Engineering of the thermodynamic properties of bilayer graphene by atomic plane rotations: the role of the out-of-plane phonons.

Nanoscale

Nano-Device Laboratory (NDL) and Phonon Optimized Engineered Materials (POEM) Center, University of California - Riverside, Riverside, California 92521, USA.

Published: August 2015

We investigated theoretically the specific heat of graphene, bilayer graphene and twisted bilayer graphene taking into account the exact phonon dispersion and density of states for each polarization branch. It is shown that contrary to a conventional belief the dispersion of the out-of-plane acoustic phonons - referred to as ZA phonons - deviates strongly from a parabolic law starting from the frequencies as low as ∼100 cm(-1). This leads to the frequency-dependent ZA phonon density of states and the breakdown of the linear dependence of the specific heat on temperature T. We established that ZA phonons determine the specific heat for T ≤ 200 K while contributions from both in-plane and out-of-plane acoustic phonons are dominant for 200 K ≤ T ≤ 500 K. In the high-temperature limit, T > 1000 K, the optical and acoustic phonons contribute approximately equally to the specific heat. The Debye temperature for graphene and twisted bilayer graphene was calculated to be around ∼1861-1864 K. Our results suggest that the thermodynamic properties of materials such as bilayer graphene can be controlled at the atomic scale by rotation of the sp(2)-carbon planes.

Download full-text PDF

Source
http://dx.doi.org/10.1039/c5nr03579aDOI Listing

Publication Analysis

Top Keywords

bilayer graphene
20
specific heat
16
acoustic phonons
12
thermodynamic properties
8
graphene twisted
8
twisted bilayer
8
density states
8
out-of-plane acoustic
8
graphene
7
phonons
6

Similar Publications

Ferroelectricity with concomitant Coulomb screening in van der Waals heterostructures.

Nat Nanotechnol

January 2025

State Key Laboratory for Mesoscopic Physics, School of Physics, Peking University, Beijing, China.

Interfacial ferroelectricity emerges in non-centrosymmetric heterostructures consisting of non-polar van der Waals (vdW) layers. Ferroelectricity with concomitant Coulomb screening can switch topological currents or superconductivity and simulate synaptic response. So far, it has only been realized in bilayer graphene moiré superlattices, posing stringent requirements to constituent materials and twist angles.

View Article and Find Full Text PDF

Graphene is a single-layered sp-hybridized carbon allotrope, which is impermeable to all atomic entities other than hydrogen. The introduction of defects allows selective gas permeation; efforts have been made to control the size of these defects for higher selectivity. Permeation of entities other than gases, such as ions, is of fundamental scientific interest because of its potential application in desalination, detection and purification.

View Article and Find Full Text PDF

Metallic Electro-optic Effect in Gapped Bilayer Graphene.

Nano Lett

January 2025

Division of Physics and Applied Physics, School of Physical and Mathematical Sciences, Nanyang Technological University, Singapore 637371.

Electro-optic (EO) modulation is a critical device action in photonics. Recently, the non-Drude dynamics induced by the Berry curvature dipole (BCD) in metals have attracted attention as a potential candidate for terahertz EO modulation. However, such BCD-induced EO effects can be challenging to realize, often requiring flat bands and complex materials such as a strained magic-angle twisted bilayer graphene on hexagonal boron nitride.

View Article and Find Full Text PDF

A possibility of unprecedented architecture may be opened up by combining both vertical and in-plane heterostructures. It is fascinating to discover that the interlayer stress transfer, interlayer binding energy, and interlayer shear stress of bi-layer Gr/hBN with CNTs heterostructures greatly increase (more than 2 times) with increase the numbers of CNTs and both saturate at the numbers of CNTs = 3, but it causes only 10.92% decrease in failure strain.

View Article and Find Full Text PDF

In-Plane Transition-Metal Dichalcogenide Junction with Nearly Zero Interfacial Band Offset.

ACS Nano

January 2025

Center for Interdisciplinary Science of Optical Quantum and NEMS Integration, School of Physics, Advanced Research Institute of Multidisciplinary Science, and School of Integrated Circuits and Electronics, Beijing Institute of Technology, Beijing 100081, China.

Two-dimensional in-plane transition-metal dichalcogenide (TMD) junctions have a range of potential applications in next-generation electronic devices. However, limited by the difficulties in ion implantation on 2D systems, the fabrication of the in-plane TMD junctions still relies on the lateral epitaxy of different materials, which always induces lattice mismatch and interfacial scattering. Here, we report the in-plane TMD junction formed with monolayer (ML) PtTe at the boundary of ML and bilayer graphene on SiC.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!