A 220 nm bandwidth supercontinuum source in the two-micron wavelength range has been developed for use in a Fourier domain optical coherence tomography (FDOCT) system. This long wavelength source serves to enhance probing depth in highly scattering material with low water content. We present results confirming improved penetration depth in high opacity paint samples while achieving the high axial resolution needed to resolve individual paint layers. This is the first FDOCT developed in the 2 μm wavelength regime that allows fast, efficient capturing of 3D image cubes at a high axial resolution of 13 μm in air (or 9 μm in paint).

Download full-text PDF

Source
http://dx.doi.org/10.1364/OE.23.001992DOI Listing

Publication Analysis

Top Keywords

fourier domain
8
domain optical
8
optical coherence
8
coherence tomography
8
μm wavelength
8
wavelength range
8
supercontinuum source
8
high axial
8
axial resolution
8
high
4

Similar Publications

In this paper, we derive diffusion equation models in the spectral domain to study the evolution of the training error of two-layer multiscale deep neural networks (MscaleDNN) (Cai and Xu, 2019; Liu et al., 2020), which is designed to reduce the spectral bias of fully connected deep neural networks in approximating oscillatory functions. The diffusion models are obtained from the spectral form of the error equation of the MscaleDNN, derived with a neural tangent kernel approach and gradient descent training and a sine activation function, assuming a vanishing learning rate and infinite network width and domain size.

View Article and Find Full Text PDF

The 2024 Zurich perfluorinated compounds (PFCs) summit reiterated the urgent need for non-selective analytical approaches for PFC detection. 19F NMR holds great potential, however, sensitivity limitations lead to long analysis times and/or the possibility of not detecting low concentration species. Steady State Free Precession (SSFP) NMR collects the signal in a steady state regime, allowing 100's of acquisitions in the timespan of a single traditional NMR scan.

View Article and Find Full Text PDF

Mid-infrared spectral analysis has long been recognized as the most accurate noninvasive blood glucose measurement method, yet no practical compact mid-infrared blood glucose sensor has ever passed the accuracy benchmark set by the USA Food and Drug Administration (FDA): to substitute for the finger-pricking glucometers in the market, a new sensor must first show that 95% of their glucose measurements have errors below 15% of these glucometers. Although recent innovative exploitations of the well-established Fourier-transform infrared (FTIR) spectroscopy have reached such FDA accuracy benchmarks, an FTIR spectrometer is too bulky. The advancements of quantum cascade lasers (QCLs) can lead to FTIR spectrometers of reduced size, but compact QCL-based noninvasive blood glucose sensors are not yet available.

View Article and Find Full Text PDF

Remaining Useful Life Prediction of Rolling Bearings Based on CBAM-CNN-LSTM.

Sensors (Basel)

January 2025

School of Mechanical and Vehicle Engineering, Changchun University, Changchun 130022, China.

Predicting the Remaining Useful Life (RUL) is vital for ensuring the reliability and safety of equipment and components. This study introduces a novel method for predicting RUL that utilizes the Convolutional Block Attention Module (CBAM) to address the problem that Convolutional Neural Networks (CNNs) do not effectively leverage data channel features and spatial features in residual life prediction. Firstly, Fast Fourier Transform (FFT) is applied to convert the data into the frequency domain.

View Article and Find Full Text PDF

When low-light meets flares: Towards Synchronous Flare Removal and Brightness Enhancement.

Neural Netw

January 2025

Hefei University of Technology, Hefei, 230601, China; The Key Laboratory of Knowledge Engineering with Big Data, Ministry of Education, Hefei, 230601, China.

Low-light image enhancement (LLIE) aims to improve the visibility and illumination of low-light images. However, real-world low-light images are usually accompanied with flares caused by light sources, which make it difficult to discern the content of dark images. In this case, current LLIE and nighttime flare removal methods face challenges in handling these flared low-light images effectively: (1) Flares in dark images will disturb the content of images and cause uneven lighting, potentially resulting in overexposure or chromatic aberration; (2) the slight noise in low-light images may be amplified during the process of enhancement, leading to speckle noise and blur in the enhanced images; (3) the nighttime flare removal methods usually ignore the detailed information in dark regions, which may cause inaccurate representation.

View Article and Find Full Text PDF

Want AI Summaries of new PubMed Abstracts delivered to your In-box?

Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!