Water dispersible, highly efficient nickel doped CdS nanoparticles anchored on graphene nanosheets as a photocatalyst for cephalexin and sulfamethoxazole photodegradation have been prepared in a facile microwave-furnace assisted method. Each one of the two modifications has played a critical role in nanocomposite functioning. Defects originated by dopant boosted the lifetime of carriers and thereupon graphene matrix transferred them to contribute effectively the photocatalytic process. Characterization results revealed the formation of monocrystalline hexagonal phase of all products and that both doping and loading on graphene have red-shifted the absorption edge of CdS towards the visible light region. Furthermore, FTIR confirmed the successful reduction of graphene oxide by the subsequent preparation steps. Adsorption isotherms revealed the role of graphene in enhancing substrate adsorption. Nevertheless, dissimilar pathways of catalytic degradation were observed on the doped composite as cephalexin oxidation was principally mediated by the hole-hydroxyl radical mechanism, sulfamethoxazole oxidation favored the superoxide radical mechanism. This composite has shown, however, a high photostability and minimized ions release of the composite.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.jhazmat.2016.08.043 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
We report the radiation-induced darkening (RD) effect caused by X-ray radiation and the bleaching effect caused by D/H/N loading in self-developed Yb-doped large mode-area photonic crystal fibers (LMA PCFs). The decrease in the slope efficiency caused by irradiation decays exponentially with an increase in the X-ray radiation doses, and the radiation-induced gain variation (RIGV) showed a linear decay trend with increasing irradiation doses. The slope efficiency of Yb-doped LMA PCF, which significantly degraded from 71.
View Article and Find Full Text PDFCollagen silver-doped hydroxyapatite scaffolds reinforced with 3D printed frameworks for infection prevention and enhanced repair of load-bearing bone defects.
Biofabrication
January 2025
Department of Anatomy and Regenerative Medicine, RCSI University of Medicine and Health Sciences, 123 St Stephen's Green, Dublin, DO2 YN77, IRELAND.
Osteomyelitis, a severe bone infection, is an extremely challenging complication in the repair of traumatic bone defects. Furthermore, the use of long-term high-dose antibiotics in standard treatment increases the risks of antibiotic resistance. Herein, an antibiotic-free, collagen silver-doped hydroxyapatite (coll-AgHA) scaffold reinforced with a 3D printed polycaprolactone (PCL) framework was developed with enhanced mechanical properties to be used in the repair of load-bearing defects with antimicrobial properties as a preventative measure against osteomyelitis.
View Article and Find Full Text PDFDual oxygen supply system of carbon dot-loaded microbubbles with acoustic cavitation for enhanced sonodynamic therapy in diabetic wound healing.
Biomaterials
January 2025
Department of Ultrasound in Medicine, The Second Affiliated Hospital of Zhejiang University School of Medicine, No. 88 Jiefang Road, Shangcheng District, Hangzhou, 310009, PR China; Research Center of Ultrasound in Medicine and Biomedical Engineering, The Second Affiliated Hospital of Zhejiang University School of Medicine, No. 88 Jiefang Road, Shangcheng District, Hangzhou, 310009, PR China; Research Center for Life Science and Human Health, Binjiang Institute of Zhejiang University, No. 66 Dongxin Avenue, Binjiang District, Hangzhou, 310053, PR China. Electronic address:
Diabetic wounds present significant treatment challenges due to their complex microenvironment, marked by persistent inflammation from bacterial infections, hypoxia caused by diabetic microangiopathy, and biofilm colonization. Sonodynamic therapy (SDT) offers potential for treating such wounds by targeting deep tissues with antibacterial effects, but its efficacy is limited by hypoxic conditions and biofilm barriers. To overcome these obstacles, we developed a novel approach using oxygen-carrying microbubbles loaded with Mn-doped carbon dots (MnCDs@OMBs) to enhance SDT and disrupt biofilms.
View Article and Find Full Text PDFPreparation of a 6FDA-DAM/ODA Mixed Matrix Membrane Doped with MOFs and Its Application in Gas Separation.
ACS Appl Mater Interfaces
January 2025
State Key Laboratory of Materials-Oriented Chemical Engineering, College of Chemical Engineering, Nanjing Tech University, Nanjing 210009, China.
Mixed matrix membranes (MMMs) can significantly improve gas separation performance, but the type and state of the filler in the membrane matrix are key indicators for the development of MMMs. Therefore, in this work, 6FDA-DAM/ODA (1:1), metal-organic frameworks (MOFs) with different particle sizes (UiO-66 and UiO-66-NH) were synthesized, and then MOFs were doped into 6FDA-DAM/ODA to prepare MMMs. The effects of the dopant materials and their particle sizes on the gas separation performance of the membranes were investigated by testing the permeability of the MMMs to H, CO, CH, and N.
View Article and Find Full Text PDFLow Pt Loading on Wolframite-Type NiWO to Excel the Electrocatalytic Water Splitting and Ammonia Oxidation Reaction.
ACS Appl Mater Interfaces
January 2025
Department of Chemistry, Indian Institute of Technology Delhi, Hauz Khas, New Delhi 110016, India.
Hydrogen production via water-splitting or ammonia electrolysis using transition metal-based electrodes is one of the most cost-effective approaches. Herein, ca. 1-4% of Pt atoms are stuffed into a wolframite-type NiWO lattice to improve the electrocatalytic efficiency.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!