Tracheal Diverticula.

Semin Ultrasound CT MR

Department of Radiology, Stanford Hospital and Clinics, Stanford, CA; Department of Nuclear Medicine, Sheba Medical Center, Ramat Gan, Israel; Sackler Faculty of Medicine, Tel Aviv University, Tel Aviv, Israel. Electronic address:

Published: June 2016

Extraluminal paratracheal air bubbles are occasionally seen on computed tomography (CT) studies that include the thoracic inlet (ie, CT of the neck, of the cervical spine, and of the chest). In most cases, these paratracheal air bubbles are tracheal diverticula (TD), sometimes also referred to as tracheal pouch, tracheocele, and tracheogenic cyst. TD are most commonly seen at the right posterolateral aspect of the upper trachea at the level T1-T3. Because of their typical location and appearance, they are easily recognized and should not be confused with pneumomediastinum or other causes of air bubbles in the same region. This article describes the prevalence, possible pathophysiology, and associated complications of TD and illustrates the spectrum of their appearance on CT.

Download full-text PDF

Source
http://dx.doi.org/10.1053/j.sult.2016.04.002DOI Listing

Publication Analysis

Top Keywords

air bubbles
12
tracheal diverticula
8
paratracheal air
8
diverticula extraluminal
4
extraluminal paratracheal
4
bubbles occasionally
4
occasionally computed
4
computed tomography
4
tomography studies
4
studies include
4

Similar Publications

Protein aggregation, a major concern in biopharmaceutical quality control, can be accelerated by various stresses during clinical handling. This study investigated potential aggregation risk factors during dilution process with syringe handling for intravenous administration. Using γ-globulin and IgG solutions as surrogate models of antibody therapeutics, we examined the effects of high sliding speeds and piston operations of the syringe on protein aggregation during saline dilution.

View Article and Find Full Text PDF

Reusable Biosensor for Easy RNA Detection from Unfiltered Saliva.

Sensors (Basel)

January 2025

Department of Clinical and Molecular Biochemistry, Pomeranian Medical University in Szczecin, 72 Powstańców Wlkp. Al., 70-111 Szczecin, Poland.

Biosensors are transforming point-of-care diagnostics by simplifying the detection process and enabling rapid, accurate testing. This study introduces a novel, reusable biosensor designed for direct viral RNA detection from unfiltered saliva, targeting SARS-CoV-2. Unlike conventional methods requiring filtration, our biosensor leverages a unique electrode design that prevents interference from saliva debris, allowing precise measurements.

View Article and Find Full Text PDF

In recent years, liquid-solid triboelectric nanogenerators (L-S TENGs) have been rapidly developed in the field of liquid energy harvesting and self-powered sensing. This is due to a number of advantages inherent in the technology, including the low cost of fabricated materials, structural diversity, high charge-energy conversion efficiency, environmental friendliness, and a wide range of applications. As liquid phase dielectric materials typically used in L-S TENG, a variety of organic and inorganic single-phase liquids, including distilled water, acidic solutions, sodium chloride solutions, acetone, dimethyl sulfoxide, and acetonitrile, as well as paraffinic oils, have been used in experiments.

View Article and Find Full Text PDF

Introduction: With the increasing use of aeromedical transport for critically ill patients, it is essential to understand the impact of pressure changes on drug infusion delivery systems. As airplanes ascend and descend, gases/bubbles are released from solutions when ambient pressure decreases and dissolves when pressure increases. This may affect mechanical fluid delivery systems and cause clinically significant changes, especially within a critical care setting.

View Article and Find Full Text PDF

We report an experimental study on how topological defects induced by cylindrical air inclusions in the ferroelectric nematic liquid crystal RM734 are influenced by ionic doping, including an ionic surfactant and ionic polymer. Our results show that subtle differences in molecular structure can lead to distinct surface alignments and topological defects. The ionic surfactant induces a planar alignment, with two -1/2 line defects adhering to the cylindrical bubble surface.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!