We have previously reported that administration of atropine (A) to unrestrained, sedentary, heat-stressed rats resulted in a dose-dependent increase in heating rate (rate of rise of core temperature, degree C/min). Additionally, we have demonstrated that the decrements in treadmill endurance and increments in heating rate of physostigmine (PH)-treated running rats can both be restored to control levels by pretreating the animals with A and diazepam (D). Our objective in the present work was to determine if the administration of D + PH to A-treated unrestrained, sedentary, heat-stressed rats (N = 16/group, 510-530 g) could improve their thermal tolerance. The following drugs were administered singly (at 10 min intervals) via lateral tail vein: vehicle-control (C), A (200 micrograms/kg), D (500 micrograms/kg), and PH (200 micrograms/kg). After drug administration, the rats were heat-stressed (Tamb = 41.5 degrees C) until a core temperature of 42.6 degrees C was attained when they were removed to a 26 degrees C chamber. The heating rates (degrees C/min) and tolerance times (min) of the respective groups were: C- 0.02, 235; A- 0.08, 58; A D- 0.06, 94; and A + D + PH- 0.04, 143. Administration of D with A significantly decreased heating rate, and D + PH more than doubled the thermal tolerance of A-treated rats. Thus, the combination of A + D + PH not only restores PH-induced performance and thermoregulatory decrements of rats exercised in a moderate environment, but also reduces A-induced heat intolerance.

Download full-text PDF

Source
http://dx.doi.org/10.1016/0024-3205(89)90404-9DOI Listing

Publication Analysis

Top Keywords

heating rate
12
unrestrained sedentary
8
sedentary heat-stressed
8
heat-stressed rats
8
core temperature
8
thermal tolerance
8
200 micrograms/kg
8
rats
6
atropine diazepam
4
diazepam physostigmine
4

Similar Publications

Dietary supplements are widely used among individuals exposed to hot environments, but whether their consumption confers any thermoregulatory effect is unclear. Therefore, we systematically evaluated the effect of dietary supplementation on key aspects of thermoregulation (core temperature [T] and sweating responses) in the heat. Three databases were searched in April 2024.

View Article and Find Full Text PDF

The effect of sub-boiling temperatures on mass transfer from former manufactured gas plant residuals.

J Contam Hydrol

January 2025

BCEG Environmental Remediation Co., Ltd., Beijing 100015, China; National Engineering Laboratory for Site Remediation Technologies, Beijing 100015, China.

The dissolution of polycyclic aromatic hydrocarbons (PAHs) from coal tar at former manufactured gas plant (FMGP) sites is a long-term threat to groundwater quality. The dissolution rate is often limited by an increase in the viscosity of the non-aqueous phase liquid (NAPL) as the lower molecular weight compounds are depleted over time, and this slow mass transfer prevents the effective application of remediation technologies that rely on NAPL-to-water mass transfer to remove or degrade mass. Increasing subsurface temperatures has the potential to increase mass transfer at FMGP sites by increasing PAH solubility and reducing NAPL viscosity.

View Article and Find Full Text PDF

This research addresses the gap in efficient thawing methods by investigating the effects of ohmic thawing variables and freezing methods on the thawing speed and quality attributes of ground turkey breast, aiming to identify the optimal ohmic thawing method and compare it with traditional air and water thawing techniques. The variables for ohmic thawing consisted of voltage gradient (10, 15, and 20 V/cm), freezing method (Snap (rapid freezing of samples in liquid nitrogen at -210 °C), -70, and -20 °C), and probe type. The results showed that the snap-freezing method demonstrated superior functional and quality characteristics.

View Article and Find Full Text PDF

Investigating Fast Scanning Calorimetry and Differential Scanning Calorimetry as Screening Tools for Thermoset Polymer Material Compatibility with Laser-Based Powder Bed Fusion.

ACS Appl Polym Mater

January 2025

Advanced Engineering Division, Savannah River National Laboratory, Savannah River Site, Aiken, South Carolina 29808, United States.

As additive manufacturing (AM) technology has developed and progressed, a constant topic of research in the area is expanding the library of materials to be used with these techniques. Among AM methods that utilize polymers, laser-based powder bed fusion (PBF-LB) has preferentially used thermoplastic polymers as its starting materials, but the deposition and material joining method employed in PBF-LB may also be compatible with powdered thermoset polymer precursors as feedstocks. To assess the compatibility of candidate thermosetting polymers and PBF-LB, characterization techniques and protocols that link fundamental material behavior to material behavior in the processing environment are needed.

View Article and Find Full Text PDF

Hydrogen production by suspension self-rotation enhanced pyrolysis of sludge particles in cyclone.

Water Res

January 2025

National Engineering Research Center of Industrial Wastewater Detoxication and Resource Recovery, East China University of Science and Technology, Shanghai, 200237, China. Electronic address:

The challenges faced by sludge pyrolysis units, including poor heat transfer efficiency and uneven heating of material groups, significantly hinder the green and low-carbon transformation and sustainable development of sludge treatment. The suspension self-rotation of sludge particles in a cyclone enhances particle heat transfer, thereby improving the pyrolysis process. In this study, we developed a novel method for sludge pyrolysis using Cyclone Suspension Self-Rotation Pyrolysis Reactor (CSSPR).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!