility of fluorinating rare earths in NdFeB waste, and one-factor experiments were performed. The results showed that at a roasting temperature of 850 °C, a reaction time of 90 min, and 100% ZnF addition, the fluorination rate of rare earths could reach 95.
View Article and Find Full Text PDFBiomacromolecules
December 2024
College of Bioresources Chemical and Materials Engineering (College of Flexible Electronics), Shaanxi University of Science & Technology, Xi'an 710021, China.
The development of engineered hydrogels with high strength, self-recovery, and adhesion is essential for applications requiring resistance to large deformations and cyclic loading. Herein, a triple-network (TN) hydrogel with ultrahigh compressive strength, strong adhesion, and good self-recovery was constructed by using tannic acid-modified chrome leather scrap hydrolysate as the first network, polyacrylamide as the second network, and poly-2-propenamide-2-methylpropanesulfonic acid as the third network. The ultrahigh (70 MPa compressive strength and 95% compression deformation) TN hydrogels were effectively created, which is attributed to the synergy of the three networks.
View Article and Find Full Text PDFWaste Manag Res
December 2024
Department of Environmental Engineering and Management, University of Dodoma, Dodoma, Tanzania.
This article aims to undertake a mini-review of the current state of electronic waste (e-waste) challenges on the African continent through a systematic analysis of existing national policies and legal frameworks, inventorying established management practices, and identification of innovative technological solutions. A literature review was conducted synthesizing evidence from over 80 peer-reviewed publications between 2010 and 2022. Content analysis of e-waste laws from 20 African countries supplemented the review of documented collection, recycling and export-related activities across the region alongside associated obstacles.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!