Room-temperature calorimeter for x-ray free-electron lasers.

Rev Sci Instrum

RIKEN SPring-8 Centre, 1-1-1 Kouto, Sayo-cho, Sayo-gun, Hyogo 679-5148, Japan.

Published: September 2015

We have developed a room-temperature calorimeter for absolute radiant power measurements of x-ray free-electron lasers. This room-temperature calorimeter is an electrical substitution device based on the equivalence of electrical and radiant heating. Consequently, the measured radiant powers are traceable to electrical standards, i.e., the International System Units (SI). We demonstrated the performance of the room-temperature calorimeter by electrical power measurements (offline tests). In the offline tests, the room-temperature calorimeter was proven to be able to measure external powers up to at least 6.9 mW, which exceeds the upper limit (∼4 mW) of a cryogenic radiometer (the primary standard detector in Japan). In addition, measurement uncertainties of the room-temperature calorimeter were evaluated to be less than 1.0%, which is adequate for the radiant power measurements of x-ray free-electron lasers. An indirect comparison with the cryogenic radiometer was performed using a synchrotron radiation source to confirm the validity of the absolute radiant powers measured with the room-temperature calorimeter. The absolute radiant powers measured by the calorimeter agreed with those measured by the cryogenic radiometer within 0.6%, which is less than the relative standard uncertainty of the comparison (1.0%).

Download full-text PDF

Source
http://dx.doi.org/10.1063/1.4929666DOI Listing

Publication Analysis

Top Keywords

room-temperature calorimeter
28
x-ray free-electron
12
free-electron lasers
12
absolute radiant
12
power measurements
12
radiant powers
12
cryogenic radiometer
12
calorimeter absolute
8
radiant power
8
measurements x-ray
8

Similar Publications

In the present study, single crystals and polycrystalline material of KCaSiO were prepared from solid-state reactions between stoichiometric mixtures of the corresponding oxides/carbonates. Heat capacity ( ) measurements above room temperature using a differential scanning calorimeter indicated that two thermal effects occurred at approximately  = 462 K and  = 667 K, indicating the presence of structural phase transitions. The standard third-law entropy of KCaSiO was determined from low-temperature 's measured by relaxation calorimetry using a Physical Properties Measurement System and amounts to °(298K) = 524.

View Article and Find Full Text PDF

Achieving micro-kelvin (µK) temperature stability is critical for many calorimetric applications. For example, sub-nanowatt resolution biocalorimetry requires stabilization of the temperature of the calorimeter to µK levels. Here, we describe how µK temperature stability can be accomplished in a prototypical calorimetric system consisting of two nested shields and a suspended capillary tube, which is well suited for biocalorimetry applications.

View Article and Find Full Text PDF

Hydrolysis of pharmaceutically active molecules can be in control under a confined environment of water-in-oil microemulsion. Stability of model drug methotrexate (MTX) in a sodium bis(2-ethylhexyl) sulfosuccinate (AOT) and olive oil microemulsion system has been evaluated. The physicochemical properties of AOT-MTX-water-olive oil reverse microemulsion (MTX-RM) were examined by UV-vis, Fourier transform infrared, and X-ray diffraction techniques, and the hydrodynamic size was determined by dynamic light scattering techniques and morphologies were characterized by a transmission electron microscope and atomic force microscope.

View Article and Find Full Text PDF

Currently, food packaging is facing a critical transition period and a major challenge: it must preserve the food products' quality and, at the same time, it must meet the current requirements of the circular economy and the fundamental principles of packaging materials eco-design. Our research presents the development of eco-friendly packaging films based on cladodes (OFIC) as renewable resources. OFIC powder (OFICP)-agar, OFICP-agar-gum arabic (GA), and OFICP-agar-xanthan (XG) blend films were eco-friendlily prepared by a solution casting method.

View Article and Find Full Text PDF

Facile preparation of high-performance plywood adhesive from gelatinized corn starch crosslinked with ammonium dihydrogen phosphate.

Int J Biol Macromol

January 2024

Yunnan Key Laboratory of Wood Adhesives and Glued Products, Southwest Forestry University, Kunming 650224, China. Electronic address:

A flame retardant high-performance gelatinized starch (GS)-ammonium dihydrogen phosphate (ADP) wood adhesive, named GS-ADP adhesive was prepared by condensation of GS and ADP under acidic condition. The preparation process of GS-ADP adhesive is very simple by mixing and stirring GS and ADP evenly at room temperature. The results revealed that the GS-ADP adhesive has good storage stability and water resistance, and its wet shear strength is much higher than that of phenolic resin (PF) adhesive.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!