A study of the α- and β-dispersion of skin bioimpedance dependence on temperature and micro-hemodynamics is presented. The vascular tone changes during the cold test are verified by the wavelet-analysis of skin temperature signals obtained simultaneously with impedance measurements. Thirty three normal healthy subjects of 28 ± 7 years old were entered into the study. The tetra-polar electrode system was used to record the resistance and reactance; measurements were carried out at 67 frequencies, in a frequency range from 2 Hz to 50 kHz. It has been found that the impedance decreases with vasodilation and increases with vasoconstriction. The high values of correlation among thermal oscillation amplitudes and Nyquist diagram parameters prove the impedance dependence on blood flow in three frequency bands corresponding to the myogenic, neurogenic and endothelial vascular tone regulation mechanisms. Using an equivalent RC circuit, we obtained the changes in the Nyquist diagram matching the experimental data. The proposed descriptive α-dispersion model can be used to study mechanisms responsible for intercellular interaction.
Download full-text PDF |
Source |
---|---|
http://dx.doi.org/10.1088/0967-3334/36/3/561 | DOI Listing |
Biology (Basel)
September 2024
Postgraduate Program in Bioexperimentation (PPGBioexp), Institute of Heatlh, Universidade de Passo Fundo, Passo Fundo 99052-900, RS, Brazil.
Recent studies emphasize the significance of skin microclimate in the prevention of pressure injuries (PI). The objective was to evaluate the effect of pressure loading on skin temperature and moisture in the heels of healthy adults. This is a before-and-after study performed at Brazil, in October 2022.
View Article and Find Full Text PDFPhysiol Meas
October 2024
ARTERYA, F-14200 Hérouville-Saint-Clair, France.
The radial artery, one of the terminal branches of the forearm, is utilized for vascular access and in various non-invasive measurement method, providing crucial medical insights. Various sensor technologies have been developed, each suited to specific characterization requirements. The work presented in this paper is based on a systematic literature review of the main publications relating to this topic.
View Article and Find Full Text PDFJ Electr Bioimpedance
January 2024
Electrical Engineering Department, State University of Santa Catarina, Mexico, Brazil.
Bio-impedance Spectroscopy (BIS) is a technique that allows tissue analysis to diagnose a variety of diseases, such as medical imaging, cancer diagnosis, muscle fatigue detection, glucose measurement, and others under research. The development of CMOS integrated circuit front-ends for bioimpedance analysis is required by the increasing use of wearable devices in the healthcare field, as they offer key features for battery-powered wearable devices. These features include high miniaturization, low power consumption, and low voltage power supply.
View Article and Find Full Text PDFJ Electr Bioimpedance
January 2024
Department of Physics, University of Oslo, 0316 Oslo, Norway.
The purpose of this pilot study was to determine if body orientation, skin treatment, joint angle, and shoulder arch movements affect localized bioimpedance spectroscopy (BIS) measurement. Nowadays, there are various wearable and portable impedance measurement tools in different shapes and sizes. Therefore, the body position and orientation of the subject during measurement may be of great importance for the comparability of the results.
View Article and Find Full Text PDFSensors (Basel)
September 2024
Medtech Business Unit, Swiss Center for Electronics and Microtechnology (CSEM), Jaquet-Droz 1, 2002 Neuchâtel, Switzerland.
Bioimpedance imaging aims to generate a 3D map of the resistivity and permittivity of biological tissue from multiple impedance channels measured with electrodes applied to the skin. When the electrodes are distributed around the body (for example, by delineating a cross section of the chest or a limb), bioimpedance imaging is called electrical impedance tomography (EIT) and results in functional 2D images. Conventional EIT systems rely on individually cabling each electrode to master electronics in a star configuration.
View Article and Find Full Text PDFEnter search terms and have AI summaries delivered each week - change queries or unsubscribe any time!