Rare earth elements (REEs) are essential raw materials for emerging renewable energy resources and 'smart' electronic devices. Global REE demand is slated to grow at an annual rate of 5% by 2020. This high growth rate will require a steady supply base of REEs in the long run. At present, China is responsible for 85% of global rare earth oxide (REO) production. To overcome this monopolistic supply situation, new strategies and investments are necessary to satisfy domestic supply demands. Concurrently, environmental, economic, and social problems arising from REE mining must be addressed. There is an urgent need to develop efficient REE recycling techniques from end-of-life products, technologies to minimize the amount of REEs required per unit device, and methods to recover them from fly ash or fossil fuel-burning wastes.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1016/j.envres.2016.05.052 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Eu-ion doped strontium molybdate perovskite quantum dots as a turn-off-on fluorescent sensor for simultaneous detection of hypoxanthine biomarker and Fe ions.
Mikrochim Acta
January 2025
Department of Chemistry, Sardar Vallabhbhai National Institute of Technology, Surat, Gujarat, 395 007, India.
A fluorescence "turn-off-on" nanoprobe is designed by using europium-doped strontium molybdate perovskite quantum dots (Eu:SMO PQDs) for the sequential detection of hypoxanthine (Hx) and Fe. The Eu:SMO PQDs were prepared by the sol-gel method using Sr(NO), (NH)MoO.4HO, and Eu(OCOCH) as precursors.
View Article and Find Full Text PDFStrategically Engineered Metal Cluster-Rare Earth Oxide Heterojunction Catalyst for High-Performance Lean Electrolyte Lithium-Sulfur Batteries.
ACS Appl Mater Interfaces
January 2025
Key Laboratory of Carbon Materials of Zhejiang Province, Wenzhou University, Wenzhou 325035, China.
Developing high-energy-density lithium-sulfur batteries faces serious polysulfide shuttle effects and sluggish conversion kinetics, often necessitating the excessive use of electrolytes, which in turn adversely affects battery performance. Our study introduces a meticulously designed electrocatalyst, Cu-CeO@N/C, to enhance lean-electrolyte lithium-sulfur battery performance. This catalyst, featuring in situ synthesized Cu clusters, regulates oxygen vacancies in CeO and forms Cu-CeO heterojunctions, thereby diminishing sulfur conversion barriers and hastening reaction kinetics through the generation of S/S intermediates.
View Article and Find Full Text PDFComparative Study on Combined Addition of Gd-Ce and Gd-Y on the Mechanical Properties and Electrochemical Behavior of Mg-Zn-Mn-Ca Alloys.
Materials (Basel)
January 2025
School of Materials Science and Engineering, Guangdong Ocean University (Yangjiang Campus), Yangjiang 529500, China.
This study presents a comparative analysis of the influence of Ce-Gd and Gd-Y additions on the microstructural evolution, mechanical properties, and electrochemical behavior of extruded Mg-3Zn-Mn-Ca alloy rods. Despite the frequent incorporation of Gd, Y, and Ce as alloying elements in magnesium alloys, the systematic examination of their combined effects on Mg-Zn alloys has been limited. Our findings reveal that both Gd-Ce and Gd-Y additions significantly enhance the mechanical properties of Mg-3Zn-Mn-Ca alloy, although through differing mechanisms.
View Article and Find Full Text PDFGreenhouse Gas Emissions from Molten Fluoride Electrolysis Composed of Raw and Magnet Recycling Derived Oxides: A Comparative Study.
Materials (Basel)
January 2025
Institute of Chemistry, Technology and Metallurgy, National Institute of the Republic of Serbia, University of Belgrade, Njegoševa 12, 11000 Belgrade, Serbia.
In situ measurements of the chemical identity and quantity of anode gases during electrochemical measurements and rare earth (RE) electrolysis from fluoride-based molten salts composed of different kinds of rare earth oxides (REOs) were performed using FTIR spectrometry. Linear sweep voltammetry (LSV) was carried out to characterize oxidation processes and determine the anodic effect from NdF + PrF + LiF + REO melt. RE complex formation and subsequent reactions on the GC anode surface were discussed to understand the formation pathways of CO/CO and perfluorocarbon gases (PFC), mainly CF and CF.
View Article and Find Full Text PDFImpact of Ce Doping on the Relaxor Behavior and Electrical Properties of SrBaNbO Ferroelectric Ceramics.
Materials (Basel)
December 2024
School of Physics and Electronic Information, Yan'an University, Yan'an 716000, China.
In this work, the rare earth element Ce was incorporated into the A-site of SrBaNbO ferroelectric ceramics, which was prepared using the conventional solid state reaction method and sintered under different procedures. A comprehensive investigation was conducted to assess the impact of Ce doping and varying sintering procedures on both the relaxor characteristics and electrical properties of the ceramics. When sintered at 1300 °C for 4 h, the grains exhibited an isometric shape.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!