Street dust samples were collected from five different types of land use patterns (busy traffic zone, urban residential area, national highways, industrial area and sensitive area) in a medium sized industrial city Asansol, India. The samples were fractionated into ≤53µm and analyzed for potential toxic elements (PTEs) viz. Zn, Cd, Pb and Cu. The mean total concentration of Zn, Cd, Pb and Cu in the urban street dust samples were 192, 0.75, 110 and 132mgkg respectively. Chemical speciation was performed for PTEs to evaluate the bio-available fractions. Cu was mostly associated with organic matter phase while Zn, Pb and Cd with residual phase. Mean mobility factor (MF) for heavy metals in Asansol was Zn (54.6%)>Pb (49.1%)>Cu (25.3%)>Cd (22.7%). Geo-chemical indices such as Enrichment Factor (EF), geo-accumulation index (Igeo) and contamination Factor (CF) were in the order of Pb>Cd>Zn>Cu. Cluster analysis was done to understand the similarities among the sites. The risks of all metals was calculated with mobile fraction, which indicated actual risk due to PTEs was less (HI<1).
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.ecoenv.2017.01.008 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Adapting Methods for Isolation and Enumeration of Microplastics to Quantify Tire Road Wear Particles with Confirmation by Pyrolysis GC-MS.
Environ Sci Technol
January 2025
U.S. Environmental Protection Agency, E205-02, Research Triangle Park, P.O. Box 12055, Durham, North Carolina 27711, United States.
The complex, varied composition (i.e., rubbers/elastomers, carbon black, fillers, additives, and embedded road materials) and wide density range of tire road wear particles (TRWPs) present challenges for their isolation and identification from environmental matrices.
View Article and Find Full Text PDFPerformance Restoration of Chemically Recycled Carbon Fibres Through Surface Modification with Sizing.
Polymers (Basel)
December 2024
Research Lab of Advanced, Composite, Nano-Materials and Nanotechnology (R-NanoLab), School of Chemical Engineering, National Technical University of Athens, 9 Heroon Polytechniou, GR-15773 Athens, Greece.
The recycling of Carbon Fibre-Reinforced Polymers (CFRPs) is becoming increasingly crucial due to the growing demand for sustainability in high-performance industries such as automotive and aerospace. This study investigates the impact of two chemical recycling techniques, chemically assisted solvolysis and plasma-enhanced solvolysis, on the morphology and properties of carbon fibres (CFs) recovered from end-of-life automotive parts. In addition, the effects of fibre sizing are explored to enhance the performance of the recycled carbon fibres (rCFs).
View Article and Find Full Text PDFRevealing Stachybotrys-like fungal growth in buildings - Possible exposure highlighted through three case studies.
Sci Total Environ
January 2025
Department of Civil Engineering, Aalto University, 00076 Espoo, Finland; International Laboratory for Air Quality and Health, Faculty of Science, School of Earth & Atmospheric Sciences, Queensland University of Technology, 2 George Street, Brisbane, QLD 4000, Australia. Electronic address:
Genus Stachybotrys (Stachybotryaceae, Hypocreales) requires high humidity to grow and represents one of the most notorious fungi associated with suspected illness in moist buildings. If Stachybotrys conidia are found in settled indoor dusts, their presence may indicate water intrusion and mold infestation revealed after dismantling the building structures. This study describes detection of Stachybotrys growth hidden inside the structures of three buildings in Finland.
View Article and Find Full Text PDFThe Influence of Resin Volume Fraction on Selected Properties of Polymer Concrete.
Materials (Basel)
December 2024
Micronization Laboratory, Łukasiewicz Research Network-New Chemical Syntheses Institute, Sowińskiego 11 Street, 44-101 Gliwice, Poland.
Polymer concrete is a promising material with applications in construction and architecture; however, guidelines for its design and optimization are not well-established in the literature. This study aimed to evaluate how resin volume fraction and aggregate size distribution affect key properties of polyester polymer concrete, including flexural strength, compressive strength, water absorption, and material cost. Three types of quartz aggregates with different particle size distributions were used, as follows: small (below 0.
View Article and Find Full Text PDFExploring heavy metal dynamics and risks from dust and soil in urban cities of Jharkhand, India.
Sci Rep
December 2024
Department of Civil and Environmental Engineering, Birla Institute of Technology, Mesra, Ranchi, Jharkhand, 835215, India.
Jharkhand is a minerally prosperous state with geogenic and industrial origins of metals. This study assesses the seasonal variation of pseudo-total metal contents (Cr, Ni, Pb, Zn, Mn, Cu, Fe, Mg, Al) and related contamination and risks in indoor dust, street dust, and soils of four major cities of Jharkhand. Across cities and seasons, Zn, Cu, and Pb were the most common pollutants.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!