Poly(3-methylthiophene) (PMeT) thin films were electrochemically deposited on quartz crystal microbalance QCM transducers to investigate their volatile organic compound (VOC) sensing properties depending on ambient conditions. Twelve different VOCs including alcohols, ketones, chlorinated compounds, amines, and the organosphosphate dimethyl methylphosphonate (DMMP) were used as analytes. The responses of the chemical sensors against DMMP were the highest among the tested analytes; thus, fabricated chemical sensors based on PMeT can be evaluated as potential candidates for selectively detecting DMMP. Generally, detection limits in the low ppm range could be achieved. The gas sensing measurements were recorded at various humid air conditions to investigate the effects of the humidity on the gas sensing properties. The sensing performance of the chemical sensors was slightly reduced in the presence of humidity in ambient conditions. While a decrease in sensitivity was observed for humidity levels up to 50% r.h., the sensitivity was nearly unaffected for higher humidity levels and a reliable detection of the VOCs and DMMP was possible with detection limits in the low ppm range.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4850937PMC
http://dx.doi.org/10.3390/s16040423DOI Listing

Publication Analysis

Top Keywords

chemical sensors
12
thin films
8
volatile organic
8
sensing properties
8
ambient conditions
8
detection limits
8
limits low
8
low ppm
8
ppm range
8
gas sensing
8

Similar Publications

Identifying promising peptide targets for leprosy serological tests: From prediction to ELISA.

J Genet Eng Biotechnol

March 2025

Programa de Pós-Graduação em Ciências da Saúde, Faculdade de Medicina, Universidade Federal de Minas Gerais, Belo Horizonte, Minas Gerais, Brazil; Programa de Pós-Graduação em Parasitologia, Instituto de Ciências Biológicas, Universidade Federal de Minas Gerais, Belo Horizonte, Minas Gerais, Brazil. Electronic address:

Leprosy remains a significant health concern, particularly in India, Brazil, and Indonesia. Early diagnosis is essential to prevent complications, highlighting the need for improved diagnostic tools. This study aimed to identify novel Mycobacterium leprae antigens and assess their effectiveness against human sera through immunotools for antibody response evaluation.

View Article and Find Full Text PDF

Conjugated polymers (CPs) are considered one of the most important gas-sensing materials due to their unique features, combining the benefits of both metals and semiconductors, along with their outstanding mechanical properties and excellent processability. However, CPs with conventional morphological structures, such as largely amorphous and bulky matrices, face limitations in practical applications because of their inferior charge transport characteristics, low surface area, and insufficient sensitivity. Therefore, the design and development of novel morphological nanostructures in CPs have attracted significant attention as a promising strategy for improving morphological and electrical characteristics, thereby enabling a considerable increase in the sensing performance of corresponding gas sensors.

View Article and Find Full Text PDF

Limonene monitoring in citrus industry wastewater using molecularly imprinted voltammetric sensor.

Talanta

March 2025

Department of Analytical, Physical-chemical and Inorganic Chemistry, Institute of Chemistry, São Paulo State University (UNESP), 55 Prof. Francisco Degni St., Araraquara, 14800-060, São Paulo State, Brazil; Bioenergy Research Institute (IPBEN), São Paulo State University (UNESP), 55 Prof. Francisco Degni St., Araraquara, 14800-060, São Paulo State, Brazil.

The present work reports the development of a novel molecularly imprinted polymer (MIP) electrochemical sensor for limonene determination in orange industry wastewater. MIP sensor was constructed through the pyrrole electropolymerization in the presence of limonene on glassy carbon electrode surface (GCE/MIP). Electrode surface as characterized by electrochemical, spectroscopy and microscopic techniques.

View Article and Find Full Text PDF

In this work, several peptides of soluble suppression of tumorigenicity 2 (sST2) were screened, synthesized, and then imprinted with electropolymerization onto poly(aniline-co-3-aminobenzenesulfonic acid), poly(AN-co-MSAN). Three MXenes, including titanium or molybdenum carbides, were also doped within the conductive polymer film to enhance the electrochemical response. The electrodes were employed as the extended gate in a field-effect transistor (EG-FET) platform.

View Article and Find Full Text PDF

Novel fluorescence-based and portable detection platforms using nitrogen-doped carbon dots for environmental monitoring of dichloran fungicide.

Spectrochim Acta A Mol Biomol Spectrosc

March 2025

Department of Chemistry, Faculty of Science and Technology, Thammasat University, Pathumthani 12120, Thailand; Center of Excellence on Petrochemical and Materials Technology, Chulalongkorn University, Bangkok 10330, Thailand. Electronic address:

A novel fluorescence sensor utilizing label-free nitrogen self-doped carbon dots (NCDs) was developed for the sensitive, selective, and rapid determination of dichloran fungicide, popularly used in agricultural and horticultural fields. The NCDs were prepared from maleic anhydride and diethylenetriamine via a one-step pyrolysis process. They demonstrated strong blue fluorescence emission with a quantum yield of 12 %.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!