Objective: To observe the characteristics of vertical cast-off bloodstain pattern by different hitting-tools.
Methods: The regular hitting tools, a kitchen knife, a dirk, a plane set-hammer and an iron pipe, were selected. At a distance of 30 cm away from the wall, the hitting tool with 5 mL fresh chicken blood made the cast-off bloodstain from top to bottom. Then the holistic distribution characteristics (length, width and density) of cast-off bloodstain and morphology characteristics (length, width and contact angle) of first single cast-off bloodstain were analyzed.
Results: The distribution length of cast-off bloodstain formed by dirk was minimum (P < 0.05). The distribution width of cast-off bloodstain formed by kitchen knife was minimum (P < 0.05). Except the pair of kitchen knife and plane set-hammer, the distribution density between each two tools had statistical differences (P < 0.05). The length of first single cast-off bloodstain formed by plane set-hammer was longest compared (P < 0.05). The width of first single cast-off bloodstain had statistical differences between kitchen knife and plane set-hammer, and between dirk and plane set-hammer (P < 0.05).
Conclusion: The type of hitting tool could be inferred by the specific characteristics of cast-off bloodstain pattern formed by every specific type of hitting tool in crime scene.
Download full-text PDF |
Source |
---|
J Forensic Sci
May 2024
Safety Division, National Forensic Service, Wonju, Republic of Korea.
In bloodstain pattern analysis (BPA), a field of forensic science, there has been active discussion on the estimation of the area of origin of impact spatter. However, there is no established methodology to quantitatively analyze the area of origin of a swing cast-off pattern. To quantitatively analyze the methodology of previous research on estimation of area of origin, a device for generating uniform swing cast-off patterns was produced.
View Article and Find Full Text PDFForensic Sci Int
January 2022
ai2-3D Forensics, 271 Jevlan Drive, Unit 14, Vaughan, ON L4L 8A4, Canada. Electronic address:
Forensic Sci Int
February 2021
Struo LLC, Ames, IA, 50010, United States; Department of Mechanical Engineering, Iowa State University, 2025, Black Engineering, Ames, 50011, IA, United States. Electronic address:
Cast-off spatter patterns exhibit linear trails of elliptical stains. These characteristic patterns occur by centrifugal forces that detach drops from a swinging object covered with blood or other liquid. This manuscript describes a method to reconstruct the motion, or swing, of the object.
View Article and Find Full Text PDF3 Biotech
June 2020
Department of Biotechnology, KLE Technological University, Hubballi, Karnataka 580031 India.
J Forensic Sci
September 2020
Knoxville Catholic High School, Knoxville, TN.
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!