Background: Within the construction industry the risk of lung disorders depends on the specific professions probably due to variations in the levels of dust exposure, and with dust levels depending on the work task and job function. We do not know the extent of exposure in the different professions or the variation between the different work tasks. The purpose of this study was therefore to assess if there were differences in dust exposure between carpenters and demolition workers who were expected to have low and high dust exposure, respectively.
Methods: Through interviews of key persons in the construction industry the most common work tasks were selected, and the concentration of dust during these tasks (indoors) were measured by personal sampling varying between 4 and 6 h of a working day. In total 38 measurements of total dust, and 25 of respirable dust on seven different work tasks were carried out for carpenters and 20 measurements of total dust, 11 of respirable dust and 11 of respirable crystalline silica dust on four different works tasks for demolition workers. Dust measurements were tested for differences using linear regression, t-test and one-way ANOVA.
Results: For carpenters the geometric mean for all the measurements of total dust was 1.26 mg/m(3) (geometric standard deviation 2.90) and the respirable dust was 0.27 mg/m(3) (geometric standard deviation 2.13). For demolition workers the geometric mean of total dust for all the measurements was 22.3 mg/m(3) (geometric standard deviation 11.6) and the respirable dust was 1.06 mg/m(3) (geometric standard deviation 5.64). The mean difference between total dust for demolition workers and carpenters was 11.4 (95 % confidence interval 3.46-37.1) mg/m(3). The mean difference between respirable dust for demolition workers and carpenters was 3.90 (95 % confidence interval 1.13-13.5) mg/m(3). Dust exposure varied depending on work task for both professions. The dustiest work occurred during demolition, especially when it was done manually. Only few workers used personal respiratory protection and only while performing the dustiest work.
Conclusions: This study confirmed that the exposure to dust and especially total dust was much higher for demolition workers compared to carpenters.
Trial Registration: (ISRCTN registry): The study is not a clinical trial and are thus not registered.
Download full-text PDF |
Source |
---|---|
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC5028992 | PMC |
http://dx.doi.org/10.1186/s12995-016-0134-5 | DOI Listing |
Environ Int
November 2024
The National Research Centre for the Working Environment, Lersø Parkallé 105, 2100 Copenhagen Ø, Denmark.
Several buildings in a Danish social housing estate exceeded indoor air guidance values for polychlorinated biphenyls (PCBs), leading to their demolition. Here, we conducted a biomonitoring study among the workers on-site (n = 24) to evaluate their exposure to all 209 PCBs across the two-year demolition. We compared their PCB serum concentrations and accumulation to those of demolition workers at other worksites (n = 21) and office workers (n = 17).
View Article and Find Full Text PDFAnn Work Expo Health
January 2025
STAMI, National Institute of Occupational Health, Gydas Vei 8, 0363 Oslo, Norway.
Increased focus on renovating and maintaining the existing building stock is an integral part of the circular economy, however this might pose challenges to workers health. The aim of this study was to assess the renovation workers' exposure to inhalable dust, thoracic dust, respirable dust, and respirable crystalline silica (RCS). Personal aerosol samples were collected as full shift samples from 92 workers to a total of 407 samples.
View Article and Find Full Text PDFJ Safety Res
September 2024
Myers Lawson School of Construction, Virginia Tech, Blacksburg, VA 24060, USA. Electronic address:
Introduction: Several studies have assessed and validated the impact of exoskeletons on back and shoulder muscle activation; however, limited research has explored the role that exoskeletons could play in mitigating lower arm-related disorders. This study assessed the impact of Ironhand, an active hand exoskeleton (H-EXO) designed to reduce grip force exertion, on worker exertion levels using a two-phase experimental design.
Method: Ten male participants performed a controlled, simulated drilling activity, while three male participants completed an uncontrolled concrete demolition activity.
Cochrane Database Syst Rev
May 2024
Radboud Institute for Health Sciences, Radboudumc, Nijmegen, Netherlands.
Background: Asbestos exposure can lead to asbestos-related diseases. The European Union (EU) has adopted regulations for workplaces where asbestos is present. The EU occupational exposure limit (OEL) for asbestos is 0.
View Article and Find Full Text PDFPathologie (Heidelb)
September 2024
Institut für Pathologie, Ruhr-Universität Bochum am berufsgenossenschaftlichen Universitätsklinikum Bergmannsheil, Bürkle-de-la-Camp-Platz 1, 44789, Bochum, Deutschland.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!