To overcome the drawback of poor solar light utilization brought about by the narrow photoresponse range of TiO₂, a silver and sulfur co-doped TiO₂was synthesized. Using the prepared catalyst, solar photocatalytic degradation of 2-nitrophenol (2-NP) by a TiO₂-based catalyst was studied for the first time. Effects of the co-doping on the structural, optical and morphological properties of the synthesized nanoparticles were investigated by different characterization methods: X-ray diffraction, N2 adsorption-desorption measurements, scanning electron microscopy, transmission electron microscopy, energy-dispersive X-ray spectroscopy, UV-visible diffuse reflectance spectroscopy and Fourier transform infrared spectroscopy. Solar experiments showed that the co-doping with silver and sulfur significantly increased the photocatalytic activity. In various initial concentrations of 2-NP more than 99% of the contaminant was decomposed by Ag-S/TiO₂in less than 150 minutes, while the degradation efficiency was much less in the presence of bare TiO₂. Kinetic studies suggested that solar photocatalytic degradation of 2-NP is consistent with the Langmuir-Hinshelwood model. The rate constant of the reaction and adsorption constant of the modified photocatalyst were found to be 2.4 and 4.1 times larger than that of bare TiO₂, respectively.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.2166/wst.2015.180 | DOI Listing |
Inorg Chem
January 2025
Department of Chemistry, Biochemistry and Pharmaceutical Sciences, University of Bern, 3012 Bern, Switzerland.
Binuclear silver(I) and copper(I) complexes, and , with bridging diphenylphosphine ligands were prepared. In , the silver(I) center is located inside a trigonal plane composed of three phosphorus donors from three separate and bridging dppm ligands. The fourth coordination site is filled with neighboring silver(I) ions.
View Article and Find Full Text PDFNanomaterials (Basel)
December 2024
Quantum Nano Centre, Department of Chemical Engineering, University of Waterloo, Waterloo, ON N2L 3G1, Canada.
Laser conversion of commercial polymers to laser-induced graphene (LIG) using inexpensive and accessible CO lasers has enabled the rapid prototyping of promising electronic and electrochemical devices. Frequently used to pattern interdigitated supercapacitors, few approaches have been developed to pattern batteries-in particular, full cells. Herein, we report an LIG-based approach to a planar, interdigitated Li-S battery.
View Article and Find Full Text PDFACS Appl Mater Interfaces
January 2025
Department of Physics, Jadavpur University, Kolkata 700032, India.
Self-powered broadband photodetectors (SPBPDs) hold great potential for next-generation optoelectronic applications, but their performance is often limited by interface defects that impair charge transport and increase recombination losses. In this work, we report the enhancement of the photodetection efficiency of SPBPDs by partially substituting copper (Cu) with silver (Ag) in kesterite CuZnSnS (ACZTS) thin films. Varying Ag concentrations (0%, 2%, 4%, 6%) are incorporated into the CZTS layer, forming a TiO/ACZTS heterojunction in superstrate configuration fabricated via a low-cost sol-gel spin-coating technique with low-temperature open air annealing avoiding conventional postdeposition sulfurization or selenization.
View Article and Find Full Text PDFNat Mater
January 2025
Department of Mechanical Engineering, The Pennsylvania State University, University Park, PA, USA.
Lithium-sulfur (Li-S) all-solid-state batteries (ASSBs) hold great promise for next-generation safe, durable and energy-dense battery technology. However, solid-state sulfur conversion reactions are kinetically sluggish and primarily constrained to the restricted three-phase boundary area of sulfur, carbon and solid electrolytes, making it challenging to achieve high sulfur utilization. Here we develop and implement mixed ionic-electronic conductors (MIECs) in sulfur cathodes to replace conventional solid electrolytes and invoke conversion reactions at sulfur-MIEC interfaces in addition to traditional three-phase boundaries.
View Article and Find Full Text PDFSci Total Environ
January 2025
Direction Milieux et impacts sur le vivant, Institut National de l'Environnement Industriel et des Risques (INERIS), Verneuil en Halatte, France.
Emissions due to tires retread/repair and incineration are a cause of concern owing to the presence of nanoparticles in the products. The assessment exposure to humans hereto related is a challenge in an environmental context. The first object of this work is to develop a method to characterize the emission sources using online (counting and sizing) and offline measurements.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!