Towards highly stable aqueous dispersions of multi-walled carbon nanotubes: the effect of oxygen plasma functionalization.

J Colloid Interface Sci

Dipartimento di Chimica, Università degli Studi "Aldo Moro", via Orabona 4, Bari 70126, Italy; CNR-NANOTEC, Istituto di Nanotecnologia, URT Bari c/o Dipartimento di Chimica, via Orabona 4, Bari 70126, Italy; Consorzio INSTM, UdR Bari, Italy.

Published: April 2017

In order to improve the dispersion of multi-walled carbon nanotubes (MWCNTs) in aqueous media, their surface functionalization was carried out in O-fed low-pressure plasmas. Differently from what can be found in the literature of this field, homogeneous functionalization was achieved by generating the plasma inside vials containing the nanotube powders properly stirred. Experimental parameters, such as input power, treatment time and pressure, were varied to investigate their influence on the process efficiency. A detailed characterization of the plasma treated nanotubes, dry and in aqueous suspension, was carried out with a multi-diagnostic analytical approach, to evaluate their surface chemical properties, morphology, structural integrity and stability in the colloidal state. The plasma grafting of polar ionizable (e.g. acid) groups has been proved to successfully limit the agglomeration of MWCNTs and to produce nanotubes suspensions that are stable for one month and more in water.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jcis.2016.12.039DOI Listing

Publication Analysis

Top Keywords

multi-walled carbon
8
carbon nanotubes
8
highly stable
4
stable aqueous
4
aqueous dispersions
4
dispersions multi-walled
4
nanotubes
4
nanotubes oxygen
4
plasma
4
oxygen plasma
4

Similar Publications

In this study, we investigate the thermoelectric properties of functionalized multi-walled carbon nanotubes (F-MWCNTs) dispersed over a flexible substrate through a facile vacuum filtration route. To improve their interfacial adhesion and dispersion, F-MWCNTs underwent hot-pressing. The heat-treatment has improved the nanotubes' connections and subsequently reduced porosity as well, which results in an increasing electrical conductivity upon increasing temperature of hot-pressing.

View Article and Find Full Text PDF
Article Synopsis
  • Multi-walled carbon nanotubes (CNT) are embedded with RuPdIrPtAu high entropy alloys (HEA) using pulsed laser irradiation in liquids, resulting in a composite that enhances hydrazine oxidation reactions (HzOR) for improved water electrolysis.
  • HEA particles, sized around 2-5 nm, are effectively dispersed on the CNTs, allowing an optimized variant (HEA/CNT-10) to demonstrate superior performance in oxygen and hydrogen evolution reactions (OER and HER), showing low overpotentials of 30.7 mV for OER and 330 mV for HER.
  • The composite exhibits a lower voltage requirement of 0.1 V for HzOR compared to the 1.56
View Article and Find Full Text PDF

The electrochemical biosensor has brought a paradigm shift in the field of sensing due to its fast response and easy operability. The performance of electrochemical sensors can be modified by coupling them with various metal oxides, nanomaterials, and nanocomposites. Hydrogen peroxide is a short-lived reactive oxygen species that plays a crucial role in various physiological and biological processes.

View Article and Find Full Text PDF

This study involves a novel CuO/CoFe₂O₄/MWCNTs (CCT) nanocomposite, developed by integrating cobalt ferrite (CoFe₂O₄) and copper oxide (CuO) nanoparticles onto multi-walled carbon nanotubes (MWCNTs), for the degradation of tetracycline (TC) under visible light. The photocatalyst was extensively characterized using XRD, HR-SEM, EDX, HR-TEM, UV-Vis, BET, and PL analysis. The synthesized CoFe₂O₄ and CuO nanoparticles exhibited crystallite sizes of 46.

View Article and Find Full Text PDF

Introduction: This study aimed to evaluate the antimicrobial efficacy of single-walled carbon nanotubes when combined with the commonly used intracanal medicaments by checking their zone of inhibition against .

Materials And Methods: The test materials were divided into five different groups, namely, Group I: single-walled carbon nanotubes; Group II: calcium hydroxide; Group III: chlorhexidine; Group IV: single-walled carbon nanotubes + calcium hydroxide; and Group V: single-walled carbon nanotubes + chlorhexidine. Five sterile Petri plates per group were inoculated with (); wells were made in the plates, one on each side, and a volume of 50 microliters of each solution was dispensed into individual wells using a pipette.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!