Effect of Competitive Surface Functionalization on Dual-Modality Fluorescence and Magnetic Resonance Imaging of Single-Walled Carbon Nanotubes.

J Phys Chem C Nanomater Interfaces

Department of Electrical Engineering and Computer Science, Vanderbilt University, Nashville, Tennessee 37235, United States ; Interdisciplinary Program in Materials Science, Vanderbilt University, Nashville, Tennessee 37235, United States ; Department of Physics and Astronomy, Vanderbilt University, Nashville, Tennessee 37235, United States.

Published: August 2012

It is well-known that ionic surfactant coated single-walled carbon nanotubes (SWNTs) possess higher near-infrared fluorescence (NIRF) quantum yield than nonionic polymer functionalized SWNTs. However, the influence of surface functionalization on the magnetic properties of SWNTs for -weighted magnetic resonance imaging (MRI) has not been reported. Here, we demonstrate that SWNTs functionalized by nonionic polymers display superior relaxivity for MRI as compared to those coated by ionic surfactants. This difference may indicate that micelle structures formed by ionic surfactants are sufficiently tight to partially exclude water protons from the iron catalysts attached to the ends of SWNTs. On the basis of the different effects of the two types of suspension agents on NIRF and MRI of functionalized SWNTs, we further explore the competitive surface functionalization between ionic surfactants and nonionic polymers by stepwise replacing ionic surfactant molecules in a nanotube suspension with nonionic polymers. The superior NIRF of ionic surfactant coated SWNTs gradually quenches whereas no improvement on relaxivity is observed during this replacement process. This result may indicate that nonionic polymers wrap around the outside of micelle structures to form small nanotube bundles rather than replacing ionic surfactants in the micelle structures to directly interact with the SWNT surface. Finally, we demonstrate the feasibility of dual-modality NIRF and MRI of nonionic polymer functionalized SWNTs in brain cells.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4670557PMC
http://dx.doi.org/10.1021/jp305372zDOI Listing

Publication Analysis

Top Keywords

nonionic polymers
16
ionic surfactants
16
surface functionalization
12
ionic surfactant
12
functionalized swnts
12
micelle structures
12
competitive surface
8
magnetic resonance
8
resonance imaging
8
single-walled carbon
8

Similar Publications

Nanocrystalline formulations typically contain stabilizing additives to minimize the risk of particle growth or agglomeration. This risk is particularly relevant when the nanosuspension is converted into a solid drug product as the original state of the nanosuspension should be restored upon redispersion of the drug product in vivo. In this work, the behavior of different nonionic and anionic surfactants in solid nanocrystalline formulations and their effects on redispersibility under biorelevant conditions were investigated.

View Article and Find Full Text PDF

Developing hydrogels with high conductivity and toughness a facile strategy is important yet challenging. Herein, we proposed a new strategy to develop conductive hydrogels by growing metal dendrites. Water-soluble Sn ions were soaked into the gel and then converted to Sn dendrites an electrochemical reaction; the excessive Sn ions were finally removed by water dialysis, accompanied by dramatic shrinkage of the gel.

View Article and Find Full Text PDF

Mesoporous bioactive glass (MBG) is an advanced biomaterial widely recognized for its application in bone regenerative engineering. This study synthesized an MBG powder (80 mol% SiO, 5 mol% PO, and 15 mol% CaO) using a facile sol-gel method with the non-ionic surfactant Pluronic P123, which acted as a pore-forming agent. MBGs form bioactive surfaces that facilitate HA formation, and the presence of Pluronic P123 increases the surface area and promotes HA nucleation.

View Article and Find Full Text PDF

Environmental changes, such as applied medication, nutrient depletion, and accumulation of metabolic residues, affect cell culture activity. The combination of these factors reflects on the local temperature distribution and local oxygen concentration towards the cell culture scaffold. However, determining the temporal variation of local temperature, independent of local oxygen concentration changes in biological specimens, remains a significant technological challenge.

View Article and Find Full Text PDF

Influence of Added Cellulose Nanocrystals on the Rheology of Polymers.

Nanomaterials (Basel)

January 2025

Department of Chemical Engineering, University of Waterloo, Waterloo, ON N2L 3G1, Canada.

The interactions between cellulose nanocrystals and six different polymers (three anionic, two non-ionic, and one cationic) were investigated using rheological measurements of aqueous solutions of nanocrystals and polymers. The experimental viscosity data could be described adequately by a power-law model. The variations in power-law parameters (consistency index and flow behavior index) with concentrations of nanocrystals and polymers were determined for different combinations of nanocrystals and polymers.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!