This study applied a classic method involving Raman spectroscopy and the use of Stokes and anti-Stokes peaks to measure the temperature of TiO2 thin films found in dye-sensitized solar cells (DSSCs). In addition, three mathematical formulae were used and analyzed to estimate the increase in temperature generated solely by the effect of the radiation. The tests and calculations performed showed an increase in the temperature of the TiO2 film. That is, the films were heated by the radiation they were exposed to. A temperature increase of up to 30 K was detected for the sample with a single layer of TiO2, and over 40 K for the sample with three layers for the highest radiation powers used, and greater increases in temperature were observed in the thicker films.

Download full-text PDF

Source
http://dx.doi.org/10.1177/0003702816652323DOI Listing

Publication Analysis

Top Keywords

tio2 thin
8
thin films
8
temperature tio2
8
increase temperature
8
temperature
6
micro-raman spectroscopy
4
spectroscopy determination
4
determination local
4
local temperature
4
temperature increases
4

Similar Publications

High-Performance Hydrogen Sensing at Room Temperature via Nb-Doped Titanium Oxide Thin Films Fabricated by Micro-Arc Oxidation.

Nanomaterials (Basel)

January 2025

Guangdong Key Laboratory of Materials and Equipment in Harsh Marine Environment, School of Ocean Engineering, Guangzhou Maritime University, Guangzhou 510725, China.

Metal oxide semiconductor (MOS) hydrogen sensors offer advantages, such as high sensitivity and fast response, but their challenges remain in achieving low-cost fabrication and stable operation at room temperature. This study investigates Nb-doped TiO (NTO) thin films prepared via a one-step micro-arc oxidation (MAO) with the addition of NbO nanoparticles into the electrolyte for room-temperature hydrogen sensing. The characterization results revealed that the incorporation of NbO altered the film's morphology and phase composition, increasing the Nb content and forming a homogeneous composite thin film.

View Article and Find Full Text PDF

Mesoporous Fe2O3-TiO2 Integrated with Plasmonic Ag Nanoparticles for Enhanced Solar H2 Production.

Chem Asian J

January 2025

CSIR-National Chemical Laboratory: CSIR National Chemical Laboratory, Catalysis and Inorganic Chemistry Division, Dr. Homi Bhabha Road, 411 008, Pune, INDIA.

Present work describes a sol-gel assisted one-pot synthesis of mesoporous Fe₂O₃-TiO₂ nanocomposites (TiFe) with different Ti:Fe ratios, and fabrication of Ag-integrated with TiFe nanocomposites (TiFeAg) by a chemical reduction method and demonstrated for high solar H2 generation activity in direct sunlight. Enhanced solar H2 production is attributed to the light absorption from entire UV+Visible region of solar spectrum combined with Schottky (Ag-semiconductor) and heterojunctions (TiO2-Fe2O3), as evidenced from HRTEM and various characterization studies.  TiFeAg-2 thin film (1 wt% Ag-loaded TiFe-4) displayed the highest activity with a solar H2 yield of 7.

View Article and Find Full Text PDF

Site-specific plan-view (S)TEM sample preparation from thin films using a dual-beam FIB-SEM.

Ultramicroscopy

January 2025

Department of Chemical Engineering and Materials Science, University of Minnesota, Minneapolis, MN 55455, USA. Electronic address:

To fully evaluate the atomic structure, and associated properties of materials using transmission electron microscopy, examination of samples from three non-collinear orientations is needed. This is particularly challenging for thin films and nanoscale devices built on substrates due to limitations with plan-view sample preparation. In this work, a new method for preparation of high-quality, site-specific, plan-view TEM samples from thin-films grown on substrates, is presented and discussed.

View Article and Find Full Text PDF

Understanding the resistive switching (RS) behavior of oxide-based memory devices at nanoscale is crucial for advancement of high-integration density in-memory computing platforms. This study explores a comprehensive growth parameter space to address the RS behavior of pulsed-laser-deposited substoichiometric TiO (TiO) thin films in search of tailored nanoscale memristors with low-power consumption and high stability. Conductive-atomic-force-microscopy-based measurements facilitate deciphering the switching behavior at nanoscale, providing a direct avenue to understand the microstructure-property relationships.

View Article and Find Full Text PDF

Atomically precise synthesis of graphene nanostructures on semiconductors and insulators has been a formidable challenge. In particular, the metallic substrates needed to catalyze cyclodehydrogenative planarization reactions limit subsequent applications that exploit the electronic and/or magnetic structure of graphene derivatives. Here, we introduce a protocol in which an on-surface reaction is initiated and carried out regardless of the substrate type.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!