A novel strategy for the preparation of Si-doped hydroxyapatite (Si-HA) coatings on H2O2-treated carbon/carbon composites (C/C) was developed. HA coating was prepared on C/C through chemical liquid vaporization deposition (CLVD)/hydrothermal treatment. HA coating was immersed in an H2SiO3 solution at an autoclave at 413 K for transformation into Si-HA coating. The effects of H2SiO3 mass contents on the phase, morphology, and composition of the Si-HA coatings were studied through SEM, EDS,XRD, and FTIR. Their bonding performance to C/C was measured through a scratch test. Under the optimal content condition, the in vitro skull osteoblast response behaviors of the Si-HA coating were evaluated. Results showed that SiO3(2-) could enter into the HA lattice and occupy the PO4(3-) sites. Doped SiO3(2-) significantly improved the bonding performance of the HA coating to C/C in comparison with the untreated HA. The adhesive strength of the coatings initially increased and then decreased with increasing H2SiO3 content. Meanwhile, the cohesive strength of the Si-HA coatings was almost nearly identical. The Si-HA coating achieved at a content of 90% H2SiO3 exhibited the best bonding performance, and its osteoblast compatibility in vitro was superior to that of the untreated HA coating on C/C through CLVD/hydrothermal treatment.
Download full-text PDF |
Source |
|---|---|
| http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4974567 | PMC |
| http://dx.doi.org/10.1038/srep31309 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Effect of Physicochemical Surface Properties of Silicon-Substituted Hydroxyapatite on Angiogenesis.
Tissue Eng Part C Methods
September 2024
Department of Materials Science and Metallurgy, University of Cambridge, Cambridge, United Kingdom.
Synthetic hydroxyapatite (HA) is a widely studied bioceramic for bone tissue engineering (BTE) due to its similarity to the mineral component of bone. As bone mineral contains various ionic substitutions that play a crucial role in bone metabolism, the bioactivity of HA can be improved by adding small amounts of physiologically relevant ions into its crystal structure, with silicate-substituted HA (Si-HA) showing particularly promising results. Nevertheless, it remains unclear how distinct material characteristics influence the bioactivity due to the intertwined nature of surface properties.
View Article and Find Full Text PDFSi substituted hydroxyapatite nanorods on Ti for percutaneous implants.
Bioact Mater
March 2020
State-key Laboratory for Mechanical Behavior of Materials, Xi'an Jiaotong University, Xi'an, 710049, China.
An ideal intraosseous transcutaneous implant should form a tight seal with soft tissue, besides a requirement of osseointegration at the bone-fixed position. Si substituted hydroxyapatite (Si-HA) nanorods releasing Si ion and simulating nanotopography of natural tissue were designed on Ti to enhance fibroblast response and biosealing with soft tissue . Si-HA nanorods were fabricated by alkali-heat treatment followed with hydrothermal treatment.
View Article and Find Full Text PDFRapid Fabrication, Microstructure, and Investigations of a High-Performance Multilayer Coating with External, Flexible, and Silicon-Doped Hydroxyapatite Nanorods on Titanium.
ACS Biomater Sci Eng
September 2019
Institute for Advanced Ceramics, Department of Materials Science and Engineering, Harbin Institute of Technology, Harbin 150001, China.
A high-performance multilayer coating with external, flexible, and silicon-doped hydroxyapatite (Si-HA) nanorods was designed using bionics. Plasma electrolytic oxidation (PEO) and the microwave hydrothermal (MH) method were used to rapidly deposit this multilayer coating on a titanium (Ti) substrate, applied for 5 and 10 min, respectively. The bioactive multilayer coating was composed of four layers, and the outermost layer was an external growth layer that consisted of many Si-HA nanorods with a single-crystal structure.
View Article and Find Full Text PDFCharacterizations of Si and Zn Doped Plasma Sprayed Hydroxyapatite Coatings Using Osteoblast and Osteoclast Coculture.
ACS Biomater Sci Eng
March 2019
W. M. Keck Biomedical Materials Research Laboratory School of Mechanical and Materials Engineering Washington State University, 980 E College Avenue, Pullman, Washington 99164-2920, United States.
Osteoporosis is one of the most commonly identified bone disorders, which leads to an enhanced risk of bone fracture, especially for the older population. Hydroxyapatite (HA) coated titanium (Ti) alloys have been used widespread for load bearing applications like hip or knee replacements owing to their compositional similarity to natural bone; however, incorporation of osteoinductivity is still a challenge. The objective of this study is to evaluate the effects of SiO and ZnO as dopants in HA coated Ti alloys on cellular osteoporotic conditions mimicked by an osteoblast and osteoclast coculture model.
View Article and Find Full Text PDFFunctional Elements Coatings on the Plasma Electrolytic Oxidation-Treated Ti-6Al-4V Alloy by Electrochemical Precipitation Method.
J Nanosci Nanotechnol
July 2019
Department of Dental Materials and Research Center of Nano-Interface Activation for Biomaterials, College of Dentistry, Chosun University, Gwangju, 61452, Korea.
In this study, functional elements coatings on the plasma electrolytic oxidation (PEO)-treated Ti-6Al-4V alloy by electrochemical precipitation method were investigated. Ti-6Al-4V ELI disks were used as specimens for PEO and HA coating. The applied voltage and time were selected to be 280 V and 3 minutes for PEO treatment, respectively.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!