A porous polyurea (PPU) was prepared through a simple protocol by reacting toluene diisocyanate with water in binary solvent of water-acetone. Its amine group was determined through spectrophotometric absorbance based on its iminization with p-nitrobenzaldehyde amines. PPU was then used as a novel polymer support for enzyme immobilization, through activation by glutaraldehyde followed by immobilization of an enzyme, lipase from Pseudomonas fluorescens (PFL), via covalent bonding with the amine groups of lipase molecules. Influences of glutaraldehyde and enzyme concentration and pH in the process were studied. The results revealed that the activity of the immobilized PFL reached a maximum at GA concentration of 0.17 mol/L and at pH 8. Immobilization rate of 60% or higher for PFL was obtained under optimized condition with an enzyme activity of 283 U/mg. The porous structure of PPU, prior to and after GA activation and PFL immobilization, was characterized. The activity of the immobilized PFL at different temperature and pH and its stability at 40 °C as well as its reusability were tested. The immobilized enzyme was finally used as enantioselective catalyst in kinetic resolution of racemic 1-phenylethanol (1-PEOH), and its performance compared with the free PFL. The results demonstrate that the enzyme activity and stability were greatly improved for the immobilized PFL, and highly pure enantiomers from racemic 1-PEOH were effectively achieved using the immobilized PFL. Noticeable deactivation of PFL in the resolution was observed by acetaldehyde in situ formed. In addition, the immobilized PFL was readily recovered from the reaction system for reuse. A total of 73% of the initial activity was retained after 5 repeated reuse cycles. This work provides a novel route to preparation of a polyurea porous material and its enzyme immobilization, leading to a novel type of immobilized enzyme for efficient kinetic resolution of racemic molecules.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.6b07979DOI Listing

Publication Analysis

Top Keywords

immobilized pfl
20
kinetic resolution
12
resolution racemic
12
pfl
10
lipase pseudomonas
8
pseudomonas fluorescens
8
porous polyurea
8
racemic 1-phenylethanol
8
enzyme
8
enzyme immobilization
8

Similar Publications

In this study, hybrid skeleton material ZIF-8@ZIF-67 was synthesized by the epitaxial growth method and then was utilized as a carrier for encapsulating lipase (PFL) through the co-precipitation method, resulting in the preparation of immobilized lipase (PFL@ZIF-8@ZIF-67). Subsequently, it was further treated with glutaraldehyde to improve protein immobilization yield. Under optimal immobilization conditions, the specific hydrolytic activity of PFL@ZIF-8@ZIF-67 was 20.

View Article and Find Full Text PDF

PEG-modified lipase immobilized onto NH-MIL-53 MOF for efficient resolution of 4-fluoromandelic acid enantiomers.

Int J Biol Macromol

December 2020

Department of Chemistry and Chemical Engineering, Hunan Institute of Science and Technology, Yueyang 414006, Hunan, China. Electronic address:

A new heterogeneous bio-catalyst was prepared by the immobilization of lipase from Pseudomonas fluorescents (PFL) onto metal-organic frameworks (MOF), NH-MIL-53(Fe), using covalent cross-linking. The immobilized lipase [PEG-PFL@NH-MIL-53(Fe)] was firstly applied in enantioselective resolution of 4-fluoromandelic acid (4-FMA) enantiomers. After optimization of the immobilization PFL onto NH-MIL-53, its loading capacity is 224.

View Article and Find Full Text PDF

Effects of Enzyme Loading and Immobilization Conditions on the Catalytic Features of Lipase From Immobilized on Octyl-Agarose Beads.

Front Bioeng Biotechnol

February 2020

Departamento de Biocatálisis, Instituto de Catálisis y Petroleoquímica - CSIC, Campus Universidad Autónoma de Madrid - CSIC Cantoblanco, Madrid, Spain.

The lipase from (PFL) has been immobilized on octyl-agarose beads under 16 different conditions (varying pH, ionic strength, buffer, adding some additives) at two different loadings, 1 and 60 mg of enzyme/g of support with the objective of check if this can alter the biocatalyst features. The activity of the biocatalysts versus -nitrophenyl butyrate and triacetin and their thermal stability were studied. The different immobilization conditions produced biocatalysts with very different features.

View Article and Find Full Text PDF

Lipase Immobilized on a Novel Rigid-Flexible Dendrimer-Grafted Hierarchically Porous Magnetic Microspheres for Effective Resolution of (,)-1-Phenylethanol.

ACS Appl Mater Interfaces

January 2020

Key Laboratory of Molecular Biophysics of the Ministry of Education, College of Life Science and Technology , Huazhong University of Science and Technology, Wuhan 430074 , China.

With the rapid development of biotechnological industry, there is an urgent need for exploiting new materials to immobilize enzymes to improve the performance of biocatalysts. In this paper, hierarchically porous magnetic microspheres (PFMMs) were prepared through solvothermal method and rapidly grafted with a novel rigid-flexible dendrimer first synthesized from monomers of trimesoyl chloride (TMC) and 1,6-hexanediamine (HDA) via interfacial polymerization process for covalent immobilization of lipase (PFL). The maximum PFL loading of the synthesized support reaches 87.

View Article and Find Full Text PDF

Further stabilization of lipase from Pseudomonas fluorescens immobilized on octyl coated nanoparticles via chemical modification with bifunctional agents.

Int J Biol Macromol

December 2019

Departamento de Engenharia Química, Universidade Federal do Ceará, Campus do Pici, Bloco 709, 60455-760 Fortaleza, CE, Brazil. Electronic address:

The lipase from Pseudomonas fluorescens (PFL) was adsorbed on superparamagnetic NiZnFeO octyl-nanoparticles via interfacial activation, producing the biocatalyst OCTYL-NANO-PFL. In order to further improve the stability of the immobilized lipase, the immobilized enzyme biocatalyst was chemically modified with different concentrations of diverse bifunctional molecules (glutaraldehyde (GA), divinylsulfone (DVS) or p-benzoquinone (BQ)). The concentrations of bifunctional agents were varied (0.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!