The present paper describes the behaviour of Lachancea thermotolerans and Saccharomyces cerevisiae in pure, co-cultured and sequential fermentations in cv. Emir grape must. Faster fermentation rates were observed in wine made with a pure culture of S. cerevisiae and wine produced with simultaneously inoculated cultures of L. thermotolerans and S. cerevisiae. Both L. thermotolerans and S. cerevisiae gave high population numbers. The use of L. thermotolerans in mixed and sequential cultures led to an increase in final total acidity content in the wines, varying in the range 5.40-6.28 g/l (as tartaric acid), compared to pure culture S. cerevisiae, which gave the lowest level of total acidity (5 g/l). The increase was in the order of 1.18-2.06 g/l total acidity. Increase in final acidity by the use of L. thermotolerans might be useful to improve wines with low acidity due to global climate change. Volatile acidity levels (as acetic acid) were in the range 0.53-0.73 g/l, while the concentration of ethyl alcohol varied in the range 10.76-11.62% v/v. Sequential fermentations of wines and pure culture fermentation of L. thermotolerans resulted in reduction in the concentrations of acetaldehyde and higher alcohols, with exception of N-propanol and esters. According to the sensory analysis, wine obtained with sequential inoculation of L. thermotolerans followed by inoculation of S. cerevisiae after 24 h, and simultaneous inoculation of these yeasts, was the most preferred. Copyright © 2016 John Wiley & Sons, Ltd.

Download full-text PDF

Source
http://dx.doi.org/10.1002/yea.3166DOI Listing

Publication Analysis

Top Keywords

pure culture
12
total acidity
12
thermotolerans
8
lachancea thermotolerans
8
sequential fermentations
8
culture cerevisiae
8
thermotolerans cerevisiae
8
increase final
8
cerevisiae
6
acidity
6

Similar Publications

Historiography is a vital perspective of our scientific literature that charts the evolution of scientific publishing, from its early origins to the present status. The key transformations including the shift from a limited self-published legacy to specialized and professional peer-reviewed journals, the impact of technological advancements, and the emergence of new profitable business models are learning points for the future course and couture. Science is pursued and persevered by real humans in social and cultural contexts and not in isolation of laboratories or clinics.

View Article and Find Full Text PDF

The advent of bioprinting has enabled the creation of precise three-dimensional (3D) cell cultures suitable for biomimetic in vitro models. In this study, we developed a novel protocol for 3D printing methacrylated collagen (ColMa, or PhotoCol®) combined with tendon stem/progenitor cells (hTSPCs) derived from human tendon explants. Although pure ColMa has not previously been proposed as a printable hydrogel, this paper outlines a robust and highly reproducible pipeline for bioprinting this material.

View Article and Find Full Text PDF

Optimal submicron roughness for balancing degradation behavior, immune modulation, and microbial adhesion on zinc-based barrier membranes.

Biomater Adv

December 2024

Department of Prosthodontics, School and Hospital of Stomatology, Guangdong Engineering Research Center of Oral Restoration and Reconstruction, Guangzhou Medical University, Guangzhou 510180, China; Guangzhou Key Laboratory of Basic and Applied Research of Oral Regenerative Medicine, Guangzhou Medical University, Guangzhou 510180, China. Electronic address:

Metallic zinc (Zn) has been demonstrated to be a promising alternative to barrier membrane materials for guided bone regeneration. Surface roughness significantly affects the properties of degradable Zn-based metals, especially within the Janus micro-environments of tissue regeneration. However, the effects of optimal surface roughness on Zn remain unknown.

View Article and Find Full Text PDF
Article Synopsis
  • Pseudomonas aeruginosa is problematic in healthcare due to its high antibiotic resistance, highlighting the need for new antimicrobial solutions.
  • A study focused on isolating a new bacteriocin from Enterococcus faecium found in stool samples, which showed promise against multidrug-resistant P. aeruginosa.
  • The purified bacteriocin, enterocin GH, demonstrated significant antibacterial and antibiofilm activity against P. aeruginosa, outperforming controls in laboratory tests.
View Article and Find Full Text PDF

Effects of on Metabolites and Flavors in Synthetic Microbiota During Baijiu Fermentation.

Foods

December 2024

Cooperative Innovation Center of Industrial Fermentation (Ministry of Education and Hubei Province), Key Laboratory of Fermentation Engineering (Ministry of Education), Hubei Provincial Key Laboratory of Industrial Microbiology, School of Life and Health Sciences, Hubei University of Technology, Wuhan 430068, China.

The distinctive flavor and aroma of Chinese baijiu are closely linked to the microorganisms involved in the fermentation process. , a dominant species in the fermentation of Chinese baijiu, has become a prominent research focus. In this study, we selected well-characterized pure cultures of microorganisms to construct diverse chassis microflora.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!