Objective: To study the influence of particle size and morphology on zinc cation adsorption by hydroxyapatite (HA) and dentifrice containing HA.

Methods: Four HAs with different particle sizes and morphologies, HA-containing dentifrice and blank dentifrice were prepared into suspensions of serial concentrations. Zinc ion solutions with an initial concentration of 10 mg/L was mixed with the suspensions and kept for 24 h for adsorption reaction. The zinc ion concentration in the supernatant was measured by inductively coupled plasma emission spectrometer and the sorption rate of zinc ion was calculated.

Results: HA and HA-containing dentifrice with various particle sizes and morphologies were all capable of absorbing zinc ions from simulated waste water, and the adsorption rate of HA-containing dentifrice was 3%-10% higher than that of HA. HA with a particle size of 12 µm and a spherical morphology showed the strongest adsorption ability, followed by short bar-shaped HA with a particle size of 30 µm. Both Langmuir and Freundlich equation could simulate the sorption processes of HA dentifrice, while only Langmuir equation could simulate the sorption processes of HA.

Conclusion: Incorporation of HA in dentifrice can enhance zinc ion adsorption capacity of the material. The particle size and morphology of HA both affect the adsorption of zinc ions, and 12-µm HA particle with a spherical morphology has the best adsorption ability.

Download full-text PDF

Source

Publication Analysis

Top Keywords

particle size
20
zinc ion
16
size morphology
12
ha-containing dentifrice
12
zinc
8
morphology zinc
8
zinc cation
8
adsorption
8
cation adsorption
8
adsorption hydroxyapatite
8

Similar Publications

Rheumatoid arthritis is an autoimmune disorder affecting multiple joints and requires lifelong treatment. Present study was designed to formulate Esculin-loaded chitosan nanoparticles (ENPs) and evaluation of its anti-inflammatory and anti-arthritic action. The acute toxicity study of ENPs was also performed.

View Article and Find Full Text PDF

Continuous Characterization of Insoluble Particles in Ice Cores Using the Single-Particle Extinction and Scattering Method.

Environ Sci Technol

December 2024

Climate and Environmental Physics, Physics Institute, and Oeschger Centre for Climate Change Research, University of Bern, Sidlerstrasse 5, Bern 3012, Switzerland.

This study presents the integration of the single-particle extinction and scattering (SPES) method in a continuous flow analysis (CFA) setup. Continuous measurements with the instrument allow for the characterization of water-insoluble particles in ice cores at high resolution with a minimized risk of contamination. The SPES method can be used to investigate particles smaller than 1 μm, which previously could not be detected by instruments typically used in CFA.

View Article and Find Full Text PDF

Developing novel materials is an essential requirement in the engineering field. This study investigates the effects of incorporating wood dust particles on the mechanical and erosive wear properties of Luffa acutangula fiber (LAF)-reinforced phenol-formaldehyde composites, fabricated using the hand layup method with a constant 20% fiber content and varying wood dust particle contents of 0%, 10%, 20%, and 30%. Using the Taguchi method, the study identifies the optimal combination for minimizing erosive wear - 20% wood dust content, 45 m/s impact velocity, 60° impingement angle, 600 μm erodent size, and 60 mm standoff distance-achieving a minimum erosion rate of 189.

View Article and Find Full Text PDF

To address the challenges of performing in-situ tests on riverbed overburden gravel, this study employs three scaling methods-equal mass substitution, similar gradation, and the mixed method-to investigate the original gradation of the gravel. Large-scale triaxial consolidated drained shear tests were conducted to evaluate the effects of the maximum particle size reduction ratio (M) and confining pressure on the stress-strain behavior, fractal dimension, particle breakage, and the parameters of the Duncan-Chang model (an elastic model describing nonlinear stress-strain relationships). The study explores how scaling, based on fractal dimension and particle breakage rate, impacts the strength and deformation characteristics of gravel materials.

View Article and Find Full Text PDF

Forage sources in total mixed rations on rumen fermentation, gut fill, and development of the gastrointestinal tract of dairy calves.

Sci Rep

December 2024

Department of Animal Science, "Luiz de Queiroz" College of Agriculture, University of São Paulo, Av. Pádua Dias, n 11, Piracicaba, SP, 1341-900, Brazil.

The inclusion of forage sources in calf diets is often discussed, and the main point debated is whether the inclusion level, particle size, source, and how forage is offered may impact gut fill and reduce body weight gain, as well as impact gastrointestinal tract development. This study aimed to determine the effects of feeding forage sources with different qualities on rumen fermentation, gut fill, and development of the gastrointestinal tract of dairy calves. Forty-eight Holstein dairy calves were blocked according to sex and body weight (BW) at 28 days of life and randomly assigned to 1 of 4 dietary treatments.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!