A compact, low loss, and highly sensitive optical fiber curvature sensor is presented. The device consists of a few-millimeter-long piece of seven-core fiber spliced between two single-mode fibers. When the optical fiber device is kept straight, a pronounced interference pattern appears in the transmission spectrum. However, when the device is bent, a spectral shift of the interference pattern is produced, and the visibility of the interference notches changes. This allows for using either visibility or spectral shift for sensor interrogation. The dynamic range of the device can be tailored through the proper selection of the length of the seven-core fiber. The effects of temperature and refractive index of the external medium on the response of the curvature sensor are also discussed. Linear sensitivity of about 3000 nm/mm(-1) for bending was observed experimentally.
Download full-text PDF |
Source |
|---|---|
| http://dx.doi.org/10.1364/OL.40.001468 | DOI Listing |
Publication Analysis
Top Keywords
Similar Publications
Curvature Determination Method for Diverging Acoustic Lens of Underwater Acoustic Transducer.
Sensors (Basel)
January 2025
College of Geodesy and Geomatics, Shandong University of Science and Technology, Qingdao 266590, China.
Underwater acoustic transducers need to expand the coverage of acoustic signals as much as possible in most ocean explorations, and the directivity indicators of transducers are difficult to change after the device is packaged, which makes the emergence angle of the underwater acoustic transducer limited in special operating environments, such as polar regions, submarine volcanoes, and cold springs. Taking advantage of the refractive characteristics of sound waves propagating in different media, the directivity indicators can be controlled by installing an acoustic lens outside the underwater acoustic transducer. To increase the detection range of an underwater acoustic transducer in a specific marine environment, a curvature-determining method for the diverging acoustic lens of an underwater acoustic transducer is proposed based on the acoustic ray tracing theory.
View Article and Find Full Text PDFSpatio-Temporal Joint Trajectory Planning for Autonomous Vehicles Based on Improved Constrained Iterative LQR.
Sensors (Basel)
January 2025
National Engineering Laboratory for Electric Vehicles, Beijing Institute of Technology, Beijing 100081, China.
With advancements in autonomous driving technology, the coupling of spatial paths and temporal speeds in complex scenarios becomes increasingly significant. Traditional sequential decoupling methods for trajectory planning are no longer sufficient, emphasizing the need for spatio-temporal joint trajectory planning. The Constrained Iterative LQR (CILQR), based on the Iterative LQR (ILQR) method, shows obvious potential but faces challenges in computational efficiency and scenario adaptability.
View Article and Find Full Text PDFCompact High-Zoom-Ratio Mid-Wavelength Infrared Zoom Lens Design Based on Particle Swarm Optimization.
Sensors (Basel)
January 2025
Changchun Institute of Optics, Fine Mechanics and Physics, Chinese Academy of Sciences, Changchun 130033, China.
This paper presents an automated method for solving the initial structure of compact, high-zoom-ratio mid-wave infrared (MWIR) zoom lenses. Using differential analysis, the focal length variation process of zoom lenses under paraxial conditions is investigated, and a model for the focal power distribution and relative motion of three movable lens groups is established. The particle swarm optimization (PSO) algorithm is introduced into the zooming process analysis, and a program is developed in MATLAB to solve for the initial structure.
View Article and Find Full Text PDFThree-Dimensional Posture Analysis-Based Modifications After Manual Therapy: A Preliminary Study.
J Clin Med
January 2025
Department of Biomedical and Neuromotor Sciences (DIBINEM), Alma Mater University of Bologna, 40138 Bologna, Italy.
Manual therapies like Osteopathic Manipulative Treatment (OMT) and Gentle Touch Intervention (GTI) are widely employed for improving posture and spinal alignment, but their effects as measured using advanced technologies remain underexplored. This study aims to evaluate the short-term postural effects of these interventions using a non-invasive three-dimensional rasterstereography-based approach, focusing on the cervical arrow, lumbar arrow, kyphotic angle, and lordotic angle parameters. A three-armed randomized controlled trial was conducted with 165 healthy participants.
View Article and Find Full Text PDFPolarimetric Compressed Sensing with Hollow, Self-Assembled Diffractive Films.
ACS Nano
January 2025
Department of Mechanical Engineering, University of California at Riverside, Riverside, California 92521, United States.
Sensing light's polarization and wavefront direction enables surface curvature assessment, material identification, shadow differentiation, and improved image quality in turbid environments. Traditional polarization cameras utilize multiple sensor measurements per pixel and polarization-filtering optics, which result in reduced image resolution. We propose a nanophotonic pipeline that enables compressive sensing and reduces the sampling requirements with a low-refractive-index, self-assembled optical encoder.
View Article and Find Full Text PDFWant AI Summaries of new PubMed Abstracts delivered to your In-box?
Enter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!