Modeling of Photochemical Reactions in a Focused Laser Beam, II.

J Res Natl Inst Stand Technol

Biochemical Science Division, National Institute of Standards and Technology, Gaithersburg, MD 20899.

Published: April 2016

A method is described for obtaining the rate constant of the photodegradation process of fluorophores illuminated by a focused laser beam. The explicit kinetic equations, describing the population dynamics of excited singlet and triplet states, are averaged over the illuminated volume to describe the resulting fluorescence signal. The illumination is modulated at frequencies from 1 Hz to 100 Hz. Synchronous detection of the resulting fluorescence yields in-phase and quadrature components. The measurement of the ratio of quadrature to in-phase components at several power levels yields information on the photodegradation rate. Specifically it is shown that the data can be interpreted in a manner which yields the value of the photodegradation rate independently of other parameters entering the model. Experiments are performed with erythrosine B which has a large intersystem crossing rate to the triplet state. Measurements in solutions with different viscosities show that the photodegradation rate depends on the viscosity. This is interpreted as evidence for an intermolecular interaction mechanism. We explore the uncertainty of the estimated photodegradation constant taking into account the uncertainties of the measurements used in the synchronous detection technique.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4652875PMC
http://dx.doi.org/10.6028/jres.113.019DOI Listing

Publication Analysis

Top Keywords

photodegradation rate
12
focused laser
8
laser beam
8
synchronous detection
8
yields photodegradation
8
rate
5
photodegradation
5
modeling photochemical
4
photochemical reactions
4
reactions focused
4

Similar Publications

Acid-Enhanced Photoiniferter Polymerization under Visible Light.

Angew Chem Int Ed Engl

December 2024

ETH Zurich, Materials, Vladimir-​Prelog-Weg 1-5/10, 8093, Zürich, SWITZERLAND.

Photoiniferter (PI) is a promising polymerization methodology, often used to overcome restrictions posed by thermal reversible addition-fragmentation chain-transfer (RAFT)  polymerization. However, in the overwhelming majority of reports, high energy UV irradiation is required to effectively trigger photolysis of RAFT agents and facilitate the polymerization, significantly limiting its potential, scope, and applicability. Although visible light PI has emerged as a highly attractive alternative, most current approaches are limited to the synthesis of lower molecular weight polymers, and typically suffer from prolonged reaction times, extended induction periods, and higher dispersities.

View Article and Find Full Text PDF

Rate coefficients for the reaction of CH with CHO were measured for the first time over the temperature range of 37-603 K, with the CH radicals produced by pulsed laser photolysis and detected by CH radical chemiluminescence following their reaction with O. The low temperature measurements (≤93 K) relevant to the interstellar medium were made within a Laval nozzle gas expansion, while higher temperature measurements (≥308 K) were made within a temperature controlled reaction cell. The rate coefficients display a negative temperature dependence below 300 K, reaching (1.

View Article and Find Full Text PDF

Aerosol light absorption has been widely considered as a contributing factor to the worsening of particulate pollution in large urban areas, primarily through its role in stabilizing the planetary boundary layer (PBL). Here, we report that absorption-dominated aerosol-radiation interaction can decrease near-surface fine particulate matter concentrations ([PM]) at a large-scale during wintertime haze events. A "warm bubble" effect by the significant heating rate of absorbing aerosols above the PBL top generates a secondary circulation, enhancing the upward motion (downward motion) and the convergence (divergence) in polluted (relatively clean) areas, with a net effect of lowering near-surface [PM].

View Article and Find Full Text PDF

Probing methylmercury photodegradation by different fractions of natural organic matter in water: Degradation kinetics and mercury isotope fractionation characteristics.

Environ Pollut

December 2024

Shandong Key Laboratory of Environmental Processes and Health, School of Environmental Science and Engineering, Shandong University, Qingdao, 266237, China; Department of Chemistry & Biochemistry, Florida International University, Miami, FL, 33199, United States. Electronic address:

Recent advancements in mercury (Hg) isotopic fractionation research have evolved from conceptual demonstrations to practical applications. However, few studies have focused on revealing fractionation fingerprinting for aqueous methylmercury (MeHg) photodegradation due to its sensitivity to natural organic matter (NOM). Here, the impact of NOM fractions with varying chemical properties on MeHg photodegradation kinetics and Hg isotope fractionation characteristics was investigated.

View Article and Find Full Text PDF

Researchers in the field of photocatalysis are interested in finding a solution to the problem of charge transfer and recombination in photodegradation mechanisms. The ideal photoactive catalyst would be inexpensive, environmentally friendly, easily manufactured, and highly efficient. Graphitic carbon nitride (g-CN) and metal oxide (MOx) based nanocomposites (g-CN/MOx) are among the photocatalysts that provide the best results in terms of charge transfer capacity, redox capabilities, and charge recombination inhibition.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!