Synthesis and Characterization of Biomimetic Hydroxyapatite Nanoconstruct Using Chemical Gradient across Lipid Bilayer.

ACS Appl Mater Interfaces

Nanotechnology Innovation Center of Kansas State, ‡Department of Chemistry, §Department of Anatomy and Physiology, Kansas State University, Manhattan, Kansas 66506, United States.

Published: December 2015

In this study, we synthesized biomimetic hydroxyapatite nanoconstruct (nanosized hydroxyapatite, NHAp) using a double emulsion technique combined with a chemical gradient across a lipid bilayer for surface modification of a titanium (Ti) implant. The synthesized NHAp was characterized by dynamic light scattering, X-ray diffraction, transmission electron microscopy, and Fourier transform infrared (FTIR) spectroscopy, and it was further tested for its biocompatibility and in vitro proliferation efficacy using normal human osteoblasts (NHOst). The results showed that the synthesized NHAp had a hydrodynamic diameter of ∼200 nm with high aqueous stability. The chemistry of the NHAp was confirmed by FTIR spectroscopic analysis. Typical FTIR vibrational bands corresponding to the phosphate group (PO4(3-)) present in hydroxyapatite (HAp) were observed at 670, 960, and 1000 cm(-1). A broad band at 3500 cm(-1) confirmed the presence of a structural -OH group in the NHAp. Powder X-ray crystallographic diffraction further confirmed the formation of NHAp with characteristic reflections in (002), (211), (130), and (213) planes at respective 2θ degrees. These reflection planes are similar to those of typical HAp crystallized toward (002) and (211) crystallographic planes. The mechanism of the formation of NHAp was studied using the fluorescence resonance energy transfer (FRET) technique. The FRET study showed the fluorescent recovery of a donor fluorophore and the mechanism of the insertion of lipids into nanodroplets obtained from the first water-in-oil (w/o) emulsion during the formation of the second oil-in-water (o/w) emulsion. With these confirmations, we further studied NHOst cell proliferation on a Ti surface. When NHOst were cultured on the Ti surface coated with the NHAp, a distinct proliferation pattern and cell-cell communication via cytoplasmic extension on the substrate surface were observed. In contrast, a bare Ti surface showed diminished cell size with minimal adherence. This result indicates that our NHAp covered with a phospholipid bilayer provides a proper environment essential for cell adhesion, which is especially important for bone implants, and the inclusion of NHAp on the Ti substrate would be an effective support for long-term sustainability of implants.

Download full-text PDF

Source
http://dx.doi.org/10.1021/acsami.5b09042DOI Listing

Publication Analysis

Top Keywords

nhap
10
biomimetic hydroxyapatite
8
hydroxyapatite nanoconstruct
8
chemical gradient
8
gradient lipid
8
lipid bilayer
8
synthesized nhap
8
formation nhap
8
002 211
8
surface
5

Similar Publications

Nursing home acquired pneumonia (NHAP), and its subset - aspiration-associated pneumonia, is a leading cause of morbidity and mortality among residents in long-term care facilities (LTCFs). Understanding colonization dynamics of respiratory pathogens in LTCF residents is essential for effective infection control. This study examines the longitudinal trends in prevalence, persistence, bacterial load, and co-colonization patterns of five respiratory pathogens in three LTCFs in Phoenix, Arizona.

View Article and Find Full Text PDF

Nanoparticles Induced Biomimetic Remineralization of Acid-Etched Dentin.

J Dent (Shiraz)

December 2024

Dept. Conservative Dentistry and Endodontics, St.Joseph Dental College, Duggirala, Eluru, Andra Pradesh, India.

Statement Of The Problem: Dentin bonding with etch-and-rinse adhesives involves demineralizing the 5-8µm of the surface dentin to create micro space for resin infiltration. The presence of continuous fluid movement in dentin tubules and positive pulpal pressure prevents complete water replacement by resin monomers. This results in areas of demineralized dentin, which contain collagen fibers without resin infiltration.

View Article and Find Full Text PDF

The management and treatment of long bone defects are challenging clinical problems. In this study, in order to address the need for load bearing segmental defects, 3D printed cylindrical implants of poly(-caprolactone) (PCL) and nanohydroxyapatite (nHAp) composites were prepared and applied as lateral segments to the femurs of New Zealand white rabbits. The results obtained after 6 weeks of implantation were compared with the autografts.

View Article and Find Full Text PDF

In this research, nano-hydroxyapatite synthesized from seashells (Ss/nHAp) and the potential of Ss/nHAp as an adsorbent for eliminating Congo Red (CR) dye from aqueous solutions were explored. The synthesized Ss/nHAp was subjected to characterization using various techniques, including XRD, XPS, FTIR, Raman, BET, FESEM in order to understand the material thoroughly. Batch adsorption experiments were conducted to establish the optimal conditions for removing the dye, considering variables such as adsorbent dosage, contact time, pH and initial dye concentration.

View Article and Find Full Text PDF

Objective: White spot lesions are initial sign of enamel caries that compromise esthetic appearance following orthodontic treatment. Thus, the systematic review was conducted to evaluate the remineralization potential of orthodontic adhesives on early-enamel lesions surrounding orthodontic bracket.

Methods: Search strategy was performed through three databases (PubMed, Web of Science, and Scopus).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!