Tailpipe and evaporative emissions from three pre-1985 passenger motor vehicles operating on an ethanol oxygenated and on a nonoxygenated (base) fuel were characterized. Emission data were collected for vehicles operating over the Federal Test Procedure at 90 °F, 75 °F, and 40 °F to simulate ambient driving conditions. The two fuels tested were a commercial summer-grade regular gasoline (the nonoxygenated base fuel) and an oxygenated fuel containing 8.8% ethanol, more paraffins and olefins, and less aromatics than the base fuel. The Reid vapor pressure (RVP) was adjusted to correspond to that of the base fuel. The emissions measured were total hydrocarbons (THCs), speciated hydrocarbons, spedated aldehydes, carbon monoxide (CO), and oxides of nitrogen (NOX). This study showed a general reduction in tailpipe emissions of THC, CO, benzene, and 1,3-butadiene when tested with the ethanol fuel. The ethanol fuel significantly reduced these emissions from the high emitting vehicle, MU098, at 90 °F, 75 °F, and 40 °F test temperatures. Additionally, the ethanol fuel reduced CO emissions from vehicle BU950, with and without catalyst, and from vehicle CI415 at 40 °F. Both formaldehyde and acetaldehyde emissions generally increased when tested with the oxygenated fuel. The acetaldehyde emissions were about double with this fuel. The limited data indicate that most emissions, including toxics, occur during the first 124 seconds of vehicle start-up. Diurnal evaporative emissions were less from the oxygenated fuel, while hot-soak evaporative emissions were greater from the oxygenated fuel (for all vehicles except MU098). Evaporative emissions were generally greatest at the 90 °F test temperature.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1080/10473289.1996.10467550 | DOI Listing |
Nanomaterials (Basel)
December 2024
Department of General Physics, Kazan National Research Technical University Named After A.N. Tupolev-KAI, Kazan 420111, Russia.
In this work, within the framework of a self-consistent model of arc discharge, a simulation of plasma parameters in a mixture of argon and methane was carried out, taking into account the evaporation of the electrode material in the case of a refractory and non-refractory cathode. It is shown that in the case of a refractory tungsten cathode, almost the same methane conversion rate is observed, leading to similar values in the density of the main methane conversion products (C, C, H) at different values of the discharge current density. However, with an increase in the current density, the evaporation rate of copper atoms from the anode increases, and a jump in the - characteristic is observed, caused by a change in the plasma-forming ion.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Electro-Optical Engineering, National Taipei University of Technology, Taipei, 10608, Taiwan.
This work reports on the preparation process of a double-layer perovskite active layer. The first active layer film, CsKPEAPbIBr, was fabricated using a spin-coating method, while the second active layer, MAPbBr, was deposited using MAPbBr single crystals as the evaporation source. Additionally, doping the PEDOT: PSS hole transport layer with ETA and EDA can enhance the uniformity of the perovskite film and reduce voids, improving charge transport efficiency.
View Article and Find Full Text PDFToxics
November 2024
Joint International Research Laboratory of Climate and Environment Change, Jiangsu Key Laboratory of Atmospheric Environment Monitoring and Pollution Control, Collaborative Innovation Center of Atmospheric Environment and Equipment Technology, School of Environmental Science and Engineering, Nanjing University of Information Science and Technology, Nanjing 210044, China.
This study investigates the chemical complexity and toxicity of volatile organic compounds (VOCs) emitted from national petrochemical industrial parks and their effects on air quality in an industrial area of Nanjing, China. Field measurements were conducted from 1 December 2022, to 17 April 2023, focusing on VOC concentrations and speciations, diurnal variations, ozone formation potential (OFP), source identification, and associated health risks. The results revealed an average total VOC (TVOC) concentration of 15.
View Article and Find Full Text PDFJ Hazard Mater
December 2024
School of Environmental Science and Engineering, Shanghai Jiao Tong University, Shanghai 200240, PR China; Shanghai Institute of Pollution Control and Ecological Security, Shanghai 200092, PR China. Electronic address:
Wet-crushing with aqueous media protection is considered safer and more efficient than common inert-gas protected dry-crushing in preprocessing spent lithium-ion batteries (LIBs). However, it is also accompanied with the releasement and transformation of hazardous electrolyte, while the mechanisms and pollution impact yet remain unknown. Based on a self-built wet-crushing system, this topic was systematically investigated here.
View Article and Find Full Text PDFSci Rep
January 2025
Department of Information Systems, College of Computing and Informatics, The University of Sharjah, Sharjah, UAE.
This study explores the integration of nanotechnology and Long Short-Term Memory (LSTM) machine learning algorithms to enhance the understanding and optimization of fuel spray dynamics in compression ignition (CI) engines with varying bowl geometries. The incorporation of nanotechnology, through the addition of nanoparticles to conventional fuels, improves fuel atomization, combustion efficiency, and emission control. Simultaneously, LSTM models are employed to analyze and predict the complex spray behavior under diverse operational and geometric conditions.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!