Altered mechanical environment of bone cells in an animal model of short- and long-term osteoporosis.

Biophys J

Biomechanics Research Centre, National Centre for Biomedical Engineering Science, Biomedical Engineering, College of Engineering and Informatics, National University of Ireland, Galway, Ireland. Electronic address:

Published: April 2015

Alterations in bone tissue composition during osteoporosis likely disrupt the mechanical environment of bone cells and may thereby initiate a mechanobiological response. It has proved challenging to characterize the mechanical environment of bone cells in vivo, and the mechanical environment of osteoporotic bone cells is not known. The objective of this research is to characterize the local mechanical environment of osteocytes and osteoblasts from healthy and osteoporotic bone in a rat model of osteoporosis. Using a custom-designed micromechanical loading device, we apply strains representative of a range of physical activity (up to 3000 με) to fluorescently stained femur samples from normal and ovariectomized rats. Confocal imaging was simultaneously performed, and digital image correlation techniques were applied to characterize cellular strains. In healthy bone tissue, osteocytes experience higher maximum strains (31,028 ± 4213 με) than osteoblasts (24,921 ± 3,832 με), whereas a larger proportion of the osteoblast experiences strains >10,000 με. Most interestingly, we show that osteoporotic bone cells experience similar or higher maximum strains than healthy bone cells after short durations of estrogen deficiency (5 weeks), and exceeded the osteogenic strain threshold (10,000 με) in a similar or significantly larger proportion of the cell (osteoblast, 12.68% vs. 13.68%; osteocyte, 15.74% vs. 5.37%). However, in long-term estrogen deficiency (34 weeks), there was no significant difference between bone cells in healthy and osteoporotic bone. These results suggest that the mechanical environment of bone cells is altered during early-stage osteoporosis, and that mechanobiological responses act to restore the mechanical environment of the bone tissue after it has been perturbed by ovariectomy.

Download full-text PDF

Source
http://www.ncbi.nlm.nih.gov/pmc/articles/PMC4390805PMC
http://dx.doi.org/10.1016/j.bpj.2015.02.031DOI Listing

Publication Analysis

Top Keywords

mechanical environment
28
bone cells
28
environment bone
16
osteoporotic bone
16
bone
12
bone tissue
12
healthy osteoporotic
8
strains healthy
8
healthy bone
8
experience higher
8

Similar Publications

Article Synopsis
  • Limited biomechanical research explores how horizontal meniscus tears (HMTs), meniscal repair (MR), and meniscectomy affect knee biomechanics, prompting this systematic review to investigate changes in knee contact mechanics following these conditions.
  • A total of 6 studies were analyzed, revealing that HMTs increase peak contact pressure (PCP) by 14.2% and decrease contact area (CA) by 7.1%; partial meniscectomies (PM) also raised PCP significantly while reducing CA, and complete meniscectomies (CM) resulted in even higher increases in PCP (54.5%).
  • Meniscal repair (MR) showed no significant difference in PCP or CA compared to intact menisci, indicating that it
View Article and Find Full Text PDF

Climate change is an emerging global health crisis, disproportionately affecting low- and middle-income countries (LMICs) where health outcomes are increasingly compromised by environmental stressors such as pollution, natural disasters, and human migration. With a focus on promoting health equity, Global Surgery advocates for expanding access to surgical care and enhancing health outcomes, particularly in resource-limited and disaster-affected areas like LMICs. The healthcare industry-and more specifically, surgical care-significantly contributes to the global carbon footprint, primarily through resource-intensive settings, i.

View Article and Find Full Text PDF

This paper introduces a novel method for spleen segmentation in ultrasound images, using a two-phase training approach. In the first phase, the SegFormerB0 network is trained to provide an initial segmentation. In the second phase, the network is further refined using the Pix2Pix structure, which enhances attention to details and corrects any erroneous or additional segments in the output.

View Article and Find Full Text PDF

The effects of heat-assisted vat photopolymerization (HVPP) on the physical and mechanical properties of 3D-printed dental resins, including the morphometric stability of 3D-printed crowns, were investigated. A resin tank was designed to maintain the resin at 30, 40, and 50 ℃ during the 3D printing process. Test specimens were fabricated using a commercial dental resin, with untreated resin serving as the control group.

View Article and Find Full Text PDF

Emerging models to study competitive interactions within bacterial communities.

Trends Microbiol

January 2025

Institute of Structural and Molecular Biology, Department of Biological Sciences, Birkbeck College, London, UK; Institute of Structural and Molecular Biology, Division of Biosciences, University College London, London, UK. Electronic address:

Within both abiotic and host environments, bacteria typically exist as diverse, multispecies communities and have crucial roles in human health, agriculture, and industry. In these communities, bacteria compete for resources, and these competitive interactions can shape the overall population structure and community function. Studying bacterial community dynamics requires experimental model systems that capture the different interaction networks between bacteria and their surroundings.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!