Techno-economic analysis of ethanol production from sugarcane bagasse using a Liquefaction plus Simultaneous Saccharification and co-Fermentation process.

Bioresour Technol

Stan Mayfield Biorefinery, University of Florida, Perry, FL 32348, United States; Microbiology & Cell Science, University of Florida, Gainesville, FL 32611-0700, United States. Electronic address:

Published: May 2016

A techno-economic analysis was conducted for a simplified lignocellulosic ethanol production process developed and proven by the University of Florida at laboratory, pilot, and demonstration scales. Data obtained from all three scales of development were used with Aspen Plus to create models for an experimentally-proven base-case and 5 hypothetical scenarios. The model input parameters that differed among the hypothetical scenarios were fermentation time, enzyme loading, enzymatic conversion, solids loading, and overall process yield. The minimum ethanol selling price (MESP) varied between 50.38 and 62.72 US cents/L. The feedstock and the capital cost were the main contributors to the production cost, comprising between 23-28% and 40-49% of the MESP, respectively. A sensitivity analysis showed that overall ethanol yield had the greatest effect on the MESP. These findings suggest that future efforts to increase the economic feasibility of a cellulosic ethanol process should focus on optimization for highest ethanol yield.

Download full-text PDF

Source
http://dx.doi.org/10.1016/j.biortech.2016.01.093DOI Listing

Publication Analysis

Top Keywords

techno-economic analysis
8
analysis ethanol
8
ethanol production
8
hypothetical scenarios
8
ethanol yield
8
ethanol
6
production sugarcane
4
sugarcane bagasse
4
bagasse liquefaction
4
liquefaction simultaneous
4

Similar Publications

This perspective work examines the current advancements in integrated CO capture and electrochemical conversion technologies, comparing the emerging methods of (1) electrochemical reactive capture (eRCC) though amine- and (bi)carbonate-mediated processes and (2) direct (flue gas) adsorptive capture and conversion (ACC) with the conventional approach of sequential carbon capture and conversion (SCCC). We initially identified and discussed a range of cell-level technological bottlenecks inherent to eRCC and ACC including, but not limited to, mass transport limitations of reactive species, limitation of dimerization, impurity effects, inadequate generation of CO to sustain industrially relevant current densities, and catalyst instabilities with respect to some eRCC electrolytes, amongst others. We followed this with stepwise perspectives on whether these are considered intrinsic challenges of the technologies - otherwise recommendations were disclosed where appropriate.

View Article and Find Full Text PDF

This work studies the influence of flue gas composition, its moisture and ash content, on the efficiency of a CO adsorption/desorption process to capture the CO from flue gases along with its subsequent reuse in greenhouse CO enrichment (Patent ES2514090). The influence of the inlet flow rate, moisture, and ash content were analysed. The experimental conditions were based on those that are achievable under real operating conditions, namely an inlet flow rate from 1.

View Article and Find Full Text PDF

The use of reduction leaching in the production of alumina from bauxite by the Bayer process in order to decrease the amount of waste (bauxite residue) by adding elemental iron or aluminum, as well as Fe salts and organic compounds in the stage of high-pressure leaching, requires the purchase of relatively expensive reagents in large quantities. The aim of this study was to investigate the possibility of the use of electrolytically reduced bauxite residue (BR) as a substitute for these reagents. Reduced BR was obtained from Al-goethite containing BR using a bulk cathode in alkaline suspension.

View Article and Find Full Text PDF

Elevated emissions of flue gases deteriorate the quality of air, impacting both terrestrial and aquatic ecosystems through their contribution to acid rain and eutrophication. This study examines the bio-mitigation process in a packed bed reactor and its capacity to concurrently decrease the environmental consequences of industrial flue gases (CO, NO, and SO) and wastewater by employing mixed bacterial consortia. The highest biomass productivity achieved during the growth phase was 0.

View Article and Find Full Text PDF

Nanofiltration Membranes for Efficient Lithium Extraction from Salt-Lake Brine: A Critical Review.

ACS Environ Au

January 2025

Dow Centre for Sustainable Engineering Innovation, School of Chemical Engineering, The University of Queensland, Brisbane, QLD 4072, Australia.

The global transition to clean energy technologies has escalated the demand for lithium (Li), a critical component in rechargeable Li-ion batteries, highlighting the urgent need for efficient and sustainable Li extraction methods. Nanofiltration (NF)-based separations have emerged as a promising solution, offering selective separation capabilities that could advance resource extraction and recovery. However, an NF-based lithium extraction process differs significantly from conventional water treatment, necessitating a paradigm shift in membrane materials design, performance evaluation metrics, and process optimization.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!