Platinum (Pt) doped TiO2 nanofibers were prepared by a sol-gel derived electrospinning and subsequent calcination for 3 h at temperatures from 500 degrees C to 700 degrees C in air. The influence of calcination temperature on crystal structure of the Pt-TiO2 nanofibers was investigated by using an X-ray diffractometer (XRD) and a transmission electron microscope (TEM). The fibers possessed both anatase and rutile phases of TiO2 as a function of the calcination temperature. At 500 degrees C, only anatase phase was observed. However, the rutile phase started to grow with increasing the temperature. At 700 degrees C, 47% of rutile phase with a crystallite size of 31 nm was detected. The continuous and smooth Pt-TiO2 fibers with a diameter of 38 nm were changed to the particulate morphology (at 700 degrees C) with increasing the temperature. This result is particularly important because the calcination temperature is attributed to the fiber morphology and the crystal structure.

Download full-text PDF

Source
http://dx.doi.org/10.1166/jnn.2015.8325DOI Listing

Publication Analysis

Top Keywords

calcination temperature
16
crystal structure
12
700 degrees
12
influence calcination
8
temperature crystal
8
structure pt-tio2
8
pt-tio2 nanofibers
8
500 degrees
8
rutile phase
8
increasing temperature
8

Similar Publications

Nowadays, Egypt is treating the Nile River Water to produce drinking water, and this process generates large amounts of waste, around 635 million m annually, which is called water treatment plant sludge (WTPS). This WTPS cost the government around 30 million US dollars to return it back to the Nile River in addition to negatively affecting the environment. Therefore, there is an urgent need to find environmentally friendly alternatives that reduce the impact of such an issue.

View Article and Find Full Text PDF

Soluble starch/zinc oxide nanocomposites could be promising candidates for eco-friendly antimicrobial, food packaging, and a wide range of other utilization. In order to find a new way for the preparation of this kind of nanocomposites, an efficient and energy-saving reaction for the synthesis of soluble starch/zinc oxide nanocomposites has been investigated. The reaction was implemented in a solid state at room temperature without post-reaction calcination.

View Article and Find Full Text PDF

Surface Oxygen Vacancies on Copper-Doped Titanium Dioxide for Photocatalytic Nitrate-to-Ammonia Reduction.

J Am Chem Soc

January 2025

Research Center for Solar Energy Chemistry and Division of Chemical Engineering, Graduate School of Engineering Science, Osaka University, Toyonaka 560-8531, Japan.

Photocatalytic transformation of nitrate (NO) in wastewater into ammonia (NH) is a challenge in the detoxification and recycling of limited nitrogen resources. In particular, previously reported photocatalysts cannot promote the reaction using water as an electron donor. Herein, we report that copper-doped titanium dioxide (Cu-TiO) powders, prepared via the sol-gel method and subsequent calcination, promote NO-to-NH reduction in water.

View Article and Find Full Text PDF

Biphasic calcium phosphate (BCP) is a bioceramic widely used in hard tissue engineering for bone replacement. BCP consists of β-tricalcium phosphate (β-TCP) - a highly soluble and resorbable phase - and hydroxyapatite (HA) - a highly stable phase, creating a balance between solubility and resorption, optimally supporting cell interactions and tissue growth. The β-TCP/HA ratio significantly affects the resorption, solubility, and cellular response, with a higher β-TCP ratio increasing resorption due to its solubility.

View Article and Find Full Text PDF

Biosorption of cobalt (II) from an aqueous solution over acid modified date seed biochar: an experimental and mass transfer studies.

Environ Sci Pollut Res Int

January 2025

Department of Chemical Engineering, Zakir Hussain College of Engineering and Technology, Aligarh Muslim University, Aligarh, 202002, Uttar Pradesh, India.

Water pollution because of the presence of heavy metals remains a serious worry. The present work demonstrates the exclusion of cobalt ion (or Co(II)) from water using novel and cost-effective biosorbents. Initially, the biosorbent was chemically modified using orthophosphoric acid and then subjected to calcination to result acid modified date seed biochar (AMDB).

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!