Ozone (O3) concentration and flux (Fo) were measured using the eddy covariance technique over a wheat field in the Northwest-Shandong Plain of China. The O3-induced wheat yield loss was estimated by utilizing O3 exposure-response models. The results showed that: (1) During the growing season (7 March to 7 June, 2012), the minimum (16.1 ppbV) and maximum (53.3 ppbV) mean O3 concentrations occurred at approximately 6:30 and 16:00, respectively. The mean and maximum of all measured O3 concentrations were 31.3 and 128.4 ppbV, respectively. The variation of O3 concentration was mainly affected by solar radiation and temperature. (2) The mean diurnal variation of deposition velocity (Vd) can be divided into four phases, and the maximum occurred at noon (12:00). Averaged Vd during daytime (6:00-18:00) and nighttime (18:00-6:00) were 0.42 and 0.14 cm/sec, respectively. The maximum of measured Vd was about 1.5 cm/sec. The magnitude of Vd was influenced by the wheat growing stage, and its variation was significantly correlated with both global radiation and friction velocity. (3) The maximum mean Fo appeared at 14:00, and the maximum measured Fo was -33.5 nmol/(m(2)·sec). Averaged Fo during daytime and nighttime were -6.9 and -1.5 nmol/(m(2)·sec), respectively. (4) Using O3 exposure-response functions obtained from the USA, Europe, and China, the O3-induced wheat yield reduction in the district was estimated as 12.9% on average (5.5%-23.3%). Large uncertainties were related to the statistical methods and environmental conditions involved in deriving the exposure-response functions.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1016/j.jes.2014.12.022 | DOI Listing |
Heliyon
January 2025
Department of Medical Laboratories, College of Applied Medical Sciences, Qassim University, Buraydah 51452, Saudi Arabia.
Purpose: Due to the extensive use of radiation in various fields, such as food safety, sterilizing surgical materials, and medical diagnostics, it is essential to minimize radiation exposure for both patients and healthcare professionals, even at low doses. To meet this requirement, a composite film has been developed using polyvinyl alcohol (PVA) polymer and nitro blue tetrazolium (NBT) dye to measure low radiation doses effectively.
Methods: Various concentrations of NBT dye (ranging from 0.
Heliyon
January 2025
Chest Clinical College of Tianjin Medical University, Tianjin, 300270, China.
Backgroud: Fluid volume abnormalities are a major cause of exacerbations in heart failure patients. However, there is few efficient, rapid, or cost-effective clinical approach for determining volume status, resulting in inadequate or unsatisfactory treatment. The aim was to develop an early fluid volume detection model for heart failure patients utilizing a machine learning stratification.
View Article and Find Full Text PDFInt J Thermophys
January 2024
Material Measurement Laboratory, Applied Chemicals and Materials Division, National Institute of Standards and Technology, Boulder, CO 80305, USA.
The thermal conductivity of liquid -1,2-dichloroethene (R-1130(E)) was measured at temperatures ranging from 240 K to 340 K and pressures up to 25 MPa using a transient hot-wire instrument. A total of 447 thermal conductivity data points were measured along six isotherms. Each isotherm includes data at nine pressures, which were chosen to be at equal density increments starting at a pressure of 0.
View Article and Find Full Text PDFInt J Thermophys
January 2024
Applied Chemicals and Materials Division, National Institute of Standards and Technology, Boulder, CO 80305, USA.
Sound speed data measured using a dual-path pulse-echo instrument are reported for pure -1,2-dichloroethene (R-1130(E)) and an azeotropic blend of -1,1,1,4,4,4-hexafluorobutene (R-1336mzz(Z)) and R-1130(E) with a composition of 74.8 mass % R-1336mzz(Z) with the balance being R-1130(E). The azeotropic blend of R-1336mzz(Z)/1130(E) is classified as R-514A in ANSI/ASHRAE standard 34.
View Article and Find Full Text PDFMater Horiz
January 2025
Center for Future Optoelectronic Functional Materials, School of Computer and Electronic Information/School of Artificial Intelligence, Nanjing Normal University, Nanjing 210023, P. R. China.
Given that optical thermometers are widely used due to their unique advantages, this study aims to address critical challenges in existing technologies, such as insufficient sensitivity, limited temperature measurement ranges, and poor signal recognition capabilities. Herein, we develop a thermometer based on the fluorescence intensity ratio (FIR) of Sb-doped CsNaInCl (CsNaInCl:Sb). As the temperature increases from 203 to 323 K, the thermally induced transition from triplet to singlet self-trapped excitons (STEs) leads to enhanced 455 nm photoluminescence (PL) from singlet STE recombination.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!