Background: Ursolic acid (UA), a natural pentacyclic triterpenoid, has been reported to possess a variety of pharmacological activities, but the poor oral bioavailability of UA owing to the poor aqueous solubility and membrane permeability limits the further clinical application.
Objective: The purpose of the present study was to develop UA nanocrystals and microcrystals employing high pressure homogenization (HPH) and to evaluate their effects on UA oral bioavailability.
Method: The crystalline morphology of UA nanocrystals and microcrystals prepared by HPH was observed by scanning electron microscopy and the crystalline state was characterized by differential scanning calorimetry (DSC) and powder X-ray diffraction (PXRD). The dissolution rate of UA nanocrystals in different pH conditions was tested. Oral bioavailability of UA nanocrystals and microcrystals comparing with UA coarse suspension was evaluated in SD rats after 50 mg·kg-1 administration.
Results: UA nanocrystals and microcrystals, the size of which ranged between 291.7 nm and 1299.3 nm were obtained. The results of DSC and PXRD revealed a degree of crystalline-amorphous transformation during HPH preparation. A significant increase was observed in the dissolution rate of UA nanocrystals. The relative bioavailability of UA nanocrystals and microcrystals exhibited 2.56 and 1.40-fold enhancement than that of UA coarse suspension, respectively, along with an increased peak concentration and a prolonged retention.
Conclusion: The nanosized UA crystal is a viable and efficient approach to improve the oral bioavailability of UA.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.2174/1567201813666160307142757 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Conversion of Flexible Spin Crossover Metal-Organic Frameworks Macrocrystals to Nanocrystals Using Ultrasound Energy: A Study on Structural Integrity by MicroED and Charge-Transport Properties.
Small
December 2024
IMDEA Nanociencia, Ciudad Universitaria de Cantoblanco, C/ Faraday 9, Madrid, 28049, Spain.
Metal-Organic Frameworks (MOFs) attract attention for their intrinsic porosity, large surface area, and functional versatility. To fully utilize their potential in applications requiring precise control at smaller scales, it is essential to overcome challenges associated with their bulk form. This is particularly difficult for 3D MOFs with spin crossover (SCO) behavior, which undergo a reversible transition between high-spin and low-spin states in response to external stimuli.
View Article and Find Full Text PDFPhotocatalytic Estrogen Degradation by the Composite of Tin Oxide Fine Particles and Graphene-like Carbon Nitride.
ACS Omega
December 2024
Department of Life Science and Applied Chemistry, Nagoya Institute of Technology Gokiso-cho, Showa-ku, Nagoya 466-8555, Japan.
This study investigates whether 17β-estradiol (E2), a natural estrogen and one of the endocrine-disrupting chemicals responsible for water pollution, can be oxidatively decomposed under simulated solar light using a composite of tin oxide nanoparticles and graphene-like carbon nitride (g-CN) as a photocatalyst. The composite photocatalyst was prepared by heating a mixture of urea and tin acetate. FT-IR measurements revealed that g-CN possesses structural units similar to g-CN, a well-studied graphite-like carbon nitride.
View Article and Find Full Text PDFSheet-on-sheet fixed target data collection devices for serial crystallography at synchrotron and XFEL sources.
J Appl Crystallogr
December 2024
Serial crystallography (SX) efficiently distributes over many crystals the radiation dose absorbed during diffraction data acquisition, enabling structure determination of samples at ambient temperature. SX relies on the rapid and reliable replacement of X-ray-exposed crystals with fresh crystals at a rate commensurate with the data acquisition rate. 'Solid supports', also known as 'fixed targets' or 'chips', offer one approach.
View Article and Find Full Text PDFSevere oral mucositis is a major cause of a low quality of life in patients; however, the therapeutic effect of traditional treatments is insufficient. Therefore, we designed a carbopol gel based on rebamipide nanocrystals (REB NCs) and gum arabic (GA-REB@NP), and investigated its efficacy in accelerating wound healing in a hamster model of oral mucositis. REB NCs were prepared by bead milling, and GA- REB@NP were prepared by incorporating REB NCs into a carbopol gel.
View Article and Find Full Text PDFLaser direct lithography allows for the maskless production and alignment of nanocrystals. However, laser-induced crystal growth requires a complex process of nucleation followed by growth that takes a long time, resulting in low efficiency. Here, we used a laser explosion to pre-grow silicon seed crystals in a silicon precursor solution, simplified crystal growth and increased the lithography efficiency.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!