This paper describes a low pass filter based on photonics crystal fiber (PCF) partial ASE suppression, and its application within a 1.7 µm to 1.8 µm band thulium-doped fiber amplifier (TDFA) and a thulium-doped fiber laser (TDFL). The enlargement of air holes around the doped core region of the PCF resulted in a low-pass filter device that was able to attenuate wavelengths above the conventional long cut-off wavelength. These ensuing long cut-off wavelengths were 1.85 μm and 1.75 μm, and enabled a transmission mechanism that possessed a number of desirable characteristics. The proposed optical low-pass filter was applied within a TDFA and TDFL system. Peak spectrum was observed at around 1.9 μm for conventional TDF lasers, while the proposed TDF laser with PCF setup had fiber laser peak wavelengths measured at downshifted values of 1.74 μm and 1.81 μm.

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.23.019681DOI Listing

Publication Analysis

Top Keywords

thulium-doped fiber
12
fiber laser
12
low-pass filter
12
optical low-pass
8
long cut-off
8
μm
7
laser
4
laser utilizing
4
utilizing photonic
4
photonic crystal
4

Similar Publications

Difference frequency generation (DFG) based tunable single-frequency mid-infrared (MIR) light sources are desirable for high-resolution spectroscopy, sensing, and imaging. In this work, we demonstrate a continuous-wave (CW) single-frequency DFG in a ZnGeP (ZGP) crystal driven by all-fiber near-infrared (NIR) fiber lasers, for the first time to our knowledge. The all-fiber NIR laser sources consist of a 1.

View Article and Find Full Text PDF

We present a model and design for a high-power triple-clad thulium doped fiber specifically for in-band or tandem pumping. This fiber is designed to maximize the output signal power while taking into consideration common effects that limit high-power operation. In-band pumping will allow for thulium fiber lasers to reach multi-kW power levels.

View Article and Find Full Text PDF

We report the first, to our knowledge, observation of the nonlinear phenomenon known as modulation instability (MI) in a coherently driven fiber resonator pumped at 1972 nm. To compensate for the very high losses in this spectral region, we have integrated a thulium-doped fiber amplifier inside the cavity. Lower losses allow a lower MI threshold, leading to the observation of this phenomenon at a moderate input power.

View Article and Find Full Text PDF

We report on single-frequency, linearly polarized, high-concentration thulium-doped silica fiber-distributed Bragg reflector lasers operating at wavelengths between 1908 and 2050 nm with high efficiencies up to 48% and high powers up to 1 W. Low relative power noise and frequency noise are demonstrated using a low-noise pump diode.

View Article and Find Full Text PDF

We report on a highly efficient, in-band pumped, Q-switched, Tm-doped, rod-type master oscillator power amplifier (MOPA) system delivering up to 140 W average output power and 7 mJ pulse energy with a slope efficiency of 77% at 20 kHz repetition rate. The amplifier is pumped with Raman-shifted fiber lasers centered at 1692 nm. This in-band pump scheme for Tm-doped fiber lasers can significantly mitigate their quantum defect-related heat load limitations.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!