Based on previous observations, the 1950-nm diode laser seems to be an ideal wavelength for laser microvascular anastomoses. The data presented here, part of a larger ongoing study, assess its use in emergency hand surgery. Between 2011 and 2014, 11 patients were operated on for hand trauma with laser-assisted microanastomoses (LAMA) and prospectively analysed. LAMA was performed with a 1950-nm diode laser after placement of equidistant stitches. For vessel size <1.5 mm, the following laser parameters were used: spot size 400 μm, five spots for each wall, power 125 mW, and arterial/venous fluence 100/90 J/cm(2) (spot duration 1/0.9 s). Mean operating time for arterial and venous microanastomoses was 7.3 ± 1.4 and 8.7 ± 1.0 min, respectively. Three anastomoses required a secondary laser application. Arterial and venous patency rates were 100 % at the time of surgery. The success rate for the 11 procedures assessed clinically and with the Doppler was 100 %. The technique is compared to the current literature. The 1950-nm LAMA is a reliable tool with excellent results in emergency hand surgery. The system is very compact and transportable for utilization in the emergency operating room.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1007/s10103-015-1711-z | DOI Listing |
In this Letter, we demonstrate mid-infrared (MIR) lateral -- GeSn waveguide photodetectors (WGPDs) on silicon, to the best of our knowledge for the first time, as a key enabler of MIR electronic-photonic integrated circuits (EPICs). Narrow-bandgap GeSn alloys were employed as the active material to enable efficient photodetection in the MIR region. A lateral -- homojunction diode was designed and fabricated to significantly enhance the optical confinement factor of the guided modes and thus enhance the optical responsivity.
View Article and Find Full Text PDFWe demonstrate a gain-switched fiber laser, yielding a maximum average power of 1.04 W at 3.46 μm, which is the current record of a pulsed rare-earth-doped fiber laser at the wavelength beyond 3 μm, to our knowledge.
View Article and Find Full Text PDFProc SPIE Int Soc Opt Eng
February 2018
University of California, San Francisco, San Francisco, CA 94143-0758.
Previous studies have shown that reflectance imaging at wavelengths greater than 1200-nm can be used to image demineralization on tooth occlusal surfaces with high contrast and without the interference of stains. In addition, these near-IR imaging systems can be integrated with laser ablation systems for the selective removal of carious lesions. Higher wavelengths, such as 1950-nm, yield higher lesion contrast due to higher water absorption and lower scattering.
View Article and Find Full Text PDFWe present a mode-locked holmium-doped all-fiber soliton laser operating in the 2052 nm wavelength range. The ultrashort pulse oscillator is simultaneously self-providing 1950-nm radiation for efficient in-band pumping in a subsequent thulium-/holmium-doped fiber tandem amplifier. More than 76 nJ-pulses for Ho:YLF or Ho:YVO amplifier seeding have been achieved.
View Article and Find Full Text PDFA multi-wavelength pumped thulium doped fiber amplifier is investigated to extend the spectral gain coverage of the amplifier in the 1.7-1.9μm wavelength range.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!