Our aim is to study the inflammatory response towards the collagen-coated and non-coated polypropylene meshes in rats and the urodynamic investigation post-operatively. Forty-two female Sprague Dawley were divided into 7 groups of 6 rats; Control, Day 7 and 30 for Sham, Avaulta Plus (MPC), Perigee (MP). UDS were taken at days 7 and 30. Mesh with the vagina and bladder wall was removed and sent for immunohistochemical examination. Results showed intense inflammatory reaction on day 7 in the study groups which decreased on day 30. IL-1, TNF-α, MMP-2 and CD31 were observed to decrease from day 7 to day 30. NGF was almost normal on day 30 in all groups. UDS showed no difference in voiding pressure. Both Study and Sham groups had shorter voiding interval (VI) on day 7 but significantly lower in MPC. VI had significantly increased on day 30 in all groups. Voided volume was significantly lower in the mesh groups even when an increase was seen on day 30. In conclusion, the higher levels of IL-1, TNF-α and MMP-2 in collagen-coated polypropylene mesh imply greater inflammation than the non-coated polypropylene mesh. Mesh implantation can lead to shorter voiding interval and smaller bladder capacity.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5172279 | PMC |
| http://dx.doi.org/10.1038/srep38960 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Retroperitoneal totally endoscopic prosthetic repair of primary lumbar hernia.
Hernia
December 2021
Department of General Surgery, Nanfang Hospital, Southern Medical University, 1838 N Guangzhou Ave, Guangzhou, 510515, China.
Purpose: A primary lumbar hernia is a rare entity that requires surgical management, but the preferred technique has not been established. We herein describe a standardized and reproducible retroperitoneal totally endoscopic prosthetic (TEP) repair technique for primary lumbar hernias.
Methods: Ten adult patients with primary lumbar hernias underwent retroperitoneal TEP repair from February 2019 to July 2020.
Introduction: Parastomal hernias (PSH) are the most common complication of stoma creation and can cause significant morbidity. We present a consecutive series of patients receiving prophylactic mesh augmentation (PMA) for prevention of PSH.
Methods: This retrospective review evaluates the efficacy and outcomes of PMA for PSH prevention, and retrospectively compares traditional keyhole PMA (tPMA) (n = 28) with a prophylactic Stapled Ostomy Reinforcement with Retromuscular Mesh technique (pSTORRM) (n = 24).
Morphogenetically-Active Barrier Membrane for Guided Bone Regeneration, Based on Amorphous Polyphosphate.
Mar Drugs
May 2017
ERC Advanced Investigator Grant Research Group at the Institute for Physiological Chemistry, University Medical Center of the Johannes Gutenberg University Mainz, Duesbergweg 6, 55128 Mainz, Germany.
We describe a novel regeneratively-active barrier membrane which consists of a durable electrospun poly(ε-caprolactone) (PCL) net covered with a morphogenetically-active biohybrid material composed of collagen and inorganic polyphosphate (polyP). The patch-like fibrous collagen structures are decorated with small amorphous polyP nanoparticles (50 nm) formed by precipitation of this energy-rich and enzyme-degradable (alkaline phosphatase) polymer in the presence of calcium ions. The fabricated PCL-polyP/collagen hybrid mats are characterized by advantageous biomechanical properties, such as enhanced flexibility and stretchability with almost unaltered tensile strength of the PCL net.
View Article and Find Full Text PDFThe immunohistochemical and urodynamic evaluation towards the collagen-coated and non-coated polypropylene meshes implanted in the pelvic wall of the rats.
Sci Rep
December 2016
Fellow of the Division of Urogynaecology, Department of Obstetrics &Gynaecology, Chang Gung Memorial Hospital, Linkou, Taoyuan, Taiwan, Republic of China.
Our aim is to study the inflammatory response towards the collagen-coated and non-coated polypropylene meshes in rats and the urodynamic investigation post-operatively. Forty-two female Sprague Dawley were divided into 7 groups of 6 rats; Control, Day 7 and 30 for Sham, Avaulta Plus (MPC), Perigee (MP). UDS were taken at days 7 and 30.
View Article and Find Full Text PDFAtomic layer deposition as pore diameter adjustment tool for nanoporous aluminum oxide injection molding masks.
Langmuir
May 2008
Department of Chemistry, University of Joensuu, P.O. Box 111, FI-80101 Joensuu, Finland.
The wetting properties of polypropylene (PP) surfaces were modified by adjusting the dimensions of the surface nanostructure. The nanostructures were generated by injection molding with nanoporous anodized aluminum oxide (AAO) as the mold insert. Atomic layer deposition (ALD) of molybdenum nitride film was used to control the pore diameters of the AAO inserts.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!