Background: Fibered confocal fluorescence microscopy (FCFM) allows in vivo investigation of pulmonary microstructures. However, the bronchial epithelium can only be imaged using exogenous fluorophores. The objective of this study is to compare methylene blue (MB) and acriflavine genotoxicity and to assess FCFM performance for in vivo imaging of precancerous lesions.

Methods: Genotoxicity was assessed using the comet assay on both cultured human lymphocytes and NCI-H460 cells, which had been exposed to MB or acriflavine before being illuminated at 660 or 488 nm, respectively. FCFM was performed on precancerous lesions in the hamster cheek pouch model, following topical application of the fluorophores. FCFM data were analyzed according to histology.

Results: No genotoxicity was found using 0.01% (w/v) MB after illumination at 660 nm for 2 and 15 min (5 mW). Acriflavine exposure (0.025%) led to DNA damages, increasing from 2 to 15 min of light exposure at 448 nm in both lymphocytes (83.4 to 88%, p = 0.021) and NCI H460 cell populations (79.9 to 84.6%, p = 0.045). In total, 11 invasive carcinoma, 24 reserve cell hyperplasia, and 17 dysplasia lesions were imaged using FCFM in vivo. With both fluorophores, the cellular density increased from hyperplasia to high-grade dysplasia (p < 0.05). With MB, the cellular diameter significantly decreased (48.9 to 13.9 μm) from hyperplasia to carcinoma (p < 0.05). In this model, a cut-off diameter of 30 μm enabled the diagnosis of high-grade lesions with a sensitivity of 94.7% and a specificity of 97%.

Conclusion: Methylene blue can be used safely to image precancerous lesions in vivo. This study does not support the use of acriflavine in humans.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4382935PMC
http://dx.doi.org/10.1186/s12890-015-0020-4DOI Listing

Publication Analysis

Top Keywords

methylene blue
8
vivo imaging
8
imaging precancerous
8
precancerous lesions
8
fibered confocal
8
confocal fluorescence
8
fluorescence microscopy
8
microscopy fcfm
8
fcfm
6
safety performance
4

Similar Publications

Nanoparticles have been extensively studied for many years due to their important roles in catalysis, metallurgy and high temperature superconductors. But, Nanoparticles are extremely unstable and easily react with other substances. So, to control the size and the shape of nanoparticles they must be stabilized.

View Article and Find Full Text PDF

Investigation of Filtration Performances in Eggshell Ultrafiltration Membranes with Surface Functionalized Using Graphene Oxide.

ACS Omega

December 2024

Department of Physics, Faculty of Mathematics and Natural Science, Universitas Padjadjaran, Jalan Raya Bandung-Sumedang Km 21 Jatinangor, Sumedang 45363, Indonesia.

Efforts to prevent fouling are crucial in advancing ultrafiltration (UF) membranes, especially in addressing the concentration polarization of the accumulation of dissolved dye molecules in wastewater. This study explores the impact of incorporating graphene oxide (GO) onto eggshell (ES) UF membranes regarding their permeability, rejection efficiency, and permeate flow rate. The ES-GO membranes were obtained from eggshells that were modified with varied concentrations of GO (0.

View Article and Find Full Text PDF

At present, it is still difficult to significantly reduce the bandgap of TiO to promote its visible light absorption. Herein, we first synthesized sulfur-doped TiO from industrial TiOSO and then successfully synthesized red TiO nanoparticles by calcination with the N source melamine. Theoretical calculations show that predoped S could markedly decrease the formation energy and substitution energy of N-doped TiO, especially in high N/Ti ratios.

View Article and Find Full Text PDF

A poly(vinyl alcohol)/montmorillonite/titania (PVA/MMT/TiO) nanocomposite film was fabricated via a simple solution casting strategy for the removal of cationic as well as anionic dyes. The developed nanocomposite film was subjected to X-ray diffraction (XRD), Fourier transform Infrared (FTIR), thermogravimetric analysis, dynamic mechanical analysis (DMA), mechanical property evaluation, and scanning electron microscopy (SEM) analysis. The embedding of MMT and TiO nanoparticles onto a PVA matrix has been confirmed from XRD, FTIR, and SEM analysis.

View Article and Find Full Text PDF

Synthesis of Tin Oxide Nanoparticles from E-Waste for Photocatalytic Mixed-Dye Degradation under Sunlight.

ACS Omega

December 2024

Department of Chemistry, School of Advanced Sciences, Vellore Institute of Technology, Chennai Campus, Vandalur-Kelambakkam Road, Chennai, Tamil Nadu 600127, India.

Electronic waste (e-waste) has become a significant environmental concern worldwide due to the rapid advancement of technology and short product lifecycles. Waste-printed electronic boards (WPCBs) contain valuable metals and semiconductors; among them, tin can be recycled and repurposed for sustainable material production. This study presents a potential ecofriendly methodology for the recovery of tin from WPCBs in the form of tin oxide nanostructured powders.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!