Influence of formulation on the oxidative stability of water-in-oil emulsions.

Food Chem

Univ. Bordeaux, CBMN, UMR 5248, 33600 Pessac, France; CNRS, CBMN, UMR 5248, 33600 Pessac, France; Bordeaux INP, CBMN, UMR 5248, 33600 Pessac, France. Electronic address:

Published: July 2016

The oxidation of water-in-oil (W/O) emulsions was investigated, emphasizing the impact of compositional parameters. The emulsions had approximately the same average droplet size and did not show any physical destabilization throughout the study. In the absence of pro-oxidant ions in the aqueous phase, lipid oxidation of the W/O emulsions was moderate at 60°C and was in the same range as that measured for the neat oils. Oxidation was significantly promoted by iron encapsulation in the aqueous phase, even at 25°C. However, iron chelation reduced the oxidation rate. Emulsions based on triglycerides rich in polyunsaturated fatty acids were more prone to oxidation, whether the aqueous phase encapsulated iron or not. The emulsions were stabilized by high- and low-molecular weight surfactants. Increased relative fractions of high molecular weight components reduced the oxidation rate when iron was present.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.foodchem.2016.01.145DOI Listing

Publication Analysis

Top Keywords

aqueous phase
12
w/o emulsions
8
reduced oxidation
8
oxidation rate
8
emulsions
6
oxidation
6
influence formulation
4
formulation oxidative
4
oxidative stability
4
stability water-in-oil
4

Similar Publications

Pharmaceuticals removal from aqueous solution by water hyacinth (Eichhornia crassipes): a comprehensive investigation of kinetics, equilibrium, and thermodynamics.

Environ Sci Pollut Res Int

January 2025

Grupo de Investigación Materiales Con Impacto (Mat&Mpac), Facultad de Ciencias Básicas, Universidad de Medellín, Carrera 87 No. 30-65, 050026, Medellín, Colombia.

This study shows the efficiency of WH-C450, an adsorbent obtained from water hyacinth (WH) biomass, in the removal of sulfamethoxazole (SMX) from aqueous solutions. The process involves calcination of WH at 450 °C to produce an optimal adsorbent material capable of removing up to 73% of SMX and maximum SMX adsorption capacity of 132.23 mg/g.

View Article and Find Full Text PDF

Enhancing oil recovery in sandstone reservoirs, particularly through smart water flooding, is an appealing area of research that has been thoroughly documented. However, few studies have examined the formation of water-in-heavy oil emulsion because of the incompatibility between the injected water-folded ions, clay particles, and heavy fraction in the oil phase. In this study, we investigated the synergistic roles of asphaltene and clay in the smart water flooding process using a novel experimental approach.

View Article and Find Full Text PDF

Compound-specific stable isotope analysis (CSIA) using liquid chromatography-isotope ratio mass spectrometry (LC-IRMS) is a powerful tool for determining the isotopic composition of carbon in analytes from complex mixtures. However, LC-IRMS methods are constrained to fully aqueous eluents. Previous efforts to overcome this limitation were unsuccessful, as the use of organic eluents in LC-IRMS was deemed impossible.

View Article and Find Full Text PDF

A novel synthesis of a nanometric MCM-41 from biogenic silica obtained from rice husk is here presented. CTABr and Pluronic F127 surfactants were employed as templating agents to promote the formation of a long-range ordered 2D-hexagonal structure with cylindrical pores and to limit the particle growth at the nanoscale level thus resulting in a material with uniform particle size of 20-30 nm. The physico-chemical properties of this sample (RH-nanoMCM) were investigated through a multi-technique approach, including PXRD, Si MAS NMR, TEM, -potential and N physisorption analysis at 77 K.

View Article and Find Full Text PDF

Efforts to reduce the impact of chemical processes on the environment are leading to a shift to enzymatic alternatives, with laccases standing out for their versatile substrate oxidation capabilities. This study addresses the improvement of biocatalytic reactions by deep eutectic solvents (DES), in particular DES-based aqueous two-phase systems (ATPS) for the extraction of biomolecules. Continuous laccase extraction from crude samples was achieved using a DES-based ATPS, which was first optimized in a batch extractor and later intensified in a microextractor.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!