Characterization of wood mulch and leachate/runoff from three wood recycling facilities.

J Environ Manage

Department of Environmental Sciences, Rutgers, The State University of New Jersey, 14 College Farm Road, New Brunswick, NJ 08901-8551, USA.

Published: November 2016

Large-scale open storage of wood mulch is common practice at wood recycling facilities. During rain and snow melt, leachate with soluble compounds and suspended particles is released from mulch stockpiles. The objective of this study was to determine the quality of leachate/runoff from wood recycling facilities to evaluate its potential to contaminate receiving waterbodies. Wood mulch (n = 30) and leachate/runoff (n = 26) samples were collected over 1.5 years from three wood recycling facilities in New Jersey, USA. Differences by site were found (p < 0.05) for most of the 21 constituents tested in the solid wood mulch samples. Biochemical oxygen demand (range <20-3000 mg/L), chemical oxygen demand (134-6000 mg/L) and total suspended solids (69-401 mg/L) median concentrations of the leachate/runoff samples were comparable to those of untreated domestic wastewater. Total Kjeldahl N, total P and fecal coliform median values were slightly lower than typical wastewater values. Dose-response studies with leachate/runoff samples using zebrafish (Danio rerio) embryos showed that mortality and developmental defects typically did not occur even at the highest concentration tested, indicating low toxicity, although delayed development did occur. Based on this study, leachate/runoff from wood recycling facilities should not be released to surface waters as it is a potential source of organic contamination and low levels of nutrients. A study in which runoff from a controlled drainage area containing wood mulch of known properties is monitored would allow for better assessment of the potential impact of stormwater runoff from wood recycling facilities.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.jenvman.2016.07.093DOI Listing

Publication Analysis

Top Keywords

wood recycling
16
recycling facilities
16
wood mulch
12
three wood
8
wood
6
characterization wood
4
mulch
4
mulch leachate/runoff
4
leachate/runoff three
4
recycling
4

Similar Publications

Extraction of Natural-Based Raw Materials Towards the Production of Sustainable Man-Made Organic Fibres.

Polymers (Basel)

December 2024

Fibrenamics, Institute of Innovation on Fiber-Based Materials and Composites, University of Minho, 4800-058 Guimarães, Portugal.

Bioresources have been gaining popularity due to their abundance, renewability, and recyclability. Nevertheless, given their diverse composition and complex hierarchical structures, these bio-based sources must be carefully processed to effectively extract valuable raw polymeric materials suitable for producing man-made organic fibres. This review will first highlight the most relevant bio-based sources, with a particular focus on promising unconventional biomass sources (terrestrial vegetables, aquatic vegetables, fungi, and insects), as well as agroforestry and industrial biowaste (food, paper/wood, and textile).

View Article and Find Full Text PDF

The glass fiber-reinforced polymer (GFRP) materials of wind turbine blades can be recovered and recycled by crushing, thereby solving one of the most perplexing problems facing the wind energy sector. This process yields selectively crushed wind turbine blade (SCWTB), a novel waste that is almost exclusively composed of GFRP composite fibers that can be revalued in terms of their use as a raw material in concrete production. In this research, the fresh and mechanical performance of concrete made with 1.

View Article and Find Full Text PDF

The aim of this work was to synthesize polyurethane foams based on petrochemical polyols and biopolyols with specific apparent densities (40, 60, 80, 100, and 120 kg/m), test their properties, glycolyze them, and finally analyze each glycolyzed product. The petroleum-based foams, used as reference foams, and the bio-based foams underwent a series of standard tests to define their properties (the content of closed cells 20-95%, compressive strength 73-1323 kPa, thermal conductivity 24-42 mW/m∙K, brittleness 4.6-82.

View Article and Find Full Text PDF

Construction materials are significantly exposed to ecological hazards due to the presence of hazardous chemical constituents found in industrial and agricultural solid wastes. This study aims to investigate the use of sawdust particles (SDPs) and sawdust wastewater (SDW) in alkali-activated composites (AACs) made from a mixture of different silicon-aluminum-based solid wastes (slag powder-SP, red mud-RM, fly ash-FA, and carbide slag-CS). The study examines the impact of SDP content, treated duration of SDPs, and SDW content on both fresh and hardened properties of the AACs, including electrical conductivity, fluidity, density, flexural and compressive strengths, and drying shrinkage.

View Article and Find Full Text PDF
Article Synopsis
  • This study explores how incorporating cotton and polyester fibers into polypropylene (PP) composites can improve their mechanical, thermal, and rheological properties, aiming for durable materials.
  • The research finds that a balanced mix of cotton and polyester fibers maximizes tensile strength and stiffness, with different coupling agents influencing fiber-matrix adhesion and overall performance.
  • The use of recycled textile fibers not only bolsters thermal resistance and structural stability but also presents a sustainable solution that supports the circular economy by repurposing textile waste in composite manufacturing.
View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!