Sandgrouse (Pterocliformes) are quintessential examples of avian adaptation to desert environments, but relatively little is known about the limits to their heat tolerance and evaporative cooling capacity. We predicted that evaporative cooling in Burchell's sandgrouse (Pterocles burchelli) is highly efficient and provides the basis for tolerance of very high air temperature (Ta). We measured body temperature (Tb), resting metabolic rate (RMR) and evaporative water loss (EWL) at Ta between 25°C and ∼58°C in birds exposed to successive increments in Ta Normothermic Tb averaged 39.0°C, lower than typical avian values. At Ta>34.5°C, Tb increased linearly to a maximum of 43.6°C at Ta=56°C. The upper critical limit of thermoneutrality (Tuc) was Ta=43.8°C, closely coinciding with the onset of panting and gular flutter. Above the Tuc, RMR increased 2.5-fold to 2.89 W at Ta=56°C, a fractional increase far exceeding that of many other species under comparable conditions. Rates of EWL increased rapidly at Ta>42.9°C to 7.84±0.90 g h(-1) at Ta=56°C, an 11-fold increase above minimal levels. Maximum evaporative cooling efficiency (ratio of evaporative heat loss to metabolic heat production) was 2.03, but could be as high as 2.70 if our assumption that the birds were metabolising lipids is incorrect. Thermoregulation at very high Ta in P. burchelli was characterised by large increases in RMR and EWL, and is much less efficient than in taxa such as columbids and caprimulgids.

Download full-text PDF

Source
http://dx.doi.org/10.1242/jeb.139733DOI Listing

Publication Analysis

Top Keywords

evaporative cooling
16
cooling capacity
8
burchell's sandgrouse
8
sandgrouse pterocles
8
pterocles burchelli
8
evaporative
6
avian thermoregulation
4
heat
4
thermoregulation heat
4
heat evaporative
4

Similar Publications

Effect of Photolithographic Biomimetic Surface Microstructure on Wettability and Droplet Evaporation Process.

Biomimetics (Basel)

November 2024

Faculty of Engineering, University of Nottingham, University Park, Nottingham NG7 2RD, UK.

In nature, engineering technology and daily life, wetting phenomena are widespread and have essential roles and significance. Bionics is becoming increasingly important nowadays and exploring the mechanism that influences biomimetic surface microstructure on droplet wetting process and heat and mass transfer characteristics is becoming more meaningful. In this paper, based on photolithography technology, SU-8 photoresist was used as raw material to prepare biomimetic surfaces with microstructures in various arrangements.

View Article and Find Full Text PDF

Effective integrated thermal management using hygroscopic hydrogel for photovoltaic-thermoelectric applications.

J Colloid Interface Sci

December 2024

Ministry of Education Key Laboratory for the Green Preparation and Application of Functional Materials, Hubei Key Laboratory of Polymer Materials, Hubei University, Wuhan 430062, China; State Key Laboratory of Solid Lubrication, Lanzhou Institute of Chemical Physics, Chinese Academy of Sciences, Lanzhou 730000, China. Electronic address:

As the proportion of solar energy in the global energy mix increases, photovoltaic cells have emerged as one of the fastest-growing technologies in the renewable energy sector. However, photovoltaics utilize only a limited portion of the incident solar spectrum, resulting in significant amounts of light energy being wasted as heat. This excess heat raises the surface temperature of photovoltaic cells, which in turn reduces their overall efficiency.

View Article and Find Full Text PDF

Designing Leidenfrost Puddles.

Phys Rev Lett

December 2024

Instituto de Física, Benemérita Universidad Autónoma de Puebla, A.P. J-48, Puebla 72570, Mexico.

Leidenfrost puddles exhibit erratic bubble bursts that release vapor trapped beneath the liquid, becoming amorphous and unstable. We report a method to stabilize and design a Leidenfrost puddle. When a thin hydrophilic layer with a suitable design is placed over the liquid, the puddle adopts the layer shape due to adhesive forces and becomes stable.

View Article and Find Full Text PDF

Molecular dynamics of evaporative cooling of water clusters.

Phys Chem Chem Phys

December 2024

Department of Physical Chemistry, University of Chemistry and Technology, Prague Technická 5, 166 28 Praha 6, Czechia.

The cooling of water clusters through evaporation into a vacuum is studied using classical molecular dynamics with the SPC water model, and the results are compared with macroscopic theory. A simple model based on the Hertz-Knudsen equation significantly underestimates cooling rates. A modified approach that accounts for the Kelvin equation provides better results.

View Article and Find Full Text PDF

Exposure to high temperatures during indoor and outdoor activities increases the risk of heat-related illness such as cramps, rashes, and heatstroke (HS). Fatal cases of HS are ten times more common than serious cardiac episodes in sporting scenarios, with untreated cases leading to mortality rates as high as 80%. Enhancing thermal comfort can be achieved through heat loss in enclosed spaces and the human body, utilizing heat transfer mechanisms such as radiation, conduction, convection, and evaporation, which do not require initial energy input.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!