Water vapor and carbon dioxide are the most dominant greenhouse gases directly contributing to the Earth's radiation budget and global warming. A performance evaluation of an airborne triple-pulsed integrated path differential absorption (IPDA) lidar system for simultaneous and independent monitoring of atmospheric water vapor and carbon dioxide column amounts is presented. This system leverages a state-of-the-art Ho:Tm:YLF triple-pulse laser transmitter operating at 2.05 μm wavelength. The transmitter provides wavelength tuning and locking capabilities for each pulse. The IPDA lidar system leverages a low risk and technologically mature receiver system based on InGaAs pin detectors. Measurement methodology and wavelength setting are discussed. The IPDA lidar return signals and error budget are analyzed for airborne operation on-board the NASA B-200. Results indicate that the IPDA lidar system is capable of measuring water vapor and carbon dioxide differential optical depth with 0.5% and 0.2% accuracy, respectively, from an altitude of 8 km to the surface and with 10 s averaging. Provided availability of meteorological data, in terms of temperature, pressure, and relative humidity vertical profiles, the differential optical depth conversion into weighted-average column dry-air volume-mixing ratio is also presented.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1364/AO.54.001387 | DOI Listing |
An integrated path differential absorption (IPDA) lidar for CH leakage monitoring is proposed and demonstrated. In the simplified all-fiber optical layout, a homemade InGaAs/InP single-photon detector (SPD) using multi-channel technique with multi-mode fiber coupling is used to increase the maximum count rate and coupling efficiency. The system is calibrated in intensity and frequency domains.
View Article and Find Full Text PDFIn contrast to the passive remote sensing of global CO column concentrations (XCO), active remote sensing with a lidar enables continuous XCO measurements throughout the entire atmosphere in daytime and nighttime. The lidar could penetrate most cirrus and is almost unaffected by aerosols. Atmospheric environment monitoring satellite (AEMS, also named DQ-1) aerosol and carbon dioxide detection Lidar (ACDL) is a novel spaceborne lidar that implements a 1572 nm integrated path differential absorption (IPDA) method to measure the global XCO for the first time.
View Article and Find Full Text PDFWe present the development of a multi-spectral, integrated-path differential absorption (IPDA) lidar based on a dual-comb spectrometer for greenhouse gas monitoring. The system uses the lidar returns from topographic targets and does not require retroreflectors. The two frequency combs are generated by electro-optic modulation of a single continuous-wave laser diode.
View Article and Find Full Text PDFAn integrated path differential absorption (IPDA) lidar can accurately measure regional weighted column average concentrations ( ), which are crucial for understanding the carbon cycle in climate change studies. To verify the performance and data inversion methods of space-borne IPDA lidar, in July 2021, we conducted an airborne lidar validation experiment in Dunhuang, Gansu Province, China. An aircraft was equipped with a lidar system developed to measure and an in situ greenhouse gas analyzer (GGA).
View Article and Find Full Text PDFAimed at the regional open-path detection of benzene ( ) in the atmosphere, a power-modulated integrated path differential absorption (PM-IPDA) lidar is introduced and demonstrated. Two tunable interband cascade lasers (ICLs) with about 3.2 µm wavelength are utilized to generate the required PM optical signal.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!