we propose a bit-rate transparent interferometric noise mitigation scheme utilizing the nonlinear modulation curve of electro-absorption modulator (EAM). Both the zero-slope region and the linear modulation region of the nonlinear modulation curve are utilized to suppress interferometric noise and enlarge noise margin of degraded eye diagrams. Using amplitude suppression effect of the zero-slope region, interferometric noise at low frequency range is suppressed successfully. Under different signal to noise ratio (SNR), we measured the power penalties at bit error rate (BER) of 10<(-9) with and without EAM interferometric noise suppression. By using our proposed scheme, power penalty improvement of 8.5 dB is achieved in a signal with signal-to-noise ratio of 12.5 dB. BER results at various bit rates are analyzed, error floors for each BER curves are removed, significantly improvement in receiver sensitivity and widely opened eye diagrams are resulted.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1364/OE.23.022572 | DOI Listing |
It has been shown that light speckle fluctuations provide a means for noninvasive measurements of cerebral blood flow index (CBFi). While conventional Diffuse Correlation Spectroscopy (DCS) provides marginal brain sensitivity for CBFi in adult humans, new techniques have recently emerged to improve diffuse light throughput and thus, brain sensitivity. Here we further optimize one such approach, interferometric diffusing wave spectroscopy (iDWS), with respect to number of independent channels, camera duty cycle and full well capacity, incident power, noise and artifact mitigation, and data processing.
View Article and Find Full Text PDFJ Phys Chem Lett
January 2025
Department of Chemistry, Massachusetts Institute of Technology, Cambridge, Massachusetts 02139, United States.
Evaluating the quantum optical properties of solid-state single-photon emitters is a time-consuming task that typically requires interferometric photon correlation experiments. Photon correlation Fourier spectroscopy (PCFS) is one such technique that measures time-resolved single-emitter line shapes and offers additional spectral information over Hong-Ou-Mandel two-photon interference but requires long experimental acquisition times. Here, we demonstrate a neural ordinary differential equation model, g2NODE, that can forecast a complete and noise-free interferometry experiment from a small subset of noisy correlation functions.
View Article and Find Full Text PDFHigh-dimensional photon states (qudits) are pivotal to enhance the information capacity, noise robustness, and data rates of quantum communications. Time-bin entangled qudits are promising candidates for implementing high-dimensional quantum communications over optical fiber networks with processing rates approaching those of classical telecommunications. However, their use is hindered by phase instability, timing inaccuracy, and low scalability of interferometric schemes needed for time-bin processing.
View Article and Find Full Text PDFSensors (Basel)
December 2024
Beijing Urban Construction Survey and Design Institute, Beijing 100101, China.
Interferometric Synthetic Aperture Radar (InSAR) is a widely used remote sensing technology for Earth observation, enabling the detection and measurement of ground deformation through the generation of interferograms. However, phase noise remains a critical factor that degrades interferogram quality. To address this issue, this study proposes MOMFNet, a deep learning approach for InSAR phase filtering based on multi-objective multi-kernel feature extraction that leverages multi-objective multi-kernel feature extraction.
View Article and Find Full Text PDFRev Sci Instrum
December 2024
Faculty of Physics, Lomonosov Moscow State University, 119991 Moscow, Russia.
High purity silicon is considered as the test mass material for future cryogenic gravitational-wave detectors, in particular Einstein Telescope-low frequency and LIGO Voyager [(LIGO) Laser Interferometer Gravitational-Wave Observatory]. To reduce the thermal noise of the test masses, it is necessary to study the sources of corresponding losses. Mechanical resonators with frequencies 300 Hz-6 kHz are successfully used for studying, for example, losses in optical coatings of the test mass.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!