Objective: Orthodontic appliances are considered to be highly biocompatible although adverse effects attributed to the release of nickel ions (Ni(2+)) have been documented. Self-ligating brackets have grown in popularity for economic reasons and supposed friction reduction. The aim of the present prospective cohort study was therefore to determine salivary Ni(2+) concentrations in patients undergoing orthodontic treatment with self-ligating fixed appliances.

Materials And Methods: A group of 30 patients between 10 and 13 years of age were treated with self-ligating brackets (SmartClip™), molar bands, and nickel-titanium (NiTi) archwires. Unstimulated saliva samples were collected after different time points (before treatment, after self-ligating bracket and band placement, before archwire insertion, after archwire insertion, and finally 4 and 8 weeks afterwards) and analyzed with an ICP mass spectrometer followed by generalized estimating equation modelling with α = 5 %.

Results: The baseline median salivary Ni(2+) concentration was 21.85 µg/l, while the Ni(2+) concentrations at the following visits ranged between 13.73 and 85.34 µg/l. Significant increases in Ni(2+) levels compared to the baseline levels were detected after band/bracket placement [+59.76 µg/l; 95 % confidence interval (CI) 44.88-74.64 µg/l; P < 0.001] and after archwire insertion (+53.55 µg/l; 95 % CI 25.57-81.52 µg/l; P < 0.001). After 4 weeks, Ni(2+) concentrations returned to initial control levels or were lower.

Conclusion: Self-ligating orthodontic appliances may affect salivary Ni(2+) concentrations in vivo over the short term. However, levels resembled those documented in conjunction with conventional bracket use and remained below the daily dietary Ni intake.

Download full-text PDF

Source
http://dx.doi.org/10.1007/s00056-016-0012-xDOI Listing

Publication Analysis

Top Keywords

ni2+ concentrations
16
salivary ni2+
12
archwire insertion
12
treated self-ligating
8
self-ligating fixed
8
prospective cohort
8
cohort study
8
orthodontic appliances
8
self-ligating brackets
8
treatment self-ligating
8

Similar Publications

A novel nanocomposite magnetic hydrogel was synthesized based on κ-carrageenan, acrylic acid, and activated carbon as an absorbent for removing heavy metal ions from aqueous solution. FT-IR spectroscopy, thermogravimetric analysis (TGA), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and vibration sample magnetometer (VSM) were employed to confirm the structure of the nanocomposite hydrogels. The effects of contact time, pH, particle size, temperature, and metal ion concentration on the metal ion adsorption were investigated.

View Article and Find Full Text PDF

Oscillatory Motion of a Camphor Disk on a Water Phase with an Ionic Liquid Sensitive to Transition Metal Ions.

J Phys Chem B

December 2024

Graduate School of Integrated Sciences for Life, Hiroshima University, 1-3-1 Kagamiyama, Higashi-Hiroshima 739-8526, Hiroshima, Japan.

We investigated oscillatory motion of a camphor disk floating on water containing 5 mM hexylethylenediaminium trifluoroacetate (HHexen-TFA) as an ionic liquid (IL). The frequency of the oscillatory motion increased with increasing concentrations of the transition metal ions Cu and Ni but was insensitive to Na, Ca, and Mg, the typical metal ions in the water phase. The surface tension of the water phase containing 5 mM HHexen-TFA also increased with increasing concentrations of Cu and Ni but was insensitive to Na, Ca, and Mg.

View Article and Find Full Text PDF

β-Glucosidase plays a pivotal role in transforming ginsenosides into specific minor ginsenosides. In this study, total ginsenosides from Panax notoginseng leaves were used as substrates to stimulate the growth of Aspergillus niger NG1306. Transcriptome analysis identified a β-glucosidase gene, Anglu04478 (1455 bp, 484 amino acids, 54.

View Article and Find Full Text PDF

Design of Chemoresponsive Liquid Crystals Using Metal-Coordinating Polymer Surfaces.

ACS Appl Mater Interfaces

December 2024

Smith School of Chemical and Biomolecular Engineering, Cornell University, Ithaca, New York 14853, United States.

Liquid crystals (LCs), when interfaced with chemically functionalized surfaces, can amplify a range of chemical and physical transformations into optical outputs. While metal cation-binding sites on surfaces have been shown to provide a basis for the design of chemoresponsive LCs, the cations have been found to dissociate from the surfaces and dissolve slowly into LCs, resulting in time-dependent changes in the properties of LC-solid interfaces (which impacts the reliability of devices incorporating such surfaces). Here, we explore the use of surfaces comprising metal-coordinating polymers to minimize the dissolution of metal cations into LCs and characterize the impact of the interfacial environment created by the coordinating polymer on the ordering and time-dependent properties of LCs.

View Article and Find Full Text PDF

Enhanced removal of Ni and Co from wastewater using a novel 2-hydroxyphosphonoacetic acid modified Mg/Fe-LDH composite adsorbent.

Water Res

December 2024

Department of Neurobiology and Acupuncture Research, The Third Clinical Medical College, Zhejiang Chinese Medical University, Hangzhou, 310053, PR China. Electronic address:

While technological advancements in treating electroplating wastewater continue, removing high concentrations of Ni and Co remains a challenge. Surface functionalization of clay has emerged as a pivotal approach for effectively removing heavy metals, rivaling intercalation modification in its effectiveness. This study investigated the adsorption performance and mechanisms of a phosphonate-modified layered double hydroxide material, employing batch experiments and simulation calculations to elucidate the impact of surface modification on adsorption behavior.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!